2011 MAZDA MODEL TRIBUTE transmission fluid

3.0L V6 engine
1. Engine coolant reservoir
2. Air filter assembly
3. Brake fluid reservoir
4. Automatic transmission fluid dipstick
5. Power distribution box
6. Battery
7. Coolant bleed valve
8. Engine oil dipstick
9. Engine oil filler cap
10. Windshield washer fluid reservoir
1
1086
2435
97
Maintenance and Specifications
273
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by
20 minutes of stop-and-go driving with at least four 30-second idle
periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
BRAKE/CLUTCH FLUID
Brake and clutch (if equipped) systems are supplied from the same
reservoir.
The fluid level will drop slowly as
the brakes wear, and will rise when
the brake components are replaced.
Fluid levels between the MIN and
MAX lines are within the normal
operating range; there is no need to
add fluid. If the fluid levels are
outside of the normal operating
range, the performance of the
system could be compromised; seek
service from your authorized dealer
immediately.
TRANSMISSION FLUID
Checking automatic transmission fluid
Refer to your scheduled maintenance section for scheduled intervals for
fluid checks and changes. Your transmission does not consume fluid.
However, the fluid level should be checked if the transmission is not
working properly, i.e., if the transmission slips or shifts slowly or if you
notice some sign of fluid leakage.
Automatic transmission fluid expands when warmed. To obtain an
accurate fluid check, drive the vehicle until it is warmed up
(approximately 20 miles [30 km]). If your vehicle has been
Maintenance and Specifications
301
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

operated for an extended period at high speeds, in city traffic
during hot weather or pulling a trailer, the vehicle should be
turned off for about 30 minutes to allow fluid to cool before
checking.
1. Drive the vehicle 20 miles (30 km) or until it reaches normal
operating temperature.
2. Park the vehicle on a level surface and engage the parking brake.
3. With the parking brake engaged and your foot on the brake pedal,
start the engine and move the gearshift lever through all of the gear
ranges. Allow sufficient time for each gear to engage.
4. Latch the gearshift lever in P (Park) and leave the engine running.
5. Remove the dipstick, wiping it clean with a clean, dry lint free rag. If
necessary, refer toIdentifying components in the engine
compartmentin this chapter for the location of the dipstick.
6. Install the dipstick making sure it is fully seated in the filler tube.
7. Remove the dipstick and inspect the fluid level. The fluid should be
in the operating range for normal operating temperature.
Your vehicle is equipped with one of the following dipsticks.
Low fluid level
Do not drive the vehicle if the fluid
level is at the bottom of the dipstick
and the outside temperatures are
above 50°F (10°C).
Correct fluid level
The transmission fluid should be checked at normal operating
temperatures 185°F-200°F (85°C-93°C) on a level surface. The normal
operating temperature can be reached after approximately 20 miles
(30 km) of driving.
The transmission fluid should be in
the zone, identified by the arrows in
this figure, if at normal operating
temperature 185°F-200°F
(85°C-93°C).
DO NOT ADD
ADD (CHECK HOT)
DO NOT ADD
ADD (CHECK HOT)
Maintenance and Specifications
302
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

High fluid level
Fluid levels above the zone,
identified by the arrow in this
figure, may result in transmission
failure. An overfill condition of
transmission fluid may cause shift
and/or engagement concerns and/or possible damage.
High fluid levels can be caused by an overheating condition.
Adjusting automatic transmission fluid levels
Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick blade. Refer to
Maintenance product specifications and capacitiesin this chapter.
Use of a non-approved automatic transmission fluid may cause
internal transmission component damage.
If necessary, add fluid in 1/2 pint (250 ml) increments through the filler
tube until the level is correct.
If an overfill occurs, excess fluid
should be removed by an authorized
dealer.
An overfill condition of transmission fluid may cause shift and/or
engagement concerns and/or possible damage.
Do not use supplemental transmission fluid additives, treatments or
cleaning agents. The use of these materials may affect transmission
operation and result in damage to internal transmission components.
Checking transmission fluid level for recreational flat tow
operation
Before recreational flat towing your vehicle, the transmission fluid level
may need to be set to a lower level. These guidelines are designed to
prevent damage to your transmission. Before you recreational flat tow,
your fluid level must be verified by an authorized dealer.
This fluid level is within the normal
operating fluid range and does not
require that you have your fluid
level readjusted after recreational
flat tow operation.
See theTires, Wheels and Loadingchapter for more information on
recreational flat towing.
DO NOT ADD
ADD (CHECK HOT)
DO NOT ADD
ADD (CHECK HOT)
DO NOT ADD
ADD (CHECK HOT)
Maintenance and Specifications
303
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

Checking and adding manual transmission fluid (if equipped)
1. Park the vehicle on a level
surface.
2. Engage the parking brake fully –
put in first gear.
3. Ensure the vehicle cannot move.
4. Clean the filler plug.
5. Remove the filler plug, located
on the lower, forward driver
side of the transmission, and
inspect the fluid level.
6. Fluid level should be at bottom of the opening.
7. Add enough fluid through the filler opening so that the fluid level is
at the bottom of the opening.
8. Install and tighten the fill plug securely.
Use only fluid that meets Mazda specifications. Refer to the
Maintenance product specifications and capacitiessection in this
chapter.
AIR FILTER
Refer toscheduled maintenancefor the appropriate intervals for
changing the air filter element.
When changing the air filter element, only use a genuine Mazda air filter
element.
WARNING:To reduce the risk of vehicle damage and/or
personal burn injuries do not start your engine with the air
cleaner removed and do not remove it while the engine is running.
Maintenance and Specifications
304
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

MAINTENANCE PRODUCT SPECIFICATIONS AND CAPACITIES
Item ApplicationPart name or
equivalentCapacity
Brake fluid and (clutch
fluid–if equipped)AllHigh Performance DOT 3
Motor Vehicle Brake
FluidBetween MIN and MAX
on reservoir
Engine coolant2.5L engine•MazdaPremium
Gold Engine Coolant
(yellow-colored)
•MazdaSpecialty
Orange Engine Coolant
1
7.4 quarts (7.0L)
3.0L engine 9.5 quarts (9.0L)
Engine oil (including
filter change)2.5L engine
SAE 5W-20 Motor Oil5.3 quarts (5.0L)
3.0L engine 6.0 quarts (5.7L)
Power Transfer Unit
Fluid4WD with
automatic
transmissionAPI service GL-5
SAE 75W-140 Synthetic
Lubricant
12 ounces (0.35L)
4WD with manual
transmissionAPI service GL-5
SAE 80W-90
Manual transmission
fluidManual
transmissionAPI service GL-4
SAE 75W-902.4 quarts (2.3L)
2
Automatic transmission
fluidAutomatic
transmissionMERCONLV AT F
3
9.0 quarts (8.5L)
4
Rear axle fluid 4WDSAE 80W-90 Axle
Lubricant2.4 pints (1.15L)
5
Maintenance and Specifications
309
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

Item ApplicationPart name or
equivalentCapacity
Windshield washer fluid AllUltra-Clear Windshield
Washer ConcentrateFill as required
Fuel tank All — 17.5 gallons (66.2L)
1Add the coolant type originally equipped in your vehicle. Check the coolant reservoir bottle
labeling for the correct fluid type to use. Do not mix different colors or types of coolant. Do not
use Mazda Extended Life Engine Coolant (orange in color). Refer toAdding engine coolantin
this chapter.2Service refill capacity is determined by filling the transmission to the bottom of the filler hole with
the vehicle on a level surface.3Automatic transmissions that require MERCONLV should only use MERCONLV fluid. Refer to
scheduled maintenanceto determine the correct service interval. Use of any fluid other than the
recommended fluid may cause transmission damage.4Indicates only approximate dry-fill capacity. Some applications may vary based on cooler size and
if equipped with an in-tank cooler. The amount of transmission fluid and fluid level should be set
by the indication on the dipstick’s normal operating range.5Fill from 1/4 inch to 9/16 inch (6mm to 14mm) below bottom of fill hole.
Maintenance and Specifications
310
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

A
ABS (see Brakes) .....................193
Accessory delay ..........................57
Air cleaner filter ...............304–305
Air conditioning
manual heating and air
conditioning system .................36
Airbag supplemental restraint
system ................114–115, 124, 127
and child safety seats ............116
description ..............115, 124, 127
disposal ....................................130
driver airbag ............117, 125, 128
indicator light .........124, 126, 130
operation .................117, 125, 128
passenger airbag .....117, 125, 128
side airbag ...............................124
All Wheel Drive (AWD),
driving off road .........................210
Ambulance packages ....................7
AM/FM .........................................19
Antifreeze (see Engine
coolant) .....................................282
Anti-lock brake system (see
Brakes) ..............................193–194
Anti-theft system ........................83
Audio system (see Radio) .........19
Automatic transmission ............203
driving an automatic
overdrive .................................204
fluid, refill capacities ..............309
fluid, specification ..................309
Auxiliary input jack (Line in) ....27
Auxiliary power point .................55
Axle
lubricant specifications ..........309refill capacities ........................309
B
Battery .......................................280
acid, treating emergencies .....280
jumping a disabled battery ....238
maintenance-free ....................280
servicing ..................................280
Belt-Minder.............................110
Booster seats .............................144
Brakes ........................................193
anti-lock ...........................193–194
anti-lock brake system (ABS)
warning light ...........................194
fluid, checking and adding ....301
fluid, refill capacities ..............309
fluid, specifications .................309
lubricant specifications ..........309
parking ....................................194
shift interlock ..........................202
Bulbs ............................................45
C
Capacities for refilling fluids ....309
Car2UHome Automation
System .........................................63
Cargo area shade ........................70
CD ................................................19
Cell phone warning ...................314
Changing a tire .........................226
Child safety seats ......................135
attaching with tether straps ..142
in front seat ............................136
in rear seat ..............................136
LATCH .....................................139
Index
315
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)