2011 FORD EXPLORER bulb

5. Pull the bulb straight out of the
socket.
Reverse steps to reinstall bulb(s).
Replacing turn/backup lamp bulbs
The turn/backup lamp bulbs are located in the same area of the tail lamp
assembly, one below the other. Follow the same steps to replace these
bulbs:
1. Make sure the headlamp switch is
in the off position, then open the
liftgate to expose the lamp assembly
bolts.
2. Remove the two bolts covers
using a standard flat tip screwdriver.
3. Remove the two bolts from the
lamp assembly.
4. Carefully remove the lamp
assembly away from the vehicle by
pulling the assembly straight out to expose the bulb socket.
Lights
89
2011 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

5. Disconnect the electrical
connector (1) from the lamp
assembly. Disconnect the bulb
socket (2) from the lamp assembly
by squeezing the two tabs at the top
and bottom of the socket.
6. Pull bulb straight out of socket and install the new bulb.
7. Install the bulb socket (2) by pushing it directly into the lamp
assembly until the top and bottom tabs snap into place. Reconnect the
electrical connector
8. Carefully install the tail lamp assembly on the vehicle by securing the
lamp assembly with two bolts.
Replacing tail/brake lamp bulbs
For bulb replacement, see your authorized dealer.
2
1
Lights
90
2011 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

Replacing fog lamp bulbs
1. Make sure the headlamp switch is
off.
2. Remove the bulb socket from the
fog lamp by turning it
counterclockwise.
3. Disconnect the electrical
connector.
Reverse steps to reinstall bulb(s).
Replacing license plate lamp bulbs
1. Make sure the headlamp switch is
off.
2. Remove the lamp assembly by
pressing the small tab and rocking
the lamp assembly out.
3. Remove the bulb socket from the
lamp assembly by turning
counterclockwise and pull the bulb
straight out.
Reverse steps to reinstall bulb(s).
Replacing high-mount brake lamp bulb
Your vehicle is equipped with an LED center high-mount stop lamp
located in the spoiler. It is designed to last the life of the vehicle. If
replacement is required, see your authorized dealer.
Lights
91
2011 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the service engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If the service engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer toOn-board
diagnostics (OBD-II)in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If the service engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if the service engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by
20 minutes of stop-and-go driving with at least four 30-second idle
periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
Maintenance and Specifications
403
2011 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

idle speed control ...................382
lubrication specifications .......411
refill capacities ........................411
service points ..........................377
Engine block heater .................273
Engine oil ..................................380
checking and adding ..............380
dipstick ....................................380
filter, specifications ........381, 410
recommendations ...................381
refill capacities ........................411
specifications ..........................411
Event data recording ....................8
Exhaust fumes ..........................272
F
Fail safe cooling ........................390
Fleet MyKey programming ......132
Floor mats .................................122
Fluid capacities .........................411
Fog lamps ....................................78
Four-Wheel Drive vehicles
driving off road .......................316
preparing to drive your
vehicle .....................................286
Fuel ............................................392
calculating fuel economy .......398
cap ...........................................394
capacity ...................................411
choosing the right fuel ...........395
detergent in fuel .....................396
filler funnel .............................396
filling your vehicle with
fuel ...........................392, 394, 398
filter, specifications ........391, 410
fuel pump shut-off ..................327
improving fuel economy ........398
octane rating ...................395, 414quality ......................................396
running out of fuel .........353, 396
safety information relating to
automotive fuels .....................392
Fuses ..................................327–328
G
Garage door opener ..................116
Gas cap (see Fuel cap) ............394
Gas mileage
(see Fuel economy) .................398
Gauges .........................................21
H
Hazard flashers .........................326
Headlamps ...................................77
aiming ........................................80
autolamp system .......................77
bulb specifications ....................85
daytime running lights .............79
flash to pass ..............................78
high beam .................................78
turning on and off ....................77
Heating
heating and air conditioning
system ...........................63, 66, 68
Hill descent mode .....................283
Hill start assist ..........................292
Hood ..........................................376
I
Ignition ...............................267, 414
Illuminated visor mirror .............94
Infant seats
(see Safety seats) .....................216
Index
444
2011 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

Inspection/maintenance (I/M)
testing ........................................403
Instrument panel
cleaning ...................................370
cluster ........................................14
lighting up panel and
interior .......................................79
Intelligent Access Key ..............131
Intelligent Access with push
button start ...............................143
J
Jack ............................................336
positioning ...............................336
storage .....................................336
Jump-starting your vehicle ......354
K
Keyless entry system
autolock ...................................139
keypad .....................................152
locking and unlocking doors ..153
programming entry code .......152
Keys ...................................130, 155
positions of the ignition .........267
L
Lamps
autolamp system .......................77
bulb replacement
specifications chart ............84–85
daytime running light ...............79
fog lamps ...................................78
headlamps .................................77
headlamps, flash to pass ..........78
instrument panel, dimming .....79
interior lamps ...........................83
LATCH anchors .........................222Liftgate ......................123–124, 145
Lights, warning and indicator ....14
anti-lock brakes (ABS) ..........275
Loading instructions .................261
Load limits .................................255
Locks
autolock ...................................139
childproof ................................142
doors ........................................138
Lubricant specifications ...........411
Luggage rack .............................128
Lug nuts ....................................352
Lumbar support, seats .....163, 165
M
Message center .....................23, 34
warning messages ...............27, 43
Mirrors ...............................100–101
automatic dimming rearview
mirror ......................................100
fold away .................................102
heated ......................................101
programmable memory ..........145
side view mirrors (power) .....101
signal .......................................102
Moon roof ..................................114
Motorcraftparts ..............374, 410
MyFord Connect™ system ........62
MyFord Touch™ system ............62
MyFord™ system ..................51, 62
MyKey ........................................132
O
Octane rating ............................395
Oil (see Engine oil) ..................380
Index
445
2011 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)