2011 LEXUS RX350 display

15
Pictorial indexInstrument panel
Rear window wiper and washer switch
P. 202
Headlight switch
Turn signal lever
Fog light switch
P. 184
P. 163
P. 195
Tilt and telescopic steering control switch P. 83
Parking brake pedal P. 164
Engine (ignition) switch P. 153
Hood lock release lever P. 460
Gauges and meters
Multi-information display
P. 166
P. 173
Windshield wiper and washer switch
P. 197
Glove box P. 400
Power back door main
switch ∗ P. 52
∗: If equipped

17
A
Without navigation system
Security indicator
P. 101, 103
Audio system
P. 283
Emergency
flasher switch
P. 524
Multi-display
lOutside temperature
display
lClock
lAir conditioning
display
lAudio display
P. 411
P. 410
P. 274
P. 283
Air conditioning
system P. 274
Rear window and
outside rear view
mirror defoggers
P. 281
*2: Refer to “Navigation System Owner's Manual”.
Multi-display light
control switch P. 412

18
B
Telephone switches ∗ *1P. 367
Talk switch ∗ *1P. 367
Multi-information switch P. 173Audio remote
control switches *1P. 339
C
Head-up display
main switch ∗
P. 181
Display position adjustment switch ∗ P. 181
Display contrast
adjustment switch ∗
P. 181
Distance switch ∗ P. 208Side camera switch ∗, *2
Pictorial indexInstrument panel
Horn P. 165
SRS driver airbag P. 109
Cruise control switch P. 204, 208

35
1-2. Opening, closing and locking the doors
1

Before driving
nAlarms and warning indicators
A combination of exterior and interior alarms as well as warning messages shown
on the multi-information display is used to prevent theft of the vehicle and accidents
resulting from erroneous operation. Take appropriate measures in response to any
warning message on the multi-information display. (→P. 545)
The following table describes circumstances and correction procedures when only
alarms are sounded.
nSecurity feature
If a door is not opened within approximately 60 seconds after the vehicle is
unlocked, the security feature automatically locks the vehicle again.
AlarmSituationCorrection procedure
Exterior alarm
sounds once for 10
seconds.
An attempt was made to lock
the vehicle while a door was
open.
Close all of the doors
and lock the doors
again.
Interior alarm pings
repeatedly
The “ENGINE START
STOP” switch was turned to
ACCESSORY mode while
the driver's door is open (The
driver's door was opened
when the “ENGINE START
STOP” switch is in ACCES-
SORY mode.)
Close the driver's door.
The “ENGINE START
STOP” switch was turned off
while the driver's door is
open.
Close the driver's door.

38
1-2. Opening, closing and locking the doors
nNotes for locking the doors
lTouching the door lock sensor while wearing gloves may delay or prevent lock
operation. Remove the gloves and touch the lock sensor again.
lWhen the lock operation is performed using the lock sensor, recognition signals
will be shown up to two consecutive times. After this, no recognition signals will
be given.
lIf the door handle becomes wet while the electronic key is within the effective
range, the door may lock and unlock repeatedly. Place the key in a position 6 ft.
(2 m) or more separate from the vehicle while the vehicle is being washed. (Take
care to ensure that the key is not stolen.)
lIf the electronic key is inside the vehicle and a door handle becomes wet during
a car wash, a message may be shown on the multi-information display and a
buzzer will sound outside the vehicle. To turn off the alarm, lock all the doors.
lThe lock sensor may not work properly if it comes into contact with ice, snow,
mud, etc. Clean the lock sensor and attempt to operate it again, or use the lock
sensor on the lower part of the door handle.
lFingernails may scrape against the door during operation of the door handle.
Be careful not to injure fingernails or damage the surface of the door.
nNotes for the unlocking function
lGripping the door handle when wearing a glove may not unlock the door.
lA sudden approach to the effective range or door handle may prevent the
doors from being unlocked. In this case, return the door handle to the original
position and check that the doors unlock before pulling the door handle again.
lIf there is another electronic key in the detection area, it may take slightly longer
to unlock the doors after the door handle is gripped.
nWhen the vehicle is not driven for extended periods
lTo prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2 m)
of the vehicle.
lThe smart access system with push-button start can be deactivated in advance.
(→P. 6 2 1 )

131
1
1-7. Safety information

Before driving
Installing child restraints
Follow the child restraint system manufacturer's instructions. Firmly
secure child restraints to the seats using the LATCH anchors or a seat belt.
Attach the top tether strap when installing a child restraint.
The lap/shoulder belt can be used if your child restraint system is not com-
patible with the LATCH (Lower Anchors and Tethers for Children) system.
Child restraint LATCH anchors
LATCH anchors are provided
for the outer rear seats. (Buttons
displaying the location of the
anchors are attached to the
seats.)
Seat belts equipped with a child
restraint locking mechanism
(ALR/ELR belts except driver’s
seat belt) (→P. 7 5 )
Anchor brackets (for top tether
strap)
An anchor bracket is provided
for each rear seat.

156
2-1. Driving procedures
nIf the engine does not start
The engine immobilizer system may not have been deactivated. (→P. 1 0 1 )
nSteering lock
After turning the “ENGINE START STOP” switch off and opening and closing the
doors, the steering wheel will be locked due to the steering lock function. Operat-
ing the “ENGINE START STOP” switch again automatically cancels the steering
lock.
nWhen the steering lock cannot be released
nSteering lock motor overheating prevention
To prevent the steering lock motor from overheating, the motor may be suspended
if the engine is turned on and off repeatedly in a short period of time. In this case,
refrain from operating the engine. After about 2 seconds, the steering lock motor
will resume functioning.
nWhen the “ENGINE START STOP” switch indicator flashes in amber
The system may be malfunctioning. Have the vehicle inspected by your Lexus
dealer immediately.
nIf the electronic key battery is depleted
→P. 4 9 6
The green indicator light on the “ENGINE
START STOP” switch will flash and a mes-
sage will be shown on the multi-information
display. Press the “ENGINE START STOP”
switch again while turning the steering wheel
left and right.

160
2-1. Driving procedures
nSelecting snow mode
Use snow mode for accelerating and driving on slippery road sur-
faces such as snow.
Press the menu switch.
The multi-information display
will change modes to electronic
features control mode.
Press the “ENTER” switch
upwards or downwards until
“ECT SNOW” appears.
Press the “ENTER” switch to
change to “ON”.
The “ECT SNOW” indicator will
be displayed.
Each pressing of the switch
turns snow mode on and off.
Press the menu switch to
change to the normal display.
STEP1
STEP2