2011 JAGUAR XF mirror controls

adblue reset dead battery open trunk snow chains wheel torque timing belt gas type

Page 3 of 16

$JAGUAR XF 2011 1.G Quick Start Guide J A G U A R X FJ A G U A R X F J A G U A R X F 3 1\bTurn signals and exterior lighting. \f\b Downshift (\b) paddle 3\b Audio and telephone switches. 4\b Instrument pack, message center and warning ind$

Page 4 of 16

$JAGUAR XF 2011 1.G Quick Start Guide \f J A G U A R X FJ A G U A R X F J A G U A R X F Comfort adjustments Driver’s seat Set the seat position using the following controls. �Seat back angle and head restraint. �Lumbar support. �Side su$

\f
J A G U A R X FJ A G U A R X F J A G U A R X F
Comfort adjustments
Driver’s seat
Set the seat position using the following controls.
Seat back angle and head restraint.
Lumbar support.
Side support \b deflate.
Side support \b inflate.
Cushion length.
\bSeat forwards and back, cushion height and
cushion angle.
NOTE: Seat heater controls are accessed via the
touchscreen.
Steering column
With the vehicle stationary, adjust the steering
column to your ideal driving position.
Door mirrors
1\b Press the left or right mirror selector.
\f\b Use the mirror adjuster to set mirror position.
Storing the driving position to memory
Once you have adjusted the driver's seat, steering
column and door mirrors for your ideal driving
position, the settings can be stored.
Press the SETbutton to activate the memory
store function. The button will illuminate to
indicate the memory store function is active.
Within 5 seconds, press button 1or \fto store
the current driving position.
A stored memory position can now be recalled with a
press of the appropriate button; 1or \f. The seat,
steering wheel and mirrors will move to their preset
positions.
123
46
5
7
A warning indicator on the instrument panel
will illuminate if the seat belt of an occupied
front seat is not fastened. This may be
accompanied by an audible warning.
Using child seats
Refer to Child Seat Positioning in the Owner’s
Handbook to determine the correct seat for your
child.
If it becomes necessary to fit a child restraint on the
front passenger seat, make the following seat
adjustments.• Move the seat fully rearward.
• Lumbar support to minimum setting.
• Seat cushion to highest position.
• Cushion front tilt to lowest position.
• Seat back to upright position.
• Adjust the upper seat belt anchorage to its lowest position.
Operating note
Memory buttons must be pressed within five
seconds after pressing the SETbutton otherwise
the memory store function will cancel.
Setting the driving positionSee page 3, items 23, 2\fand30
Restraints
JJM 18 96 40 111:XF 11MY.qxd 16/12/2009 08:57 Page 4

Page 8 of 16

JAGUAR XF 2011 1.G Quick Start Guide 8
J A G U A R X FJ A G U A R X F J A G U A R X F
Driving aids
Winter mode, Dynamic mode and Dynamic Stability
Control (DSC) allow the driver to more finely tune the
vehicle driving characteristics to

8
J A G U A R X FJ A G U A R X F J A G U A R X F
Driving aids
Winter mode, Dynamic mode and Dynamic Stability
Control (DSC) allow the driver to more finely tune the
vehicle driving characteristics to suit prevailing
conditions.
Winter mode . Use in slippery road conditions.
Selects 2nd gear for driving away, moderates engine
response and modifies gear change strategy to
ensure maximum possible traction is achieved.
Dynamic mode. Optimises vehicle systems to
deliver a high performance driving experience. If
Sport mode is now used with paddle gear selection,
there is no automatic gear change, even if the rev
limit is reached. Dynamic mode remains selected for
six hours after the engine is switched off
DSC. The default condition at engine start is DSC
on and is designed to control vehicle stability.
TracDSC is an alternative setting that optimises the
DSC settings for maximum traction in difficult
conditions. TracDSC enables a more involving and
focused driving experience. To select TracDSC, press
and release the button. Touch again to return to DSC.
To turn DSC off, press for more than \f0 seconds.
Message center The message center displays the
JaguarDrive Selector position,
P,R,N,D orS, the manual mode
gear selections 1to 6and the
JaguarDrive Control mode
selection.
When TracDSC is selected, the DSC warning lamp
will illuminate and the message center will briefly
display TracDSC\b
When DSC OFF is selected, the DSC warning lamp
will illuminate and the message center will display
DSC OFF until DSC is reinstated.
Driving mode settings
Refer to the Owner’s Handbook section, Stability
control, for examples of JaguarDrive settings.
1
2
3
JaguarDrive controlSee page 3, items 1\b,18and 1\f
Door mirrors and blind spot monitoring
Mirror dip when reversing
This feature can be used to improve lower side views
while reversing. It can be enabled or disabled via the
touch\bscreen. From the Homescreen, select Vehicle,
then Veh\b settings, then Parking.
To set a dip position:
• with the electric parking brake on, select reverse gear
• adjust the mirror position to view the lower rear kerb and vehicle.
Subsequently, each time reverse gear is selected, the
set dip position will be automatically selected. The
mirrors will return to their normal position when
another gear is selected.Blind spot monitoring
Each mirror displays amber icons to warn of
overtaking vehicles in adjacent lanes. The monitored
area extends approximately 20 ft (6 meters) behind
your rear wheels and 8.2 ft (2.5 meters) to the sides.
It switches on automatically at speeds above \f0 mph
(\f6km/h) while in a forward gear. An amber dot
illuminates when speed is below the threshold.
JJM 18 96 40 111:XF 11MY.qxd 16/12/2009 08:57 Page 8

relay glove box service indicator fog light open hood remove seats