Page 7 of 396
CHECKS PRACTICAL
INFORMATIONTECHNICAL DATA AUDIO AND
TELEMATICS
231 Bonnet
232 Running out of fuel (Diesel)
233 Petrol engines
234 Diesel engines
235 Checking levels
238 Checks244 Temporary puncture repair
kit
249 Changing a wheel
256 Changing a bulb
263 Changing a fuse
269 Battery
272 Energy economy mode
273 Changing a wiper blade
273 Very cold climate screen
274 Towing the vehicle
276 Towing a trailer
278 Accessories282 Petrol engines
283 Petrol weights
284 Diesel engines
285 Diesel weights
286 Dimensions
287 Identifi cation markings291 Emergency or assistance
293 eMyWay
345 Audio system
012012013013010010011011
Page 16 of 396
Instruments and controls
1.
Cruise control/speed limiter controls.
2.
Controls for optional functions.
3.
Steering wheel adjustment control.
4.
Lighting and direction indicator control
stalk.
5.
Instrument panel.
6.
Driver's airbag.
Horn.
7.
Controls for audio and telematic system.
8.
Controls for Bluetooth system or telephone.
9.
Bonnet release.
10.
Door mirror controls.
Electric window controls.
11.
Fusebox.
12 .
Manual headlamp height adjustment
Lower side switch panel.
13.
Fuel filler flap opening switch.
Upper side switch panel.
14 .
Side adjustable air vent.
15.
Front side window demisting vent.
Page 219 of 396
217Driving
No aler t will be given in the following situations:
- in the presence of stationary objects
(parked vehicles, barriers, street lamps,
road signs...),
- with vehicles moving in the opposite
direction,
- driving on a sinuous road or a sharp corner, The aler t is given by a warning lamp which
comes on in the door mirror on the side in
question as soon as a vehicle - car, lorry,
cycle - is detected and the following conditions
are fulfilled:
- all the vehicles must be moving in the same
direction,
- the speed of your vehicle is between 7 and
75 mph (12 and 140 km/h),
- the difference in speed between your
vehicle and the other vehicles must be less
than 6 mph (10 km/h),
- the traffic must be flowing normally,
- in the case of an over taking manoeuvre,
if this is prolonged and the vehicle being
over taken remains in the blind spot,
- you are driving on a straight or slightly
cur ved road,
- your vehicle is not pulling a trailer,
a caravan...
- when over taking (or being over taken by) a
very long vehicle (lorry, coach...) which is
at the same time detected at the rear in the
blind spot angle and present in the driver's
for ward field of vision,
- in very heavy traffic: vehicles detected in
front and behind are confused with a lorry
or a stationary object,
- when overtaking quickly.
Page 235 of 396
233Checks
Petrol engines
The various caps and covers allow access for
checking the levels of the various fluids and for
replacing cer tain components.
1.
Power steering reservoir.
2.
Screenwash and headlamp wash reser voir.
3.
Coolant reser voir.
4.
Brake fluid reser voir.
5.
Battery/Fuses.
6.
Fusebox.
7.
Air filter.
8.
Engine oil dipstick.
9.
Engine oil filler cap.
Page 236 of 396
Diesel engines
The various caps and covers allow access for
checking the levels of the various fluids, for
replacing cer tain components and for priming
the fuel system.
1.
Power steering reservoir.
2.
Screenwash and headlamp wash reser voir.
3.
Coolant reser voir.
4.
Brake fluid reser voir.
5.
Battery/Fuses.
6.
Fusebox.
7.
Air filter.
8.
Engine oil dipstick.
9.
Engine oil filler cap.
10.
Priming pump * .
11.
Bleed screw * .
*
According to engine.
Page 265 of 396
263Practical information
Changing a fuse
The extraction tweezer is fitted to the back of
the dashboard fusebox cover.
For access to it:
)
unclip the cover by pulling at the top right,
then left,
)
disengage the cover completely and turn it
over,
Access to the tools
)
remove carrier on which the tweezer is
fitted.
Changing foglamp bulbs
These bulbs are replaced from outside the rear bumper:
)
pass your hand under the bumper,
)
turn the bulb holder a quar ter turn and
remove it,
)
turn the bulb a quar ter turn, pull it out and
fit a new bulb.
For reassembly, carry out these operations in
reverse order.
Take care not to touch the silencer;
there is a risk of burns if changing a
bulb within a few minutes of switching
off the ignition.
Page 266 of 396
Installing electrical
accessories
Your vehicle's electrical system is
designed to operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a CITROËN dealer or a
qualified workshop.
CITROËN will not accept responsibility
for the cost incurred in repairing your
vehicle or for rectifying malfunctions
resulting from the installation of
accessories not supplied and not
recommended by CITROËN and
not installed in accordance with its
instructions, in par ticular when the
combined consumption of all of the
additional equipment connected
exceeds 10 milliamperes.
Before changing a fuse:
)
the cause of the failure must be identified
and rectified,
)
all electrical consumers must b switched off,
)
the vehicle must be immobilised with the
ignition off,
)
identify the failed fuse using the tables and
layout drawings in the following pages.
Changing a fuse
Good
Failed
The replacement of a fuse not shown in
the tables below may cause a serious
malfunction of your vehicle. Contact
a CITROËN dealer or a qualified
workshop.
Tw e e z e r
To replace a fuse, you must:
)
use the special tweezer to extract the fuse
from its housing and check the condition of
its filament,
)
always replace the failed fuse with a fuse
of the same rating (same colour); using a
different rating could cause faults (risk
of fire).
If the fuse fails again soon after replacement,
have the vehicle's electrical system checked by
a CITROËN dealer or a qualified workshop.
Page 267 of 396
265Practical information
Dashboard fuses
The fuseboxes are located in the lower
dashboard (left-hand side).
Access to the fuses
)
Refer to the paragraph "Access to the
tools".
