2011 MITSUBISHI OUTLANDER battery

10Names and functions of parts
Names and functions of parts
Replacing the battery
Use your fi ngernail to press tab A on
the battery case at the backside of the
remote control. While pressing tab A in the
direction shown in (1), pull the battery case
out as shown in (2)
NOTE
● When disposing of the lithium battery, apply insulating
tape and dispose of the battery in accordance with
applicable local regulations.
Place a new battery in the battery case
with its positive side facing up
mb075
Nouvelle pile (borne positive)
Before using the remote control
The remote control comes with a battery
installed.
There is an insulation sheet to prevent the
battery from discharging. Remove this
insulation sheet before using the remote
control.
mb073
Insulation sheet
Operating instructions
When using the remote control to operate
the system, aim the remote control at the
remote control sensor.
mb077
Remote control sensor
NOTE
● Do not disassemble or drop the remote control, and
do not subject the remote control to any physical
shock.
● Do not place any heavy objects on top of or sit on
the remote control.
● If the remote control sensor is exposed to direct
sunlight or other strong light, it may stop functioning
properly or stop operating at all. In this situation,
block out the light.
● Store the remote control in the seatback pocket
when not in use.


   


11 Names and functions of parts
Names and functions of parts
● Be sure to place the battery in with the correct
polarity.
● Replace the old battery with a new one of the same
type (CR2025LITHIUM).

Replace the battery case into the
remote control
mb076
Slide the battery case in
until tab A locks it in place. Ta b A
·
For safety’s sake, keep batteries out of the
reach of children.
WARNING


  


13 Names and functions of parts
Names and functions of parts
Replacing the wireless headphone batteries
Take the following steps to replace the wireless headphone
batteries.
Use a coin to turn the screw, then remove the screw, battery
cover, and the old battery.
Place two AAA batteries in the battery compartment,
checking for correct polarity, as shown in the fi gure.
Replace the battery cover.
Replace the screw.
NOTE
● When not using the headphones for an extended period, remove the batteries from
the wireless headphones.


  


14Names and functions of parts
Names and functions of partsPrecautions for use
Precautions for use
·
When running the engine so that you can view a video, for example, do not park your vehicle in a garage
or other enclosed space that has poor ventilation.
·
When driving, set the volume to a level at which you can still hear sounds outside the vehicle. Driving
without being able to hear sounds outside the vehicle could result in an accident.
·
For safety’s sake, the driver must not operate while driving.
WARNING
· Do not disassemble or modify. Doing so could cause smoke, fi re, or an accident.
CAUTION
NOTE
● When a message is displayed on the screen, be sure to follow the instructions that appear.
● Video may be viewed when the ignition switch is turned to ON or ACC, but to save battery power, it is best to view while the engine is running.
● If video or television are viewed for an extended period without running the engine, a low battery warning is displayed and the power will automatically be turned off.
● The following are characteristic of liquid crystal displays and are not malfunctions.

P Small black or luminescent (red, green, or blue) spots appear on the screen.

P The screen darkens or appears reddish in cold weather. Screen movement becomes sluggish.

P Screen color and brightness vary depending on the viewing angle.
● Clean the screen by wiping it with a soft cloth. Do not use benzine, anti-static agents, or chemically treated tissues. Doing so could damage the screen.


   


Error display messages
63
Error display messages
Message Action to take
DISC ERROR (-)
CALL AN AUTHORIZED
DEALER FOR ASSISTANCE.Contact your authorized
dealer.
ABNORMAL VOLTAGE
ABNORMAL VOLTAGE INPUT NOW.
SYSTEM OFF IN 7 SECONDS.Check the battery
voltage.
HIGH TEMPERATURE
EXTREMELY HIGH TEMPERATURE
INSIDE.SYSTEM OFF IN 7SECONDS.Wait a while for the
device to cool down.
SYSTEM ERROR (-)
CALL AN AUTHORIZED DEALER FOR
ASSISTANCE.Contact your authorized
dealer.Message Action to take
DVD DRIVE ERROR(-)
CALL AN AUTHORIZED
DEALER FOR ASSISTANCE.
Contact your
authorized dealer.
DVD DRIVE ERROR (-)
HIGH TEMPERATURE.
DVD DRIVE IS STOPPED FOR
PROTECTION.Wait a while for the
device to cool down.
DISC ERROR (-)
PLEASE CHECK THE DISC.Check the disc type,
check for scratches
on the disc.
VIDEO MODE (NTSC/PAL) IS SWITCHING
NOW PLEASE WAITWait until the video
playback mode changes
(NTSC
PAL).
DISC ERROR
THE REGION OF DISC CAN NOT BE
PLAYED.Check the region
number.


   


Troubleshooting
64
Troubleshooting
Problem Cause Action to take
The wireless
headphones do not
work.The wireless
headphone power is
switched OFF, or the
volume is turned all the
way down.Check the wireless
headphone power and
volume.
The wireless
headphone battery is
run down.Replace the battery.
The disc does not
play.The disc is inserted
with the disc surface
facing up.Insert the disc with
the disc surface facing
down.
The disc is dirty or
scratched.Check the disc.
The inserted disc is
not supported by the
system.
The recording format is
not supported by the
system.Check the operation
of the recording
equipment.
Problem Cause Action to take
The power does not
come on.The ignition key is in
the OFF position.Turn the ignition key
to the ACC or ON
positions.
The display remains
closed.Open the display or
press the POWER
button.
The remote control
does not work.The remote control
battery is run down.Replace the battery.
The system remote
control sensor is in
strong light, such as
direct sunlight.Avoid using the system
in direct sunlight.
The remote control
is not aimed at the
system remote control
sensor.Aim the remote control
at the system remote
control sensor.
The screen is dark.The brightness is not
properly adjusted.Make the necessary
adjustments.
The color is bad.The color or tint is not
properly adjusted.