2011 FORD E SERIES bulb

2. Remove the four screws from the
headlamp assembly and carefully
remove the lamp/bezel.
3. Remove the four screws and the
retaining ring.
4. Disconnect the electrical
connector from the lamp and
remove the lamp.
To install the new lamp, follow the
removal procedures in reverse order.
Replacing front parking lamp/turn signal bulbs
1. Make sure the headlamp control is in the off position.
2. Remove the headlamp assembly. Refer toReplacing headlamp bulbs
in this section.
Aerodynamic
Sealed beam
3. Rotate the bulb socket counterclockwise and remove.
4. Carefully pull the bulb straight out of the socket.
Lights
58
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)

To complete installation, follow the removal procedures in reverse order.
Replacing side marker bulbs
1. Make sure the headlamp control is in the off position.
2. Remove the headlamp assembly. Refer toReplacing headlamp bulbs
in this section.
Aerodynamic
Sealed beam
3. Rotate the bulb socket counterclockwise and remove.
4. Carefully pull the bulb straight out of the socket.
To complete installation, follow the removal procedures in reverse order.
Lights
59
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)

Replacing high-mount brake lamp bulbs
On vehicles without a rear headliner, the interior cargo lamp (if
equipped) must be removed from under the high-mount brake lamp
assembly located inside the vehicle. Then, do the following:
1. Remove the two screws from the
high-mount brake lamp assembly
and lift the lamp from the vehicle.
2. Remove the bulb socket from the
lamp assembly by turning it
counterclockwise.
3. Carefully pull the bulb straight
out of the socket.
To install the new bulb, follow the removal procedure in reverse order.
Replacing license plate lamp bulbs
1. Turn the headlamp switch to the
off position.
2. Remove the two screws and the
license plate lamp assembly from
the rear door.
3. Remove bulb socket from lamp
assembly by turning it
counterclockwise.
4. Pull the bulb out from socket and
push in the new bulb.
To install the new bulb, follow the removal procedures in reverse order.
Lights
60
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)

Replacing stop/turn/tail/side marker/backup lamp bulbs
The stop/turn/tail/side marker/backup lamp bulbs are located in the tail
lamp assembly. Follow the same steps to replace any of the bulbs:
1. Turn the headlamp switch to the
off position, then remove the four
screws and the lamp assembly from
the vehicle.
2. Rotate the bulb socket
counterclockwise and remove it
from lamp assembly.
3. Carefully pull the bulb straight
out of the socket and push in the
new bulb.
To install the lamp, follow the removal procedures in reverse order.
Lights
61
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)

20 mph (32 km/h) will turn off the stability control light and TCS OFF
light. The switch will not allow partial AdvanceTracwith RSCsystem
disabling above 20 mph (32 km/h).
In R (Reverse), ABS and the engine traction control and brake traction
control features will continue to function; however, ESC and RSCare
disabled.
AdvanceTracwith RSCFeatures
Button
functionsStability
control and
TCS OFF
lightRSCESC TCS
Default at
start-upIlluminated
during bulb
checkEnabled Enabled Enabled
Button pressed
momentarilyIlluminated
solidEnabled EnabledDisabled
below
20 mph
(32 km/h)
Button pressed
again after
deactivation or
driving above
20 mph
(32 km/h)Not
illuminatedEnabled Enabled Enabled
STEERING
To help prevent damage to the power steering system:
•Never hold the steering wheel at its furthest turning points (until it
stops) for more than a few seconds when the engine is running.
•Do not operate the vehicle with a low power steering pump fluid level
(If the fluid level is below the FULL COLD range on the dipstick).
•Some noise is normal during operation. If the noise is excessive, check
for low power steering pump fluid level before seeking service by your
authorized dealer.
Driving
193
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)

If the service engine soonindicator remains on, have your vehicle
serviced at the first available opportunity. Although some malfunctions
detected by the OBD-II may not have symptoms that are apparent,
continued driving with the service engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the service engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If the service engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer toOn-board
diagnostics (OBD-II)in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If the service engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if the service engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by
20 minutes of stop-and-go driving with at least four 30-second idle
periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
Maintenance and Specifications
281
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)

A
Accessory delay ..........................64
AdvanceTrac ..............................189
Air cleaner filter .......289–290, 293
Airbag supplemental restraint
system ................................103–104
and child safety seats ............105
description ..............................104
disposal ....................................108
driver airbag ............................106
indicator light .........................107
operation .................................106
passenger airbag .....................106
passenger deactivation
switch ......................................109
Ambulance packages ....................7
Antifreeze (see Engine
coolant) .....................................263
Anti-lock brake system
(see Brakes) ......................186–187
Anti-theft system ........................81
arming the system ....................82
Audio system (see Radio) ...29, 31
Automatic transmission
driving an automatic
overdrive .........................198, 200
fluid, adding ............................284
fluid, checking ........................284
fluid, refill capacities ..............294
fluid, specification ..................294
Auxiliary Input Jack ...................38
Auxiliary power point .................63
Axle
lubricant specifications ..........294
refill capacities ........................294
traction lok ..............................194B
Battery .......................................260
acid, treating emergencies .....260
jumping a disabled battery ....232
maintenance-free ....................260
replacement, specifications ...293
servicing ..................................260
Belt-Minder...............................99
Blind spot mirror ......................208
Booster seats .............................131
Brakes ........................................186
anti-lock ...........................186–187
anti-lock brake system (ABS)
warning light ...........................187
fluid, checking and adding ....283
fluid, refill capacities ..............294
fluid, specifications .................294
lubricant specifications ..........294
parking ....................................187
shift interlock ..........................196
trailer .......................................175
Bulbs ............................................55
C
Capacities for refilling fluids ....294
Cell phone use ............................10
Changing a tire .........................222
Child safety seats ......................117
in front seat ............................118
in rear seat ..............................118
LATCH .....................................121
recommendations ...................115
tether anchorage hardware ...128
Child safety seats - booster
seats ...........................................131
Cleaning your vehicle
engine compartment ..............248
Index
332
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)

Exhaust fumes ..........................184
F
Fail safe cooling ........................267
Flexible Fuel Vehicle (FFV) ....269
Floor mats .............................71–72
Fluid capacities .........................294
Four-Wheel Drive vehicles
preparing to drive your
vehicle .....................................194
Fuel ............................................269
calculating fuel
economy ............................22, 276
cap ...........................................272
capacity ...................................294
choosing the right fuel ...........274
detergent in fuel .....................274
filling your vehicle
with fuel ..................269, 272, 276
filter, specifications ........269, 293
fuel pump shut-off switch .....212
improving fuel economy ........276
octane rating ...................274, 301
quality ......................................275
running out of fuel .................275
safety information relating to
automotive fuels .....................269
Fuel - flex fuel vehicle
(FFV) .................................269, 274
Fuses ..................................214–215
G
Gas cap (see Fuel cap) ............272
Gas mileage (see Fuel
economy) ...................................276
Gauges .........................................19
H
Hazard flashers .........................212Head restraints ...........................85
Headlamps ...................................50
aiming ........................................53
bulb specifications ....................56
daytime running lights .............50
flash to pass ..............................51
high beam .................................50
replacing bulbs .........................57
turning on and off ....................50
Heating
heater only system .............47, 49
heating and air conditioning
system .......................................48
Hood ..........................................255
I
Ignition ...............................181, 301
Illuminated visor mirror .............63
Infant seats
(see Safety seats) .....................117
Inspection/maintenance (I/M)
testing ........................................281
Instrument panel
cleaning ...................................249
cluster ........................................14
lighting up panel and
interior .......................................51
J
Jack ............................................222
positioning ...............................222
storage .....................................222
Jump-starting your vehicle ......232
K
Keyless entry system
autolock .....................................72
Index
334
2011 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)