2011 HONDA CIVIC COUPE manual transmission

[x] Cancel search: manual transmission

Page 277 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual If you exceed the maximum speed 
f or the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may f eel
the engine cut in and out. This is
caused by a li

Page 280 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual µµ µ
This position is similar
to D, except only the first three 
gears are selected. Use D to provide
engine braking when going down a
steep hill. D can also keep the
transmission f rom cycling

Page 282 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual If your vehicle has an automatic 
transmission, set the parking brake
bef ore you put the transmission in
Park. This keeps the vehicle f rom
moving and putting pressure on the
parking mechanism in the

Page 293 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual This section explains why it is 
important to keep your vehicle well
maintained and how to f ollow basic
maintenance saf ety precautions. 
This section also includes 
instructions on how to read the
M

Page 302 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual ÎÎ
Fluid Locations
DX, LX, EX, EX-L, in the U.S., and DX-G, SE, EX, EX-L in the Canada
298
RADIATOR CAP
WASHER FLUID 
(Blue cap)
ENGINE OIL DIPSTICK
(Orange handle)
BRAKE FLUID
(Black cap)
ENGINE

Page 313 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual Check the f luid level with the 
transmission at normal operating
temperature and the vehicle sitting
on level ground. Remove the
transmission f iller bolt, and caref ully
f eel inside the bolt hole w

Page 314 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual The f luid level should be between 
theMINandMAXmarksontheside
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected f or leaks

Page 315 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual Manual Transmission onlyAll models except Si and Canadian DX-Gwith manual transmission
The f luid level should be between 
theMINandMAXmarksontheside
of the reservoir. If it is not, add
brake f luid t