2011 Peugeot 308 SW BL gearbox

1
i
27
INSTRUMENTS and CONTROLS












PETROL - DIESEL MANUAL OR 6-SPEED ELECTRONIC GEAR CONTROL OR
AUTOMATIC GEARBOX PEUGEOT CONNECT MEDIA INSTRUMENT PANELS

Dials



1.
Rev counter.


Indicates the speed of rotation of
the engine (x 1 000 rpm).

2.
Coolant temperature.


Indicates the temperature of the
engine coolant (°Celsius).

3.
Fuel level.


Indicates the quantity of fuel
remaining in the tank.

4.
Vehicle speed.


Indicates the current speed of the
moving vehicle (km/h or mph).

A.
Trip distance recorder.


(miles or km)

B.
Distance recorder.


(miles or km).

C.
Engine oil level indicator,


service indicator.


(miles or km)
These two functions are displayed
when the ignition is switched on,
then disappear after a few seconds.
The following functions are displayed
depending on the selection.


- Warning lamps/CHECK.


- Tyre under-infl ation detection.


- Speed limiter/Cruise control.


- Gear shift indicator.


- 6-speed electronic gear control
or automatic gearbox.


- Navigation - Guidance/Trip
computer.


- Vehicle parameters.





Panel grouping together the vehicle
operation indication dials and warning
lamps.
Displays

5.
Small screen.


6.
Central screen.


7.
Control button.


Starts a manual CHECK and
recalls the service information.
Resets the function to zero (trip
distance recorder or service indicator).

8.
Instrument panel lighting button.


Adjusts the brightness of the
lighting of the instruments and
controls.
For more information, refer to the
paragraph which relates to the but-
ton or function and its associated
display.

1
32
INSTRUMENTS and CONTROLS





Low fuel level


fi xed with the
needle in the
red zone,
accompanied
by an audible
signal and a
message. When it fi rst comes on there
remains approximately
6 litres
of fuel in the tank.
At this point, you begin to
use the fuel reserve. Refuel as soon as possible to avoid running out
of fuel.
Until suffi cient fuel has been added, this warning
lamp will come on every time the ignition is
switched on, accompanied by an audible signal
and a message.
This audible signal and message are repeated
with increasing frequency as the fuel level drops
towards "0"
.
Fuel tank capacity: approximately 60 litres
.
Never continue to drive until you run out of fuel,
as this could damage the emission control and
injection systems.

Warning lamp



is on



Cause



Action/Observations






Anti-lock
Braking
System
(ABS)


fi xed. The anti-lock braking
system has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact
a PEUGEOT dealer or a qualifi ed workshop
without delay.




Dynamic
stability
control
(ESP/ASR)


fl ashing. The ESP/ASR regulation is
active. The system optimises traction and improves the
directional stability of the vehicle.

fi xed. Unless it has been
deactivated (button pressed
and its indicator lamp on) the
ESP/ASR system has a fault. Have it checked by a PEUGEOT or a qualifi ed
workshop.




Directional
headlamps


fl ashing. The directional headlamps
system has a fault. Have it checked by a PEUGEOT dealer or a
qualifi ed workshop.


Foot on the
brake pedal


fi xed. You have forgotten to press
the brake pedal when
starting the engine, with
an electronic gear control
gearbox. You have to press the brake pedal to start the
engine (gear lever in position N
).

9
!
i
!
148
DRIVING
When parking on a slope, direct
your wheels against the pavement,
apply the parking brake and engage
a gear.






PARKING BRAKE


Applying


)
Pull the parking brake lever fully up
to immobilise your vehicle.

When the vehicle is being driven,
if this warning lamp and the STOP

warning lamp come on, accom-
panied by an audible signal and a
message on the multifunction screen, this
indicates that the parking brake is still on
or has not been properly released.
Releasing


)
Pull the parking brake lever gently,
press the release button then lower
the lever fully.









6-SPEED MANUAL GEARBOX


Engaging 5 th or 6 th gear



)
Move the lever fully to the right to
engage 5 th or 6 th gear.



Engaging reverse gear



)
Raise the ring under the knob and
move the gear lever to the left then
forwards.
Only engage reverse gear when
the vehicle is stationary with the
engine at idle.
As a safety precaution and to facili-
tate starting of the engine:


- always select neutral,

- press the clutch pedal.

9
i
149
DRIVING











GEAR SHIFT INDICATOR *

System which reduces fuel consumption
by advising the driver to change up on
vehicles fi tted with a manual gearbox.


Operation

The system intervenes only when driving
economically.
Depending on the driving situation and
your vehicle's equipment, the system
may advise you to skip one or more
gears. You can follow this instruc-
tion without engaging the intermediate
gears.
The gear engagement recommenda-
tions must not be considered compulso-
ry. In fact, the confi guration of the road,
the amount of traffi c and safety remain
determining factors when choosing the
best gear. Therefore, the driver remains
responsible for deciding whether or not to
follow the advice given by the system.
This function cannot be deactivated.

* According to engine.
Example:


- You are in third gear.

- You press the accelerator pedal
moderately.

- The system may suggest that you
engage a higher gear, if appropriate.
The information appears in the instru-
ment panel screen in the form of an
arrow accompanied by the suggested
gear.

In the case of driving which makes
particular demands on the perfor-
mance of the engine (fi rm pres-
sure on the accelerator pedal, for
example, when overtaking...), the
system will not recommend a gear
change.
The system never suggests:


- engaging fi rst gear,

- engaging reverse gear,

- engaging a lower gear.

9
i
151
DRIVING

















6-SPEED ELECTRONIC GEAR
CONTROL GEARBOX
Gear lever


R.
Reverse.


)
With your foot on the brake, move
the lever upwards to select this
position.

N.
Neutral.


)
With your foot on the brake, select
this position to start.

A.
Automated mode.


)
Move the lever downwards to select
this mode.

M +/-.
Sequential mode with manual
changing of the gears.


)
Move the lever downwards then to
the left to select this mode, then:


- push the lever forwards to change
up a gear,

- or pull the lever rearwards to
change down a gear.


S.
Sport function.


)
Press this button to activate or
deactivate this function.



Steering mounted control paddles


+.
Change up control paddle to the
right of the steering wheel.


)
Press the back of the "+"
steering
wheel control paddle to change up a
gear.

-.
Change down control paddle to the
left of the steering wheel.


)
Press the back of the "-"
steering
wheel control paddle to change down
a gear.
The steering wheel control paddles
do not permit the selection of neutral
or engaging or disengaging reverse
gear. Six-speed electronic gear control gear-
box which offers a choice between the
comfort of automated operation or the
pleasure of manual gear changing.
Two driving modes are offered:


- automated
mode for automatic
control of the gears by the gearbox,
without any action on the part of the
driver,

- manual
mode for sequential
changing of the gears by the driver
using the gear lever or steering
mounted control paddles.
With each of these two modes, a Sport

function is available for a more dynamic
style of driving.
With the automated mode, you can tem-
porarily take control of gear changing at
any time.
This gearbox provides you with additional
functions:


- hill start assist,

- creep * (movement of the vehicle
on releasing the brake pedal) in
automated mode or reverse.

*
Model fi tted with the 1.6 litre e-HDi
PEF 112 hp Diesel engine.

9
i!
i
152
DRIVING

Displays in the instrument panel


Gear lever positions


Moving off


N.
Neutral.

R.
Reverse.

1 2 3 4 5 6.
Gears in sequential mode.

AUTO.
This comes on when the au-
tomated mode is selected. It
switches off on changing to
manual mode.

S.
Sport (Sport function).

)
Select position N
.

)
Press the brake pedal down fully.

)
Start the engine.


)
Select automated mode (position A
),
manual mode (position M
) or reverse
(position R
).

)
Release the parking brake.

)

Progressively release the brake pedal.
Vehicles with the 1.6 litre e-HDi PEF
112 hp Diesel engine then start to move.

)
Accelerate away.

AUTO
and 1
, 1
or R
appear in the in-
strument panel screen.


N
fl ashes in the instrument panel,
accompanied by an audible signal
and a message in the screen, if the
gear lever is not in position N
on
starting.

Automated mode



)
Select position A
.
Never select neutral N
while the
vehicle is moving. The gearbox operates in auto-active
mode, without any action on the part
of the driver. It continuously selects the
most suitable gear for:


- optimum fuel consumption,

- the style of driving,

- the profi le of the road,

- the vehicle load.
For optimum acceleration, for example
when overtaking another vehicle, press
the accelerator pedal fi rmly past the
point of resistance.
N
appears in the instrument
panel screen.
An audible signal is heard when
reverse gear is engaged.

AUTO
and the gear engaged
appear in the instrument panel
screen.

The Foot on the brake pedal

warning lamp comes on, ac-
companied by an audible
signal and a message, if the
brake pedal is not pressed on starting
the engine.

9
!
i
153
DRIVING

Temporary manual control of gear
changing
You can temporarily take over control
of gear changing using the steering
mounted "+" and "-" control paddles: if
the engine speed allows, the request to
change gear is accepted.

AUTO
and the gear engaged
is displayed in the instrument
panel. When braking or slowing down, the
gearbox changes down automatically
so that the vehicle picks up in the cor-
rect gear.
On sharp acceleration, the gearbox will
not change up unless the driver acts on
the gear lever or the steering mounted
control paddles.
The gears engaged appear in
succession in the instrument
panel screen.

Manual mode



)
Select position M
.


Sport function



)
Following selection of the manual
mode or automated mode, press
button S
to activate the Sport function
which offers you a more dynamic
style of driving. Never select neutral N
when the
vehicle is moving.
It is possible to change mode at
any time, by moving the gear lever
from A
to M
or from M
to A
.
This function allows you to anticipate
certain situations such as overtaking
another vehicle or approaching a bend.
After a few moments without any ac-
tion on the control paddles, the gearbox
starts managing gear changes auto-
matically again.


S
appears next to the gear en-
gaged in the instrument panel
screen.


)
Press button S
again to deactivate
the function.

S
is then cleared from the instrument
panel screen.

Reverse

To engage reverse, the vehicle must be
stationary, with your foot on the brake
pedal.


)
Select position R
.
At very low speed, if reverse gear is re-
quested, this will only be taken into ac-
count when the vehicle is immobilised.
The Foot on the brake pedal
warning
lamp comes on in the instrument panel
to encourage you to brake.
At high speed, if reverse gear is re-
quested, the N
indicator lamp will fl ash
and the gearbox will change to neutral
automatically. To engage a gear again,
return the lever to position A
or M
.
The gear change requests are only car-
ried out if the engine speed permits.
It is not necessary to release the accel-
erator during gear changes.

Hill start assist

This function allows temporary immo-
bilisation of your vehicle.
It maintains the pressure of the brakes
briefl y, long enough for you to move
your foot from the brake pedal to the
accelerator pedal.
It comes into operation if the vehicle is
immobilised by pressing the brake ped-
al and depending on the gradient:


- on an ascending gradient, with
the vehicle stationary, gear lever
in position A
or M
, the vehicle is
held briefl y when the brake pedal is
released,

- on a descending gradient, with the
vehicle stationary, gear lever in
position R
, the vehicle is held briefl y
when the brake pedal is released.

The Sport function is deactivated
each time the ignition is switched off.

9
PRND
!
!
!
!
154
DRIVING

Creep function *

This function makes manoeuvering
the vehicle much easier at low speeds
(when parking, in traffi c jams…).
After fi rst placing the gear lever in posi-
tion A
, M
or R
, the vehicle starts moving
as soon as you take your foot off the
brake pedal.
When the engine is idling, brakes
released, if position A
, M
or R
is
selected, the vehicle moves even if
you do not press the accelerator.
Never leave unsupervised children in
the vehicle with the engine running. Do not hold the vehicle using the
accelerator: use the foot brake or
the parking brake.
Never leave the vehicle during a
hill start assist phase.
*

Model fi tted with the 1.6 litre e-HDi
PEF 112 hp Diesel engine.


Stopping the vehicle

Before switching off the engine, you can:


- move to position N
to select neutral,
or

- leave the gear engaged; in this case
the vehicle cannot be moved.
In both cases, it is essential that you ap-
ply the parking brake to immobilise the
vehicle.

Operating fault

When immobilising the vehicle,
with the engine running, you must
place the gear lever in neutral N
.
Before carrying out any work in the
engine compartment, check that
the gear lever is in neutral N
and
that the parking brake is applied. With the ignition on, if this warn-
ing lamp comes on and AUTO

fl ashes, accompanied by an
audible signal and a message
in the screen, this indicates a malfunc-
tion of the gearbox.
Have it checked by a PEUGEOT dealer
or a qualifi ed workshop.
This warning lamp may also come on if
a door is opened.
With the ignition on, if the warn-
ing lamp above and this warning
lamp come on, accompanied by
an audible signal and a mes-
sage in the screen, this indicates a mal-
function of the hill start assist system.
Have it checked by a PEUGEOT dealer
or a qualifi ed workshop.
It is essential to press the brake
pedal when starting the engine.
When parking, is it essential to ap-
ply the parking brake to immobilise
the vehicle, whatever the circum-
stances.