2011 HONDA CR-Z Owners Manual

72
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Door/Hatch Open Indicator Comes on for a few seconds if you

•
turn the ignition switch to ON
II,
then goes off. Comes on if the hatch or either

•
door is not completely closed. Goes off if both doors and the hatch

•
are closed.
EPS (Electric Power Steering System) Indicator Comes on when you turn the

•
ignition switch to ON
II, and goes
off when the engine starts. Comes on if there is a problem

•
with the EPS (Electric Power Steering System). Stays on constantly or does not

•
come on at all - Have the vehicle
checked by a dealer.
If the EPS Indicator Comes On P.302
U.S. models only
Low Tire Pressure/TPMS IndicatorComes on briefly when you turn

•
the ignition switch to ON
II.
Comes on if the tire pressure of any

•
of the tires becomes significantly low.Blinks for about one minute, and

•
then stays on if there is a problem with the TPMS, or when a compact spare tire is temporarily installed. Comes on during driving

• - Stop in
a safe place, check tire pressures, and inflate the tire(s) if necessary. Blinks and remains on

• - Have the
vehicle checked by a dealer. If the vehicle is fitted with a compact spare, get your regular tire repaired or replaced and put back on your vehicle as soon as you can.
Main MenuTable of Contents

73
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
High Temperature Indicator Comes on briefly when you turn

•
the ignition switch to ON
II.
Blinks when the engine coolant

•
temperature goes up, and stays on if the temperature continues to rise. Blinks while driving

• - Drive slowly to
prevent overheating.Stays on while driving

• - Immediately
stop in a safe place and allow the engine to cool.
Overheating P.297
IMA System Indicator Comes on briefly when you turn

•
the ignition switch to ON
II.
Comes on if there is a problem

•
with the IMA system. Remains on or does not come on

•
at all - Avoid high speed driving and
have the vehicle checked by a dealer as soon as possible.
If the IMA Indicator Comes ON P.303
System Message Indicator Comes on along with a beep when

•
a problem is detected. A system message on the multi-information display appears at the same time. While the indicator is on, press the

•
(information) button to see
the message again. Refer to the Indicators information in

•
this chapter when a system message appears on the multi-information display. Take the appropriate action for the message.
The multi-information display does not

•
return to the normal screen unless the warning is canceled, or the

button is pressed.
—
Main MenuTable of Contents

74
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Low Temperature Indicator Comes on when the engine

•
coolant temperature is low. If the indicator stays on after the

•
engine has reached normal operating temperature, there may be a problem with the temperature sensors. Have the vehicle inspected by a dealer.
—
U.S.
Canada Side Airbag Off Indicator Comes on for a few seconds when

•
you turn the ignition switch to ON
II, then goes off.
Comes on when the passenger side

•
airbag system is automatically shut off. It does not mean there is a problem

•
with your side airbags. Comes on when nobody is sitting

•
in the passenger seat - Have the
vehicle checked by a dealer.Comes on when someone is sitting

•
in the seat - Have the person sit
properly. U.S.
Canada
High Beam Indicator Comes on when the high beam

•
headlights are on.Comes on with reduced brightness

•
when DRL (daytime running lights) are on. —
—
Main MenuTable of Contents

75
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Lights On Indicator Comes on whenever the light

•
switch is on, or in AUTO when the exterior lights are on. If you remove the key from the

•
ignition switch while the light is on, a chime sounds when the driver’s door is opened.
—
Fog Light Indicator * Comes on when the fog lights are

•
on. ——
Turn Signal IndicatorsThe turn signal indicators blink

•
when you operate the turn signal lever.If you press the hazard warning

•
button, both indicators and all turn signals blink at the same time. Does not blink or blinks rapidly

• -
A turn signal light bulb has blown. Change the bulb immediately. Replacing Light Bulbs P.262, 263—
Immobilizer System IndicatorComes on briefly when you turn

•
the ignition switch to ON
II, then
goes off. Comes on if the immobilizer

•
system cannot recognize the key information. Blinks

• - You cannot start the engine.
Turn the ignition switch to LOCK
0, pull the key out, and then insert
the key and turn it to ON
II again.
Repeatedly blinks

• - The system may
be malfunctioning. Have the vehicle checked by a dealer.Do not attempt to alter this system

•
or add other devices to it. Electrical problems can occur.
—
*Not available on all models
Main MenuTable of Contents

76
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Security Alarm System IndicatorBlinks when the security alarm

•
system has been set.
Security Alarm System P.105—
Auto Idle Stop IndicatorBlinks when Auto Idle Stop is in

•
operation. The engine automatically shuts off. Auto Idle Stop P.224, 227—
Cruise Main Indicator Comes on when you press the

•
CRUISE button. Cruise Control P.211 —
Cruise Control Indicator Comes on if you have set a speed

•
for cruise control. Cruise Control P.211—
Shift Up Indicator
* Comes on briefly when you turn

•
the ignition switch to ON II.
Comes on when shifting up is

•
recommended.
Shift Up/Down Indicators P.208—
Shift Down Indicator
* Comes on briefly when you turn

•
the ignition switch to ON II.
Comes on when shifting down is

•
recommended.
SPORT Mode Indicator *1 Comes on briefly when you turn

•
the ignition switch to ON II.
Comes on when you press the

•
SPORT mode button. 3-Mode Drive System P.210
*Not available on all models
Main MenuTable of Contents

77
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
NORMAL Mode Indicator*1 Comes on briefly when you turn

•
the ignition switch to ON II.
Comes on when you press the

•
NORMAL mode button. 3-Mode Drive System P.210
ECON Mode Indicator *1 Comes on briefly when you turn

•
the ignition switch to ON
II.
Comes on when you press the

•
ECON mode button. 3-Mode Drive System P.210
* 1
: The driving mode message on the multi-information display appears for a few seconds when you press the appropriate mode
button.
Main MenuTable of Contents

78
Instrument Panel
Indicators Multi-Information Display Warning and Information Messages
Multi-Information Display Warning and Information Messages The following messages appear only on the multi-information display. Press the
(information) button to see the message again
with the system message indicator on.
Message Condition Explanation
Appears when the fuel fill cap is loose or is not

•
installed.
Tighten the Fuel Fill Cap P.301
Appears if there is a problem with the DRL system.

•
Daytime Running Lights P.112
Canadian models only Appears when washer fluid gets low.

• Refilling washer fluid.

•
Refilling Window Washer Fluid P.257
Appears when the scheduled maintenance is due

•
soon. Consequently, “SERVICE DUE NOW” and “SERVICE

•
PAST DUE” follow.
Maintenance Minder ™
P.241
Appears when you open the driver’s door while the

•
ignition key is in ACCESSORY
I. Turn the ignition switch to LOCK

•
0, then
remove the key.
Main MenuTable of Contents

79
Instrument Panel
Indicators Multi-Information Display Warning and Information Messages
Message ConditionExplanation
Appears when the ignition key is turned to

•
ACCESSORY
from ON II. (The driver’s door is
closed.) —
Appears when you open the driver’s door while the

•
ignition key is in LOCK
0. Remove the key from the ignition switch.

•
Appears if the clutch pedal is not fully depressed while
the auto idle stop is in operation, and the engine is ready
to restart. Fully depress the clutch pedal.

•
Auto Idle Stop P.227
Appears when the shift lever is in any forward gear

•
position, and the auto idle stop operating time has continued for a while. Shift to

•
N. Auto Idle Stop P.227
Appears while the auto idle stop is in operation, and

•
to allow the engine to restart again for the following reasons:
The IMA battery charge is low.
•
There is a problem with the system.
• Manually start the engine.

•
Starting the Engine P.197
Main MenuTable of Contents