2011 HONDA ACCORD COUPE light

Malfunction IndicatorsIf an indicator remains on\b there may be a problem; see your dealerOn\bOff Indicators
Condition IndicatorsAction is needed by driver
PASSENGERAIRBAG
OFFPASSENGER AIRBAG OFF(above Hazard Warning button)
SIDE AIRBAGOFF
VSA OFF
CRUISE CONTROL on
ECOFuel economyon*
Fog lightson*
Headlights on
Turn signals/hazards on
CRUISE MAINonHigh beamson
*if equipped
Charging system
Low brake fluid
Low oil pressure
ABS(antilock brake system)
DRL(daytime running lights)
Malfunction indicator lamp(check engine light)
TPMS(tire pressure monitoring system)
VSA(vehicle stability assist)
SRS(supplemental restraint system)
Parking brake on:
Release
Door/Trunk open:
Close door(s) / trunk
Seat belt reminder:
Fasten seat belt(s)
Low fuel:
Refill
Low tire pressure:
Add air
Maintenance MinderTM:
Make dealer appointment
INSTRUMENT PANEL INDICATORS
Immobilizer
Flashes: improperly coded key;
use correct key
Briefly appear with each engine start. Red and amber indicators are most critical.
Blue and green indicators are used for general information.
45
11 Accord 2D TRG\fATG_NEW STYLE 8/3/2010 10\f50 AM Page 4

I P O D®O R U S B F L A S H M E M O R Y
Play audio files from your compatible iPod or USB flash memory device through your
vehicle’s audio system.
Connecting Devices and Playing Audio Files
1.Open the center console\b and pull
out the USB adapter cable.
3.Press CD/AUX or AUX to begin
playing.
2. Connect the USB connector to your
iPod dock connector or flash drive.
4. Press the SKIP buttons to change
tracks.
1011
H O M E L I N K®( i f e q u i p p e d )
The HomeLink Universal Transceiver can be programmed to operate up to three
remotecontrolled devices around your home\b such as garage doors\b lighting\b or home
security systems.
Press and hold thebutton on the
remote and the HomeLin kbutton at
the same time. Th en, while
continuing to hold the HomeLink
button, press and release thebutton
on the remote every 2seconds.
Does the LED blink at a faster rate within 20
seconds?
Press and hold
the HomeLink
button again. Training
complete
YES
NO
HomeLink indicator
flashes for 2 seconds,
then remains on. HomeLink LED
remains on.YES
NO YES
NO
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.1
Press and hold the desired
HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
2
a
The remote has a rolling code.
Press the “learn” button on the
remote-controlled device (e.g.,
garage door opener).
Press the programmed HomeLink
button again; the remote-controlled
device should operate. Within 30 seconds, pressand
hold the programmed HomeLink
button for 2 seconds.a
Press and hold theprogrammed
HomeLink button for about a
second.
Does the device (garage door opener) work?
3
b
4
5
Training a Button
If you have any problems programming HomeLink\b see the owner’s manual included
with the device you are trying to program\b call HomeLink at (8\f\f) 3553515\b or
visit www.homelink.com .
iPod is a registered trademark of Apple Computer, Inc ., registered in the U.S. and other countries. iPod not included. model with
navigation shown
11 Accord 2D TRG\fATG_NEW STYLE 8/3/2010 10\f51 AM Page 7