2011 DODGE DURANGO wheel

[x] Cancel search: wheel

Page 461 of 576

DODGE DURANGO 2011 3.G Owners Manual 5. Raise the vehicle by turning the jack screw clockwise.
Raise the vehicle just enough to remove the flat tire.
WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable. It

Page 462 of 576

DODGE DURANGO 2011 3.G Owners Manual 8. Lower the vehicle by turning the jack screw counter-
clockwise, and remove the jack and wheel blocks.
9. Finish tightening the lug nuts. Push down on the
wrench while tightening for increased lever

Page 463 of 576

DODGE DURANGO 2011 3.G Owners Manual 12. Slide the road wheel on the ground using the protec-
tive plate until it is directly under the winch and between
the rear bumper and exhaust system heat shields. Raise
the tire by turn the lug wre

Page 465 of 576

DODGE DURANGO 2011 3.G Owners Manual 15. Have the aluminum road wheel and tire repaired as
soon as possible and properly secure the spare tire, jack
and tool kit.
WARNING!
A loose tire or jack, thrown forward in a collision or
hard stop

Page 472 of 576

DODGE DURANGO 2011 3.G Owners Manual Towing Condition Wheels OFFthe GroundRWD MODELS AWD MODELS
Flat Tow NONE If transmission is operable:
•Trans in
NEUTRAL
•30 mphmax(48 km/h)
•15 miles (24 km) maxdistance See instructions in “R

Page 473 of 576

DODGE DURANGO 2011 3.G Owners Manual CAUTION!
•Do not attempt to use sling type equipment when
towing. When securing the vehicle to a flat bed
truck, do not attach to front or rear suspension
components. Damage to your vehicle may resu

Page 474 of 576

DODGE DURANGO 2011 3.G Owners Manual If the transmission is not operable, or the vehicle must be
towed faster than 30 mph (48 km/h) or farther than
15 miles (24 km), tow with the rear wheelsOFFthe
ground. Acceptable methods are to tow th

Page 510 of 576

DODGE DURANGO 2011 3.G Owners Manual CAUTION!
•Do not use abrasive or strong cleaning materials
such as steel wool or scouring powder, which will
scratch metal and painted surfaces.
•Use of power washers exceeding 1,200 psi
(8 274 kP