WW-74
< REMOVAL AND INSTALLATION >
REAR WIPER ARM
REAR WIPER ARM
Exploded ViewINFOID:0000000006220420
Removal and InstallationINFOID:0000000006220421
REMOVAL
1. Operate rear wiper to the auto stop position.
2. Remove rear wiper arm cover.
3. Remove rear wiper arm mounting nut.
4. Remove wiper arm from the vehicle.
INSTALLATION
1. Clean wiper arm mount as shown in the figure to prevent nutfrom being loosened.
2. Operate the rear wiper motor to the auto stop position.
3. Adjust the rear wiper blade position. Refer to WW-74, "
Adjust-
ment".
4. Install the rear wiper arm by tightening the mounting nut.
5. Inject the washer fluid.
6. Operate the rear wiper to the auto stop position.
7. Check that the rear wiper blades stop at the specified position.
8. Install the rear wiper arm cover.
AdjustmentINFOID:0000000006220422
REAR WIPER BLADE POSITION ADJUSTMENT
Set the wiper blade top on the defrosting wire (A) (c learance between the end of back door glass and the top
of wiper blade center).
1. Rear wiper motor 2. Pivot seal 3. Rear wiper arm
4. Rear wiper arm cover 5. Rear wiper blade
Refer to GI-4, "
Components" for symbols in the figure.
JMLIA0942GB
SKIA0082J
Revision: 2010 May2011 QX56
