Page 163 of 609

154
2-1. Driving procedures
IS250/220d/200d_EE
NOTICE
When driving the vehicle
Do not depress the accelerator and brake pedals at the same time during
driving. If the brake pedal is depressed while driving with the accelerator
pedal depressed, driving torque may be restrained.
With automatic transmission vehicles
Do not use the accelerator pedal or depress the accelerator and brake ped-
als together to hold the vehicle on a hill.
With manual transmission vehicles
Do not rest your foot on the clutch pedal while driving.
Doing so may cause clutch trouble.
Do not use any gears other than the first gear when starting off and mov-
ing forward.
Doing so may damage the clutch.
Do not use the clutch to hold the vehicle when stopping on an uphill
grade.
Doing so may damage the clutch.
When parking the vehicle
With automatic transmission vehicles, always put the shift lever in P. Failure
to do so may cause the vehicle to move or the vehicle may accelerate sud-
denly if the accelerator pedal is accidentally depressed.
Avoiding damage to vehicle parts
Do not turn the steering wheel fully in either direction and hold it there for
a long time.
Doing so may damage the power steering motor.
When driving over bumps in the road, drive as slowly as possible to avoid
damaging the wheels, underside of the vehicle, etc.
IS220d and IS200d: Make sure to idle the engine immediately after high-
speed driving or hill climbing. Stop the engine only after the turbocharger
has cooled down.
Failure to do so may cause damage to the turbocharger.
Page 522 of 609

496
5-2. Steps to take in an emergency
IS250/220d/200d_EE
CAUTION
Using the tire jack
Improper use of the tire jack may lead to death or serious injuries due to the
vehicle suddenly falling off the jack.
Do not use the tire jack for any purpose other than replacing tires or
installing and removing tire chains.
Only use the tire jack that comes with this vehicle for replacing a flat tire.
Do not use it on other vehicles, and do not use other tire jacks for replac-
ing tires on this vehicle.
Always check that the tire jack is securely set to the jack point.
Do not put any part of your body under the vehicle supported by a jack.
Do not start or run the engine while your vehicle is supported by the jack.
Do not raise the vehicle while someone is in it.
When raising the vehicle, do not put an object on or under the jack.
Do not raise the vehicle to a height greater than that required to replace the
tire.
Use a jack stand if it is necessary to get under the vehicle.
Take particular care when lowering the vehicle to ensure that no one work-
ing on or near the vehicle may be injured.
Replacing a flat tire
Do not attach a heavily damaged wheel ornament, as it may fly off the
wheel while the vehicle is moving.
Failure to follow these precautions could cause the wheel nuts to loosen
and the tire to fall off, resulting in death or serious injury.
• Never use oil or grease on the wheel bolts or wheel nuts.
Oil and grease may cause the wheel nuts to be excessively tightened,
leading to bolt or disc wheel damage. In addition, the oil or grease can
cause the wheel nuts to loosen and the wheel may fall off, causing a
serious accident. Remove any oil or grease from the wheel bolts or
wheel nuts.
• Have the wheel nuts tightened with a torque wrench to 103 N
•m (10.5
kgf
•m, 76 ft•lbf) as soon as possible after changing wheels.
Page 578 of 609
548
6-1. Specifications
IS250/220d/200d_EE
Tires and wheels
Tires and wheels (except for compact spare)
Ty p e A
Tire size205/55R16 89W
Tire inflation pressure
(front and rear)
(Recommended cold tire
inflation pressure)
Vehicle
speedFront wheel
kPa (kgf/cm2
or bar, psi)
Rear wheel
kPa (kgf/cm2
or bar, psi)
More than
210 km/h
(132 mph)
310 (3.1, 45)330 (3.3, 48)
From 160 km/
h (100 mph)
to 210km/h
(132 mph)
290 (2.9, 42)310 (3.1, 45)
160 km/h
(100 mph) or
less
240 (2.4, 35)260 (2.6, 38)
Wheel size16 7 JJ
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)
Page 579 of 609
549
6-1. Specifications
6
Vehicle specifica-
IS250/220d/200d_EETy p e B
Tire sizeFront tires: 225/45R17 90W
Rear tires: 245/45R17 95W
Tire inflation pressure
(front and rear)
(Recommended cold tire
inflation pressure)
Vehicle
speedFront wheel
kPa (kgf/cm2
or bar, psi)
Rear wheel
kPa (kgf/cm2
or bar, psi)
More than
210 km/h
(132 mph)
300 (3.0, 44)320 (3.2, 46)
From 160 km/
h (100 mph)
to 210km/h
(132 mph)
280 (2.8, 41)300 (3.0, 44)
160 km/h
(100 mph) or
less
240 (2.4, 35)260 (2.6, 38)
Wheel size17 8 J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)
Page 580 of 609
550
6-1. Specifications
IS250/220d/200d_EETy p e C
Tire sizeFront tires: 225/40R18 88Y
Rear tires: 255/40R18 95Y
Tire inflation pressure
(front and rear)
(Recommended cold tire
inflation pressure)
Vehicle
speedFront wheel
kPa (kgf/cm2
or bar, psi)
Rear wheel
kPa (kgf/cm2
or bar, psi)
More than
210 km/h
(132 mph)
320 (3.2, 46)340 (3.4, 49)
From 160 km/
h (100 mph)
to 210km/h
(132 mph)
300 (3.0, 44)320 (3.2, 46)
160 km/h
(100 mph) or
less
IS250
240 (2.4, 35)
IS220d
and IS200d
260 (2.6, 38)IS250
260 (2.6, 38)
IS220d
and IS200d
280 (2.8, 41)
Wheel sizeFront wheels: 18 8J
Rear wheels: 18 8 1/2 J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)