2011 JEEP COMPASS air condition

[x] Cancel search: air condition

Page 371 of 490

JEEP COMPASS 2011 1.G Owners Manual Automatic Transmission – If Equipped
The automatic transmission fluid and filter should be
changed if you REGULARLY tow a trailer for more than
45 minutes of continuous operation. Refer to “Mainte

Page 376 of 490

JEEP COMPASS 2011 1.G Owners Manual HAZARD WARNING FLASHERS
The Hazard Warning flasher switch is located on the
instrument panel, below the radio.Press the switch to turn on the Hazard Warning
flasher. When the switch is activated, all

Page 377 of 490

JEEP COMPASS 2011 1.G Owners Manual CAUTION!
Driving with a hot cooling system could damage
your vehicle. If the pointer rises to the H (red) mark,
the instrument cluster will sound a chime. When
safe, pull over and stop the vehicle wit

Page 397 of 490

JEEP COMPASS 2011 1.G Owners Manual MAINTAINING YOUR VEHICLE
CONTENTS
Engine Compartment — 2.0L ............. 397
 Engine Compartment — 2.4L ............. 398
 Onboard Diagnostic System — OBD II ...... 399
▫ Loose Fuel Filler

Page 410 of 490

JEEP COMPASS 2011 1.G Owners Manual CAUTION!
•It is essential when replacing the cables on the
battery that the positive cable is attached to the
positive post and the negative cable is attached to
the negative post. Battery posts are

Page 411 of 490

JEEP COMPASS 2011 1.G Owners Manual WARNING!
•Use only refrigerants and compressor lubricants
approved by the manufacturer for your air condi-
tioning system. Some unapproved refrigerants are
flammable and can explode, injuring you. O

Page 421 of 490

JEEP COMPASS 2011 1.G Owners Manual •Keep the front of the radiator clean. If your vehicle is
equipped with air conditioning, keep the front of the
condenser clean.
•Do not change the thermostat for Summer or Winter
operation. If re

Page 426 of 490

JEEP COMPASS 2011 1.G Owners Manual Frequency Of Fluid Change
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
Power Transfer Unit (PTU) – AWD/4WD Models
Only
Lubricant Selection
Use only the manufacturer