4
FAMILIARISATION
  EXTERIOR  
 
 
Stop & Start system 
  This system puts the engine temporarily 
into standby during stops in the traffi c  (red 
lights, traffi c jams, etc...). The engine restarts 
automatically as soon as you want to move 
off. The Stop & Start system reduces fuel 
consumption, exhaust emissions and the 
noise level when stationary. 
   
 
  
 158  
 
   
Directional lighting 
  This lighting automatically provides 
additional visibility when cornering. 
   
 
  
 103  
    
Panoramic sunroof 
  This roof provides incomparable 
visibility and light in the passenger 
compartment. 
   
 
  
 95  
 
   
Temporary puncture repair kit 
  This kit is a complete system, con-
sisting of a compressor and a sealant 
cartridge, for the temporary repair of 
a tyre. 
   
 
  
 176  
 
  
1
37
INSTRUMENTS and CONTROLS
    
 
 
Stop & Start 
 
    
fi xed.    When the vehicle stops (red 
lights, traffi c jams, ...) the 
Stop & Start system has 
put the engine into STOP 
mode.   The warning lamp goes off and the engine 
restarts automatically in START mode, as soon 
as you want to move off. 
   
fl ashes for a 
few seconds, 
then goes off.    STOP mode is temporarily 
unavailable. 
  or 
  START mode is invoked 
automatically.   Refer to "Driving - § Stop & Start" for special 
cases with STOP mode and START mode.     
 
Warning lamp 
 
   
 
is on 
 
   
 
Cause 
 
   
 
Action/Observations 
 
 
   
 
    
Passenger's 
front airbag 
   fi xed on the 
seat belt and 
passenger's 
front airbag 
warning lamps 
display.   The control switch, located 
on the passenger's side of 
the dashboard, has been 
placed in the  "ON" 
 position.  
The passenger's front 
airbag is activated.  
In this case, do not install 
a "rear facing" child seat.   While you do not have a rear-facing child 
seat fi tted to the front passenger seat, it is 
recommended that the passenger's front airbag 
be activated. 
  On the other hand, before fi tting a rear-facing 
child seat, you must turn the control switch to the 
  "OFF" 
 position.  
9
!
i
158
DRIVING
   
 
 
 
 
 
 
 
 
 
 
STOP & START 
 
The Stop & Start  system puts the engine 
temporarily on standby - STOP mode - 
during stops in the traffi c (red lights, 
traffi c jams, or other...). The engine re-
starts automatically - START mode - as 
soon as you want to move off. The re-
start takes place instantly, quickly and 
silently. 
  Perfect for urban use, the Stop & Start 
system reduces fuel consumption and 
exhaust emissions as well as the noise 
level when stationary. 
   
Operation 
 
 
Going into engine STOP mode 
  The  "ECO" 
 warning lamp comes 
on in the instrument panel and the 
engine goes into standby: 
   
 
-   with a manual gearbox 
, at speeds 
below 12 mph (20 km/h), when you 
put the gear lever into neutral and 
release the clutch pedal, 
   
-   with the 6-speed electronic gear 
control gearbox 
, at a speed below 
5 mph (8 km/h), when you press the 
brake pedal or put the gear lever 
into position  N 
.    If your vehicle is fi tted  with 
the system, a time counter 
calculates the sum of the 
periods in STOP mode dur-
ing a journey. It rests itself to 
zero every time the ignition 
is switched on with the key. 
  With the automatic gearbox sys-
tem, for your comfort during park-
ing manoeuvres, STOP mode is 
not available for a few seconds af-
ter coming out of reverse gear. 
  STOP mode does not affect the 
functionality of the vehicle, such 
as braking, power steering, for
example. 
  Never refuel with the engine in 
STOP mode; you must switch off 
the ignition with the key.     
Special cases: STOP mode 
unavailable 
  STOP mode is not invoked when: 
   
 
-   the driver's door is open, 
   
-   the driver's seat belt is not fastened, 
   
-   the vehicle has not exceeded 6 mph 
(10 km/h) since the last engine start 
using the key, 
   
-   the engine is needed to maintain 
a comfortable temperature in the 
passenger compartment, 
   
-   demisting is on, 
   
-   some special conditions (battery 
charge, engine temperature, braking 
assistance, ambient temperature...) 
where the engine is needed to 
assure control of a system.  
  In this case, the  "ECO" 
 warning 
lamp fl ashes for a few seconds, 
then goes off. 
   
This operation is perfectly normal.