2011 FORD MUSTANG ground clearance

Introduction
3
Welcome 3
Breaking-in your vehicle 4
ShelbyGT500Unique Features
5
Driving your ShelbyGT500
9
AdvanceTrac10
Driving through water 10
Ground clearance 11
Washing your vehicle 11
Chassis
12
Wheels 12
Wheel lug nut torque 13
Tire information 14
Roadside Emergencies
18
Wrecker towing 18
Maintenance
22
Engine oil 23
Air filter(s) 28
Part numbers 29
Refill capacities 30
Warranty Coverage
34
Table of Contents
1
2011 05+ Mustang(197)
Supplement, 1st Printing
USA(fus)

GROUND CLEARANCE
Because of low vehicle ground clearance, use caution when
approaching curbs/curb stops from the front and rear as vehicle
damage will occur. Additionally, when crossing speed bumps or
driveway curbs, SVT recommends approaching at a 45 degree
angle to reduce the risk of vehicle damage.
WASHING YOUR SHELBY GT500
Do not drive your vehicle through an automated, commercial car
wash due to the vehicle’s low ground clearance, tire width and
track. Wash your vehicle by hand, or by using a touchless
commercial wash with no mechanical tracks on the floor. Do not
use a commercial or high pressure wand on the striped surfaces
or stripe edges.
Driving your ShelbyGT500
11
2011 05+ Mustang(197)
Supplement, 1st Printing
USA(fus)

SUSPENSION
•MacPherson strut with L-arm front suspension
•8.8 inch solid rear axle with limited slip differential (3.55:1 ratio
standard, 3.73:1 ratio optional))
Coupe stabilizer bars:
•33.2 x 5.0 mm tubular front stabilizer bar
•23.0 mm standard, 24.0 mm optional solid rear bar
•Tokico twin tube shocks and struts
Convertible stabilizer bars:
•33.2 x 5.0 mm tubular front stabilizer bar
•23 mm standard, 22 mm optional solid rear bar
•Tokico twin tube shocks and struts
Coupe spring rates:
•34.0 N/mm front and 31.5 N/mm rear standard
•41.0 N/mm front and 34.5 N/mm rear optional
Convertible spring rates:
•31.5 N/mm front and 27.3 N/mm rear standard
•34.0 N/mm front and 31.5 N/mm rear optional
WHEELS
Your SVT vehicle is equipped with unique wheels matched to the tires.
These wheels are more susceptible to damage due to their diameter,
width and low profile tires. To avoid damage to your wheels:
•Maintain proper tire pressure (seeTiresin this supplement).
•Do not drive your vehicle through an automated, commercial car wash
due to the vehicle’s low ground clearance, tire width and track. Wash
your vehicle by hand, or by using a touchless commercial wash with
no mechanical tracks on the floor. Do not use a commercial or high
pressure wand on the striped surfaces.
•When installing wheels, always torque lug nuts to specification with a
torque wrench.
•Inspect your wheels for damage on a regular basis. If a wheel is
damaged, replace it immediately.
•In the event that you encounter an abnormally harsh impact, inspect
the outer diameter of your wheels, both inside and out, for damage.
Chassis
12
2011 05+ Mustang(197)
Supplement, 1st Printing
USA(fus)