Page 33 of 356

1
31
INSTRUMENTS and CONTROLS
   
 
  
 
 
Service 
 
    
temporarily, 
accompanied 
by a message.    Minor faults have occurred 
for which there is no 
specifi c warning lamp.   Identify the fault by reading the message 
displayed in the screen: 
   
 
-   doors, boot or bonnet open, 
   
-   low engine oil level, 
   
-   low screenwash/headlamp wash reservoir 
level, 
   
-   remote control battery fl at, 
   
-   low tyre pressures, 
   
-   saturation of the particle emission fi lter on 
Diesel vehicles (see Checks - checking 
levels/particle emissions fi lter).  
  For any other faults, contact a PEUGEOT dealer 
or a qualifi ed workshop. 
   
fi xed, 
accompanied 
by a message 
and an audible 
signal.    Major faults have occurred 
for which there is no 
specifi c warning lamp.   Identify the fault by reading the message shown 
in the screen and  you must then contact 
 a 
PEUGEOT dealer or a qualifi ed workshop.     
 
Warning lamp 
 
   
 
is on 
 
   
 
Cause 
 
   
 
Action/Observations 
 
 
      
 
Engine 
autodiagnosis 
system 
 
    
fl ashing.    The engine management 
system has a fault.   Risk of destruction of the catalytic converter. 
  Have it checked by a PEUGEOT dealer or a 
qualifi ed workshop. 
 
  fi xed.    The emission control 
system has a fault.   The warning lamp should go off when the engine 
is started. 
  If it does not go off, contact a PEUGEOT dealer 
or qualifi ed workshop without delay.  
     
        
        Page 35 of 356

1
!
33
INSTRUMENTS and CONTROLS
   
 
 
 
 
 
The other warning lamps appear only in this instrument panel. 
  The illumination of certain warning lamps may be accompanied by an audible signal; 
an additional message is still displayed in the multifunction screen, to help you identify 
the fault. 
   
 
Warning lamp 
 
   
 
is on 
 
   
 
Cause 
 
   
 
Action/Observations 
 
 
   
 
  
 
 
Door(s) open 
 
    
fi xed if the 
speed is 
below 6 mph 
(10 km/h).  
  A door or the boot is still 
open.   Close the door or boot.     
fi xed and 
accompanied 
by an audible 
signal if the 
speed is 
above 6 mph 
(10 km/h).  
   
 
    
 
Engine oil 
pressure 
 
    
fi xed.    There is a fault with the 
engine lubrication system.   You must stop as soon it is safe to do so. 
  Park, switch off the ignition and contact a 
PEUGEOT dealer or a qualifi ed workshop. 
   
 
    
 
Battery 
charge 
 
*  
    
fi xed.    The battery charging circuit 
has a fault (dirty or loose 
terminals, slack or cut 
alternator belt, ...).   The warning lamp should go off when the engine 
is started. 
  If it does not go off, contact a PEUGEOT dealer 
or a qualifi ed workshop.    If they are associated with the  STOP 
 warning lamp, you must stop the vehicle 
as soon as it is safe to do so! 
   
*  
 According to destination country.   
     
        
        Page 174 of 356

10
!
i
172
CHECKS
   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
CHECKING LEVELS 
 
Check all of these levels regularly and 
top them up if necessary, unless other-
wise indicated. 
  If a level drops signifi cantly, have the 
corresponding system checked by a 
PEUGEOT dealer or a qualifi ed  work-
shop. 
   
Brake fluid level 
 
 
On vehicles which are fi tted  with  a 
particle emission fi lter, the fan may 
operate after the vehicle has been 
switched off, even if the engine is 
cold. 
 
  In addition, as the cooling system is 
pressurised, wait at least one hour after 
switching off the engine before carrying 
out any work. 
  To avoid any risk of scalding, unscrew the 
cap by two turns to allow the pressure to 
drop. When the pressure has dropped, 
remove the cap and top up the level. 
   
Oil level 
 
The check is carried out either 
when the ignition is switched on 
using the oil level indicator on 
the instrument panel, or using 
the dipstick. 
  This manual check will only be correct 
if the vehicle is on level ground and 
the engine has been off for more than 
30 minutes. 
  After topping up the oil, the check when 
switching on the ignition with the oil level 
indicator in the instrument panel will only 
be valid 30 minutes after topping up.   The brake fl uid level should be 
close to the "MAX" mark. If it is 
not, check the brake pad wear. 
   
Changing the fl uid 
  Refer to the Warranty and Maintenance 
Record for details of the interval for this 
operation.  
 
 
Power steering fluid level 
 
The power steering fl uid  level 
should be close to the "MAX" 
mark. Unscrew the cap, with the 
engine cold, to check the level.      
Engine oil change 
  Refer to the Warranty and Maintenance 
Record for details of the interval for this 
operation. 
  In order to maintain the reliability of the 
engine and emission control system, 
the use of additives in the engine oil is 
prohibited.  
   
It is normal to top up the oil level 
between services. PEUGEOT 
recommends that you check the oil 
level and top up if necessary every 
3 000 miles (5 000 kilometres).     
Fluid specifi cation 
  The brake fl uid must conform to the 
manufacturer's recommendations and 
meet the DOT4 standard.  
    
Changing the coolant 
  The coolant does not have to be 
changed.  
 
 
Coolant level 
 
The coolant level should be 
close to the "MAX" mark but 
should never exceed it. 
  When the engine is warm, the tempera-
ture of the coolant is regulated by the fan. 
This can operate with the ignition off. 
   
Fluid specifi cation 
  The coolant must conform to the manu-
facturer's recommendations.  
     
When working under the bonnet, 
take care, as certain areas of the 
engine may be extremely hot (risk 
of burns).     
Oil specifi cation 
  The oil must be the correct grade for 
your engine and conform to the manu-
facturer's recommendations.  
  
     
        
        Page 204 of 356
11
202
PRACTICAL INFORMATION
   
 
Fuse N° 
 
   
 
Rating 
 
   
 
Functions 
 
 
   
 
F12 
 
   
 
30 A 
 
  Windscreen wipers slow/fast speed. 
   
 
F13 
 
   
 
40 A 
 
  Built-in systems interface supply (ignition positive). 
   
 
F14 
 
   
 
30 A 
 
  Air pump. 
   
 
F15 
 
   
 
10 A 
 
  Right-hand main beam headlamp. 
   
 
F16 
 
   
 
10 A 
 
  Left-hand main beam headlamp. 
   
 
F17 
 
   
 
15 A 
 
  Left-hand dipped headlamp. 
   
 
F18 
 
   
 
15 A 
 
  Right-hand dipped headlamp. 
   
 
F19 
 
   
 
15 A 
 
   Oil vapour heater (1.4 litre and 1.6 litre VTi), purge 
canister electrovalve (1.4 litre and 1.6 litre VTi), 
oxygen sensors (petrol), air cooling electrovalves 
(Diesel). 
   
 
F20 
 
   
 
10 A 
 
   Electronic thermostat, variable timing electrovalves, 
air fl ow sensor (1.6 litre THP 200), turbo pressure 
regulation electrovalve (Diesel), engine coolant 
level detector (Diesel). 
   
 
F21 
 
   
 
5 A 
 
   Cooling fan relay supply, Valvetronic relay control 
(1.4 litre 16V and 1.6 litre VTi), Turbo cooling 
(1.6 litre THP), Valvetronic engine (1.6 litre THP 
200), air fl ow sensor (1.6 litre HDI).