2011 Lexus CT200h remote

499
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_EE (OM76041E)
Before recharging
When recharging, the 12-volt battery produces hydrogen gas which is flam-
mable and explosive. Therefore, observe the following precautions before
recharging:
If recharging with the 12-volt battery installed on the vehicle, be sure to
disconnect the ground cable.
Make sure the power switch on the charger is off when connecting and
disconnecting the charger cables to the 12-volt battery.
After recharging/reconnecting the 12-volt battery
Unlocking the doors using the smart entry & start system may not be
possible immediately after reconnecting the 12-volt battery. If this hap-
pens, use the wireless remote control or the mechanical key to lock/
unlock the doors.
Start the hybrid system with the “POWER” switch in ACCESSORY
mode. The hybrid system may not start with the “POWER” switch
turned OFF. However, the hybrid system will operate normally from the
second attempt.
The “POWER” switch mode is recorded by the vehicle. If the battery is
reconnected, the vehicle will return the “POWER” switch mode to the
status it was in before the battery was disconnected. Make sure to turn
off the power before disconnect the battery. Take extra care when con-
necting the battery if the “POWER” switch mode prior to discharge is
unknown.
Restart the hybrid system, depress the brake pedal, and confirm that it is
possible to shift into each shift position.
If the system will not start even after multiple attempts at all methods above,
contact any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional.

518
4-3. Do-it-yourself maintenance
CT200h_EE (OM76041E)
Use a CR1632 lithium battery
Batteries can be purchased at any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional, local electrical appli-
ance shops or camera stores.
Replace only with the same or equivalent type recommended by the
manufacturer.
Dispose of used batteries according to local laws.
When the card key battery needs to be replaced (if equipped)
The battery for the card key is available only at Lexus dealer. Your Lexus
dealer can replace the battery for you.
If the electronic key battery is depleted
The following symptoms may occur:
The smart entry & start system, push-button start system and wireless
remote control will not function properly.
The operational range will be reduced.

519
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_EE (OM76041E)
CAUTION
Removed battery and other parts
Keep away from children. These parts are small and if swallowed by a child,
they can cause choking. Failure to do so could result in death or serious
injury.
Certification for the smart entry & start system and push-button start system
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCOR-
RECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS.
NOTICE
For normal operation after replacing the battery
Observe the following precautions to prevent accidents:
Always work with dry hands.
Moisture may cause the battery to rust.
Do not touch or move any other component inside the remote control.
Do not bend either of the battery terminals.

5
617
5-2. Steps to take in an emergency
When trouble arises
CT200h_EE (OM76041E)
If the electronic key does not operate properly
Locking and unlocking the doors and key linked functions
Use the mechanical key (P. 54)
in order to perform the following
operations:
An alarm will sound if the
alarm is set. ( P. 138)
Locks all the doors
Closes the windows
* (turn
and hold)
Unlocks all the doors
Opens the windows
* (turn
and hold)
*: This setting must be customized
at any authorized Lexus dealer
or repairer, or another duly
qualified and equipped profes-
sional.
If communication between the electronic key and vehicle is inter-
rupted (P. 82) or the electronic key cannot be used because the bat-
tery is depleted, the smart entry & start system, the push-button start
system and wireless remote control cannot be used. In such cases, the
doors can be opened and the hybrid system can be started by following
the procedure below.

660
6-2. Customization
CT200h_EE (OM76041E)
Smart
entry &
start sys-
tem
*4 and
wireless
remote
control
(
P. 59,
80)
LOCK FEED-
BACK VOL-
UME
(Adjust the
volume of
buzzer sounds)
7
Off
–OO
1 to 6
LOCK/
UNLOCK
ANSWER
BACK
(Enable/dis-
able the opera-
tion of the
emergency
flashers when
the vehicle is
locked or
unlocked)
OnOff–OO
ItemFunctionDefault
settingCustomized
setting

661
6-2. Customization
6
Vehicle specifica-
CT200h_EE (OM76041E)
Smart
entry &
start sys-
tem
*4 and
wireless
remote
control
(
P. 59,
80)
AUTO.
RELOCK
TIME
ADJUST-
MENT
(Adjust the
time elapsed
before the
automatic door
lock function
is activated if a
door is not
opened after
being
unlocked)
30 seconds
Off
–OO
60 seconds
120 seconds
Open door
reminder
buzzer (When
locking the
vehicle)
OnOff––O
ItemFunctionDefault
settingCustomized
setting

663
6-2. Customization
6
Vehicle specifica-
CT200h_EE (OM76041E)
Wireless
remote
control
(
P. 80)
Wireless
remote controlOnOff––O
REMOTE
2-PRESS
UNLOCK
(Allows all
doors to be
unlocked by
pressing
on the elec-
tronic key
once)
Off
(All doors
unlocked in
first step)
On
(Driver’s door
unlocked in
first step, all
doors
unlocked in
second step)
–OO
Auto
alarm
(
P. 138)
Operation
when doors
are unlocked
using the
mechanical
key
OffOn––O
ItemFunctionDefault
settingCustomized
setting

666
6-2. Customization
CT200h_EE (OM76041E)
Illumina-
tion
(
P. 438)
Operation
after the
“POWER”
switch is
turned to OFF
OnOff––O
Operation
when the
doors are
unlocked with
the Smart
entry & start
system or the
wireless
remote con-
trol function or
the mechanical
key
*2
OnOff––O
Operation
when you
approach the
vehicle with
the electronic
key on your
person
*2
OnOff––O
ItemFunctionDefault
settingCustomized
setting