2
J A G U A R X FJ A G U A R X F J A G U A R X F
Vehicle access
Jaguar Smart Key
Emergency key access
If there is a problem with the Smart Key and it will not
unlock the vehicle, use the emergency key access
procedure. Press the Smart Key release button
Remove the key blade .
Insert the blade into the slot beneath the front left\b
hand door lock cover. Lift slightly and twist to remove
the cover. Insert the key into the exposed lock and
turn it towards the rear of the vehicle then release it
to unlock.
If the vehicle security system was previously armed
with the Smart Key, the alarm will sound. To disarm
the alarm, press the START STOPbutton while the
Smart Key is inside the vehicle.
Unlocking mode alternatives
Single\bpoint entry allows only the driver’s door to unlock with a single press. A second press unlocks all other doors
and trunk.
Multi\bpoint entry will unlock all doors and trunk with a single press.
To change between modes, with the vehicle unlocked, press the lock and unlock buttons simultaneously for three
seconds. The hazard warning lamps will flash twice to confirm the change.
• Press once to lock the vehicle and arm the exterior (perimetric) alarm.
• Multi\bpoint entry \b Press once to disarm the alarm, unlock all doors and unlock
the trunk.
• Press and hold to unlock all doors and open the windows and sunroof (Global
opening).
• Press once to switch the headlamps on for 25 seconds. Press again to
switch off.
• Press to open only the luggage compartment. The rest of the security
system remains active.
• Press and hold for three seconds to activate/cancel the panic alarm.
1
2
To unlock the vehicle and disarm the alarm, simply
press a door handle button or luggage compartment
release button while the Smart Key is within 3 ft (\f
metre) of the vehicle.
To lock the vehicle and arm the alarm, first ensure
that the Smart Key is outside the vehicle but within
3ft (\f metre).
Press a door handle button once to single lock. Press
it twice within three seconds to double lock.Rear seat release handles
The split fold rear seats have release handles located
inside the trunk. Pull to release one or both seat
backs and fold forward. Head restraints can be
removed if required.
Keyless entry/exit
JJM 18 96 40 111:XF 11MY.qxd 16/12/2009 08:57 Page 2
J A G U A R X FJ A G U A R X F J A G U A R X F
3
1\bTurn signals and exterior lighting.
\f\b Downshift (\b) paddle
3\b Audio and telephone switches.
4\b Instrument pack, message center and warning
indicators
5\b Cruise control switches
6\b Upshift (+) paddle
7\b Windshield wiper and washer
8\b Master locking switches
9\b Hazard warning switch
10\b Touch\bscreen
11\b Home screen
1\f\b Touch\bscreen on/off
13\b Climate control
14\b JaguarDrive selector
15\b DSC (Dynamic Stability Control) switch
16\b ASL (Automatic Speed Limiter) switch
41256 7
89101112
13
17
18
19
20
21
1514
16
2223
28
27
26
24
25
29
30
31
32
3
17\b EPB (Electric Parking Brake)
18\b Dynamic mode switch
19\b Winter mode switch
\f0\b Engine start/stop button
\f1\b Audio system
\f\f\b Horn
\f3\b Column adjust switch
\f4\b Headlamps levelling
\f5\b Instruments dimmer control
\f6\b Rear fog lamps
\f7\b Trunk release
\f8\b Forward alert
\f9\b Mirror adjuster
30\b Powerfold mirror selector s
31\b Window switches
3\f\b Window switch isolator
Driver controls
Trunk opening
With the vehicle unlocked, the trunk can also be
opened by pressing the release button under the
chrome finisher at the rear of the vehicle.Powerfold mirrors
Press buttons 30simultaneously to fold the mirrors
inward. Press again to unfold.
JJM 18 96 40 111:XF 11MY.qxd 16/12/2009 08:57 Page 3
Starting and driving
J A G U A R X FJ A G U A R X F J A G U A R X F
5
Ignition on:
• With the Jaguar Smart Key inside the vehicle,
press the START STOP button to switch on
ignition.
• A second press will switch off the ignition.
Engine start
• The selector lever must be in Park orNeutral
position to enable engine starting.
• With the footbrake depressed, press and release the START STOP button to start the engine.
• Press again to stop the engine and switch off the ignition.
Rolling start
If the engine is switched off while the vehicle is
moving, it can be restarted by selecting Nposition
then pressing the START STOPbutton.
Operating note
The engine will continue to run even if the Smart
Key is removed from the vehicle by more than 3ft
(\f metre). However, if the engine is stopped, it
cannot be restarted until the Smart Key is returned
to the vehicle.
Engine start and stopSee page 3, item 20
Gearshift interlock
The brake pedal must be
depressed before the
selector can be moved
from the Park position.
Maintain brake pressure
until a gear is selected.
Select Pbefore switching
off the engine. However, if
the engine is switched off
with Reverse, Drive or
Sport selected, the
selector will automatically
return to Pwhile retracting.
P R N D S
STARTENGINESTOP
DSC
Automatic gear selection
Select Dfor fully automatic gear changes.
Sport mode
This is an automatic gear change mode, however,
change points are modified to make full use of engine
power.
Press the selector down and rotate from Dto Sport.
Manual gear changes
Manual gear change mode is effective when rapid
acceleration and engine braking are required.
• To shift down, briefly pull the left (\b) paddle.
• To shift up, briefly pull the right (+) paddle.
When the paddles are used in D,gear selection will
revert to automatic if use of the paddles is not
maintained. With Sselected, continuous manual
operation is initiated if the paddles are used.
NOTE: To return to automatic operation pull and hold
the right hand paddle for two seconds.
Operating note
If the engine is switched off with Neutral selected,
automatic selection of Pis delayed for \f0 minutes.
DO NOT use this feature to enable towing of the
vehicle. Refer to Vehicle recovery in the Owner’s
Handbook.
TransmissionSee page 3, items 2,6and 14
JJM 18 96 40 111:XF 11MY.qxd 16/12/2009 08:57 Page 5
6
J A G U A R X FJ A G U A R X F J A G U A R X F
Starting and driving
Low tire pressure
Airbag fault
DSC off, Trac DSC ON or
DSC fault. Flashing \b DSC
operating
Adaptive Cruise Control
activeSeat belt reminder
ASL active
Forward alert active
Engine malfunction
ABS fault (USA only)
EPB on, brake fluid low or
braking system fault.
(USA only)
EPB on, brake fluid low or
braking system fault
ABS fault
Applying • With the vehicle stationary, lift up the parking brake lever and then release it. The red warning
indicator in the instrument panel will illuminate.Releasing
• With the ignition on, apply the foot brake and press down on the parking brake lever.
• If the vehicle is stationary with the parking brake applied and either Drive orReverse selected,
pressing the accelerator will automatically release
the parking brake.
NOTE: Do \fOT use the recess in the electric parking
brake as a storage area.
Electric parking brakeSee page 3, item 17
Warning lampsDisplayed on the instrument panel
Operating note
The brake must be manually applied when parking.
Auto headlamps and wipersSee page 3, items 1and 7
MAX
MINMAX
MIN
6
5
7
Automatic wipers are activated by a rain sensor.
When the wiper control is moved up to the first
position the wipers will operate automatically as
required. Sensitivity can be adjusted.
First stop for auto position.
\bRain sensor maximum sensitivity.
Rain sensor minimum sensitivity.
When AUTO is selected on the lighting control
the side lamps and headlamps will turn on
automatically when ambient light fades.
With the control in the low beam position, high
beam will activate automatically when ambient
light falls below a pre set level. Vehicle speed
must be above 25 mph (40 km/h).
The headlamps can be set to temporarily
light your way when you exit the car at night.
Rotate the contol for exit delay periods of 30
seconds, 60 seconds or \f20 seconds.
1
432
Automatic car wash
Before entering an automatic car wash, turn the
wipers off to deactivate the rain sensor. Otherwise,
the wipers will operate during the washing process
and may be damaged.
JJM 18 96 40 111:XF 11MY.qxd 16/12/2009 08:57 Page 6