2011 Lexus CT200h light

469
4-1. Maintenance and care
4
Maintenance and care
CT200h_EE (OM76041E)
NOTICE
To prevent paint deterioration and corrosion on the body and components
(aluminum wheels etc.)
Wash the vehicle immediately in the following cases:
• After driving near the sea coast
• After driving on salted roads
• If coal tar or tree sap is present on the paint surface
• If dead insects, insect droppings or bird droppings are present on the
paint surface
• After driving in an area contaminated with soot, oily smoke, mine
dust, iron powder or chemical substances
• If the vehicle becomes heavily soiled with dust or mud
• If liquids such as benzene and gasoline are spilled on the paint sur-
face
If the paint is chipped or scratched, have it repaired immediately.
To prevent the wheels from corroding, remove any dirt and store in a
place with low humidity when storing the wheels.
Cleaning the exterior lights
Wash carefully. Do not use organic substances or scrub with a hard brush.
This may damage the surfaces of the lights.
Do not apply wax to the surfaces of the lights.
Wax may cause damage to the lenses.

473
4-1. Maintenance and care
4
Maintenance and care
CT200h_EE (OM76041E)
NOTICE
Cleaning detergents
Do not use the following types of detergent, as they may discolor the vehi-
cle interior or cause streaks or damage to painted surfaces:
• Non-seat portions: Organic substances such as benzene or gasoline,
alkaline or acidic solutions, dye, and bleach
• Seats: Alkaline or acidic solutions, such as thinner, benzene, and
alcohol
Do not use polish wax or polish cleaner. The instrument panel’s or other
interior part’s painted surface may be damaged.
Preventing damage to leather surfaces
Observe the following precautions to avoid damage to and deterioration of
leather surfaces:
Remove any dust or dirt from leather surfaces immediately.
Do not expose the vehicle to direct sunlight for extended periods of time.
Park the vehicle in the shade, especially during summer.
Do not place items made of vinyl, plastic, or containing wax on the uphol-
stery, as they may stick to the leather surface if the vehicle interior heats
up significantly.
Water on the floor
Do not wash the vehicle floor with water.
Vehicle systems such as the audio system may be damaged if water comes
into contact with electrical components such as the audio system above or
under the floor of the vehicle. Water may also cause the body to rust.
Cleaning the inside of the rear window
Do not use glass cleaner to clean the rear window, as this may cause dam-
age to the rear window defogger heater wires or antenna. Use a cloth
dampened with lukewarm water to gently wipe the window clean. Wipe
the window in strokes running parallel to the heater wires or antenna.
Be careful not to scratch or damage the heater wires or antenna.

478
4-3. Do-it-yourself maintenance
CT200h_EE (OM76041E)
ItemsParts and tools
Engine oil level (P. 487)
• “Toyota Genuine Motor Oil” or
equivalent
• Rag or paper towel
• Funnel (used only for adding
engine oil)
Fuses (P. 520)• Fuse with same amperage rating
as original
Light bulbs (P. 534)
• Bulb with same number and
wattage rating as original
• Phillips-head screwdriver
• Flathead screwdriver
•Wrench
Radiator and condenser (P. 4 9 4)
Tire inflation pressure (P. 507)• Tire pressure gauge
• Compressed air source
Washer fluid (P. 495)
• Water or washer fluid contain-
ing antifreeze (for winter use)
• Funnel (used only for adding
water or washer fluid)

480
4-3. Do-it-yourself maintenance
CT200h_EE (OM76041E)
NOTICE
If you remove the air cleaner filter
Driving with the air cleaner filter removed may cause excessive engine wear
due to dirt in the air. Also, a backfire could cause a fire in the engine com-
partment.
If the fluid level is low or high
It is normal for the brake fluid level to go down slightly as the brake pads
wear or when the fluid level in the accumulator is high.
If the reservoir needs frequent refilling, it may indicate a serious problem.

481
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_EE (OM76041E)
Hood
Release the lock from the inside of the vehicle to open the hood.
Pull the hood release lever.
The hood will pop up
slightly.
Pull up the auxiliary catch
lever and lift the hood.
Hold the hood open by
inserting the supporting rod
into the slot.
STEP1
STEP2
STEP3

500
4-3. Do-it-yourself maintenance
CT200h_EE (OM76041E)
CAUTION
Chemicals in the 12-volt battery
The 12-volt battery contains poisonous and corrosive sulfuric acid and may
produce hydrogen gas which is flammable and explosive. To reduce the risk
of death or serious injury, take the following precautions while working on
or near the 12-volt battery:
Do not cause sparks by touching the 12-volt battery terminals with tools.
Do not smoke or light a match near the 12-volt battery.
Avoid contact with eyes, skin and clothes.
Never inhale or swallow electrolyte.
Wear protective safety glasses when working near the 12-volt battery.
Keep children away from the 12-volt battery.
Where to safely charge the 12-volt battery
Always charge the 12-volt battery in an open area. Do not charge the 12-volt
battery in a garage or closed room where there is insufficient ventilation.
How to recharge the 12-volt battery
Only perform a slow charge
*. The 12-volt battery may explode if charged at
a quicker rate.
*: 4.2 A or less on vehicles with a navigation system or alarm
3.5 A or less on vehicles without a navigation system and alarm

524
4-3. Do-it-yourself maintenance
CT200h_EE (OM76041E)
Fuse layout and amperage ratings
Engine compartment
FuseAmpereCircuit
1DC/DC125 AInverter and converter
2HTR50 AAir conditioning system
3RDI30 AElectric cooling fans
4CDS30 AElectric cooling fans
5RAD NO.115 AAudio system, navigation system
6S-HORN10 ANavigation system
7ENG W/P30 ACooling system
8ABS MAIN
NO.27.5 AElectronically controlled brake
system
9H-LP CLN30 AHeadlight cleaner
10P CON MTR30 AP position control system

525
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_EE (OM76041E)
11AMP NO.230 AAudio system
12ETCS10 A
Multiport fuel injection system/
sequential multiport fuel injection
system
13IGCT30 APCU, IGCT NO.2, IGCT NO.3
14DC/DC-S5 AInverter and converter
15P CON MAIN7.5 AP position control system, P posi-
tion switch
16AM27.5 APower management system
17ECU-B27.5 ASmart entry & start system
18MAYDAY10 ANo circuit
19ECU-B310 AAir conditioning system
20TURN & HAZ10 ATurn signal lights, emergency
flashers
21AMP NO.130 AAudio system
22ABS MAIN
NO.120 AElectronically controlled brake
system
23P/I 240 A
P position control system, horn,
headlights (low beam), back-up
light
24ABS MTR 130 AElectronically controlled brake
system
25ABS MTR 230 AElectronically controlled brake
system
26H-LP HI MAIN20 AH-LP RH HI, H-LP LH HI
FuseAmpereCircuit