
   
Limit the causes of excess 
consumption 
   
Spread loads throughout the vehicle; 
place the heaviest items in the bottom 
of the boot, as close as possible to the 
rear seats. 
  Limit the loads carried in the vehicle 
and reduce wind resistance (roof bars, 
roof rack, bicycle carrier, trailer...). Use 
a roof box in preference. 
  Remove roof bars and roof racks after 
use.  
   
At the end of winter, remove snow 
tyres and refi t your summer tyres.  
 
 
 
Observe the recommendations 
on maintenance 
   
Check the tyre pressures regularly, 
when cold, referring to the label in the 
door aperture, driver's side. 
  Carry out this check in particular: 
   
 
-   before a long journey, 
   
-   at each change of season, 
   
-   after a long period out of use.  
  Don't forget the spare wheel and the 
tyres on any trailer or caravan.  
   
Have your vehicle serviced regularly 
(engine oil, oil fi lter,  air fi lter...)  and 
observe the schedule of operations 
recommended by the manufacturer.  
 
    
When refuelling, do not continue after 
the 3 rd  cut-off of the nozzle to avoid 
any overfl ow.  
   
At the wheel of your new vehicle, 
it is only after the fi rst  1 800 miles 
(3 000 kilometres) that you will see 
the fuel consumption settle down to a 
consistent average.  
 
24 

1
i
26
INSTRUMENTS and CONTROLS
   
 
 
 
 
 
 
 
 
 
 
 
PETROL - DIESEL MANUAL OR 6-SPEED ELECTRONIC GEAR 
CONTROL OR AUTOMATIC GEARBOX INSTRUMENT PANELS 
  Panel grouping together the vehicle 
operation indication dials and warning 
lamps.    
5. 
  Small screen. 
 
   
6. 
  Central screen. 
 
   
7. 
  Control button. 
 
 
  Starts a manual CHECK and 
recalls the service information.  
  Resets the function to zero 
(trip distance recorder or service 
indicator). 
   
8. 
  Instrument panel lighting button. 
 
 
  Adjusts the brightness of the 
lighting of the instruments and 
controls.  
 
 
Dials 
 
 
 
1. 
  Rev counter. 
 
 
  Indicates the speed of rotation of 
the engine (x 1 000 rpm). 
   
2. 
  Coolant temperature. 
 
 
  Indicates the temperature of the 
engine coolant (° Celsius). 
   
3. 
  Fuel level. 
 
 
  Indicates the quantity of fuel 
remaining in the tank. 
   
4. 
  Vehicle speed. 
 
 
  Indicates the current speed of the 
moving vehicle (mph or km/h).    
 
A. 
  Trip distance recorder. 
 
 
  (miles or km) 
   
B. 
  Distance recorder. 
 
 
  (miles or km) 
   
C. 
  Engine oil level indicator, 
 
 
   service indicator. 
 
 
  (miles or km)  
  These two functions are displayed 
when the ignition is switched on, 
then disappear after a few seconds.      
Displays 
  For more information, refer to the 
paragraph which relates to the but-
ton or function and its associated 
display.   The following functions are displayed 
depending on the selection. 
   
 
-   Warning lamps/CHECK. 
 
   
-   Tyre under-infl ation detection. 
 
   
-   Speed limiter/Cruise control. 
 
   
-   Gear 
  shift 
  indicator. 
 
   
-   6-speed electronic gear control 
or automatic gearbox. 
 
   
-   Navigation - Guidance/Trip 
computer. 
 
 
 
  

1
i
27
INSTRUMENTS and CONTROLS
   
 
 
 
 
 
 
 
 
 
 
 
PETROL - DIESEL MANUAL OR 6-SPEED ELECTRONIC GEAR CONTROL OR 
AUTOMATIC GEARBOX PEUGEOT CONNECT MEDIA INSTRUMENT PANELS
   
Dials 
 
 
 
1. 
  Rev counter. 
 
 
  Indicates the speed of rotation of 
the engine (x 1 000 rpm). 
   
2. 
  Coolant temperature. 
 
 
  Indicates the temperature of the 
engine coolant (°Celsius). 
   
3. 
  Fuel level. 
 
 
  Indicates the quantity of fuel 
remaining in the tank. 
   
4. 
  Vehicle speed. 
 
 
  Indicates the current speed of the 
moving vehicle (km/h or mph).    
 
A. 
  Trip distance recorder. 
 
 
  (miles or km) 
   
B. 
  Distance recorder. 
 
 
  (miles or km). 
   
C. 
  Engine oil level indicator, 
 
 
  service indicator. 
 
 
  (miles or km)  
  These two functions are displayed 
when the ignition is switched on, 
then disappear after a few seconds.  
  The following functions are displayed 
depending on the selection. 
   
 
-   Warning lamps/CHECK. 
 
   
-   Tyre under-infl ation detection. 
 
   
-   Speed limiter/Cruise control. 
 
   
-   Gear shift indicator. 
 
   
-   6-speed electronic gear control 
or automatic gearbox. 
 
   
-   Navigation - Guidance/Trip 
computer. 
 
   
-   Vehicle parameters. 
 
 
 
 
  
Panel grouping together the vehicle 
operation indication dials and warning 
lamps.    
Displays 
   
5. 
  Small screen. 
 
   
6. 
  Central screen. 
 
   
7. 
  Control button. 
 
 
  Starts a manual CHECK and 
recalls the service information.  
  Resets the function to zero (trip 
distance recorder or service indicator). 
   
8. 
  Instrument panel lighting button. 
 
 
  Adjusts the brightness of the 
lighting of the instruments and 
controls.  
  For more information, refer to the 
paragraph which relates to the but-
ton or function and its associated 
display.  

1
31
INSTRUMENTS and CONTROLS
   
 
  
 
 
Service 
 
    
temporarily, 
accompanied 
by a message.    Minor faults have occurred 
for which there is no 
specifi c warning lamp.   Identify the fault by reading the message 
displayed in the screen: 
   
 
-   doors, boot or bonnet open, 
   
-   low engine oil level, 
   
-   low screenwash/headlamp wash reservoir 
level, 
   
-   remote control battery fl at, 
   
-   low tyre pressures, 
   
-   saturation of the particle emission fi lter on 
Diesel vehicles (see Checks - checking 
levels/particle emissions fi lter).  
  For any other faults, contact a PEUGEOT dealer 
or a qualifi ed workshop. 
   
fi xed, 
accompanied 
by a message 
and an audible 
signal.    Major faults have occurred 
for which there is no 
specifi c warning lamp.   Identify the fault by reading the message shown 
in the screen and  you must then contact 
 a 
PEUGEOT dealer or a qualifi ed workshop.     
 
Warning lamp 
 
   
 
is on 
 
   
 
Cause 
 
   
 
Action/Observations 
 
 
      
 
Engine 
autodiagnosis 
system 
 
    
fl ashing.    The engine management 
system has a fault.   Risk of destruction of the catalytic converter. 
  Have it checked by a PEUGEOT dealer or a 
qualifi ed workshop. 
 
  fi xed.    The emission control 
system has a fault.   The warning lamp should go off when the engine 
is started. 
  If it does not go off, contact a PEUGEOT dealer 
or qualifi ed workshop without delay.  

1
i
40
INSTRUMENTS and CONTROLS
  The level shown will only be correct 
if the vehicle is on level ground and 
the engine has been off for more 
than 30 minutes. 
   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Engine oil level indicator 
 
System which informs the driver whether 
the engine oil level is correct or not. 
  This information is indicated for a few 
seconds when the ignition is switched 
on, after the service information. 
   
Oil level correct  
   
Oil level low    
Oil level indicator fault 
   
Dipstick 
  This is indicated by the fl ashing of  "OIL" 
, 
linked with the service warning lamp, ac-
companied by an audible signal and a 
message in the multifunction screen. 
  If the low oil level is confi rmed by a 
check using the dipstick, the level must 
be topped up to prevent damage to the 
engine.    This is indicated by the fl ashing of  "OIL --" 
. 
Contact a PEUGEOT dealer or a qualifi ed 
workshop.  
  Refer to the "Checks" section to locate 
the dipstick and the oil fi ller cap on your 
engine. 
  There are 2 marks on the 
dipstick: 
   
 
-   A 
 = max; never exceed 
this level (risk of 
damage to the engine), 
   
-   B 
 = min; top up the level 
via the oil fi ller cap, 
using the grade of oil 
suited to your engine.  
 
  

4
i
i
97
ACCESS
   
 
 
 
 
 
 
 
 
 
Quality of the fuel used
for petrol engines 
   
The petrol engines are perfectly com-
patible with E10 type petrol biofuels 
(containing 10 % ethanol), conforming 
to European standards EN 228 and 
EN 15376. 
  E85 type fuels (containing up to 85 % 
ethanol) are reserved exclusively for ve-
hicles marketed for the use of this type 
of fuel (BioFlex vehicles). The quality of 
the ethanol must comply with European 
standard EN 15293. 
  For Brazil only, special vehicles are 
marketed to run on fuels containing up 
to 100 % ethanol (E100 type).  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Quality of the fuel used
for Diesel engines 
   
The Diesel engines are perfectly com-
patible with biofuels which conform to 
current and future European standards 
(Diesel fuel which complies with stan-
dard EN 590 mixed with a biofuel which 
complies with standard EN 14214) 
available at the pumps (containing up 
to 7 % Fatty Acid Methyl Ester). 
  The B30 biofuel can be used in cer-
tain Diesel engines; however, this use 
is subject to strict application of the 
special servicing conditions. Contact a 
PEUGEOT dealer or a qualifi ed  work-
shop.   The use of any other type of (bio)fuel 
(vegetable or animal oils, pure or dilut-
ed, domestic fuel...) is strictly prohibited 
(risk of damage to the engine and fuel 
system).  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
MISFUEL PREVENTION *  
 
Mechanical device which prevents fi ll-
ing the tank of a Diesel vehicle with 
petrol. It avoids the risk of engine dam-
age that can result from fi lling with the 
wrong fuel. 
  Located in the fi ller neck, the misfuel 
prevention device appears when the 
fi ller cap is removed. 
 
 
Operation 
 
When a petrol fi ller nozzle is introduced into 
the fuel fi ller neck of your Diesel vehicle, it 
comes into contact with the fl ap. The system 
remains closed and prevents fi lling. 
 
 
Do not persist but introduce a Diesel 
type fi ller nozzle. 
 
   It is still possible to use a fuel can 
to fi ll the reservoir.  
In order to ensure a good fl ow of fuel, 
do not place the nozzle of the fuel can 
in direct contact with the fl ap of the 
misfuel prevention device. 
   
 
Travelling abroad 
  As Diesel fuel pump nozzles may 
be different in other countries, the 
presence of the misfuel prevention 
device may make refuelling impos-
sible. 
  Before travelling abroad, we rec-
ommend that you check with the
PEUGEOT dealer network, whether 
your vehicle is suitable for the fuel 
pumps in the country in which you 
want to travel.  
 
   
*   According to destination country.   

10
170
CHECKS
   
 
 
 
 
 
 
 
 
 
 
 
 
 
PETROL ENGINES 
 
The various caps and covers allow access for checking the levels of the various fl uids and for replacing certain components. 
   
 
1. 
  Power steering reservoir. 
   
2. 
  Screenwash and headlamp wash 
reservoir. 
   
3. 
 Coolant reservoir.    
4. 
 Brake fl uid reservoir. 
   
5. 
 Battery/Fuses. 
   
6. 
 Fusebox.    
7. 
 Air fi lter. 
   
8. 
  Engine oil dipstick. 
   
9. 
 Engine oil fi ller cap.   

10
171
CHECKS
   
 
 
 
 
 
 
 
 
 
 
 
 
DIESEL ENGINES 
 
The various caps and covers allow access for checking the levels of the various fl uids, for replacing certain components and 
for priming the fuel system. 
   
 
1. 
  Power steering reservoir. 
   
2. 
  Screenwash and headlamp wash 
reservoir. 
   
3. 
 Coolant reservoir.    
4. 
 Brake fl uid reservoir. 
   
5. 
 Battery/Fuses. 
   
6. 
 Fusebox. 
   
7. 
 Air fi lter.    
8. 
  Engine oil dipstick. 
   
9. 
 Engine oil fi ller cap. 
   
10. 
 Priming  pump * . 
   
11 . 
 Bleed  screw * .  
   
*   According to engine.