2011 FORD TRANSIT CONNECT brake

[x] Cancel search: brake

Page 184 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual Once through the water, always dry the brakes by moving your
vehicle slowly while applying light pressure on the brake pedal.
Wet brakes do not stop the vehicle as quickly as dry brakes.
Electric vehi

Page 190 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
126 — Rear unlock relay
127 — Ignition overload relay
128 — Battery saver relay (modified
vehicle)
130 15A Hazard flashers
131 5A Power mirro

Page 191 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
154 15A Roof lamp (modified vehicle)
155 10A Battery saver (modified vehicle)
156 7.5A Right parking lamp/tail lamps
157 7.5A License plate lamps
1

Page 193 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual The high-current fuses are coded as follows:
Fuse/Relay
LocationFuse Amp
RatingProtected circuits
1 7.5A* Heated windshield telltale
2 40A** Right heated windshield, Modified
vehicle — Rear heater b

Page 194 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual Fuse/Relay
LocationFuse Amp
RatingProtected circuits
13 30A* Heater blower motor
14 10A* PCM relay
15 20A** ABS/RSC valves
16 30A** Cooling fan – low
17 50A** Cooling fan – high
18 25A** Daytime r

Page 195 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual Fuse/Relay
LocationFuse Amp
RatingProtected circuits
30D — Left heated windshield relay
31A — Backup lamp relay
31B — Fuel pump relay
31C — DRL relay
31D — Low beam headlamps relay
31E — M

Page 198 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual Stopping and securing the vehicle
1. Park on a level surface, set the
parking brake and activate hazard
flashers.
2. Place gearshift lever in P (Park)
and turn engine off.
Removing the spare tire
The

Page 199 of 295

FORD TRANSIT CONNECT 2011 1.G Owners Manual 3. Detach the first cable by pulling
the cap up and sliding it away from
the wheel. Then turn the end of the
cable so it fits through the slot and
remove the cable and bracket.
4. Detach the second ca