2011 Citroen DS3 clutch

Driving safely


Stop & Start


Going into engine STOP mode




166

The "ECO"
warning lamp comes on
in the instrument panel and the engine
automatically goes into standby:


- with a manual gearbox:
at speeds below
12 mph (20 km/h), when you put the gear
lever in neutral, and you release the clutch
pedal.


Going into engine START mode

Deactivation/Reactivation

You can deactivate the system at any time by
pressing the "ECO OFF"
button; the button's
warning lamp comes on.



167





167


The system is automatically reactivated
every time the engine is star ted with
the key.
Before refuelling or doing anything
under the bonnet, you must switch off
the ignition with the key. The "ECO"
warning lamp goes off
and the engine restarts automatically:


- with a manual gearbox:
when you fully

depress the clutch pedal.
In certain circumstances, the STOP mode
may not be available; the "ECO"
warning lamp
flashes for a few seconds, then goes off. In certain circumstances, START mode may be
invoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off.

33Monitoring






Foot on the
brake pedal


fixed. The brake pedal must be pressed. With the SensoDrive gearbox, press the brake pedal
to star t the engine (lever in position N
).
With an automatic gearbox, with the engine running,
press the brake pedal before releasing the parking
brake, to unlock the lever and come out of position P
.
If you wish to release the parking brake without
pressing the brake pedal, this warning lamp will
remain on.

flashing. With a SensoDrive gearbox, if you
hold the vehicle on an incline using
the accelerator for too long, the clutch
overheats. Use the brake pedal and/or the parking brake.






Automatic wiping


fixed. The wiper control is pushed
downwards. Automatic front wiping is activated.






Passenger's
airbag system
fixed. The control switch, located in the
glove box, is in the " ON
" position.
The passenger's front airbag is
activated.
In this case, do not install a rear-
facing child seat. Turn the control switch to the " OFF
" position to
deactivate the front passenger's airbag.
In this case you can install a rear-facing child seat.

Warning lamp



is on



Cause



Action/Observations

157Driving








6-speed manual gearbox



)
Move the lever fully to the right to engage
5 th or 6 th gear.



Engaging 5 th or 6 th gear

As a safety precaution and to facilitate
star ting of the engine:


- always select neutral,

- press the clutch pedal.
Only engage reverse gear when the
vehicle is stationary with the engine at idle.

Engaging reverse gear



)
Raise the ring under the knob and move
the gear lever to the left then for wards.

Stop & Start
The Stop & Start system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, etc...). The engine
restarts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Start system reduces fuel consumption and exhaust emissions as well as offering the comfort of silence when
stationary.

Operation


Going into engine STOP mode

For your comfort when parking, STOP
mode is not available for a few seconds
after coming out of reverse gear.
STOP mode does not affect the
functionality of the vehicle, such as
braking, power steering, for example.
Never refuel with the engine in STOP
mode; you must switch off the ignition
with the key. The "ECO"
warning lamp comes
on in the instrument panel and the
engine goes into standby:


- with a manual gearbox
, at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral, and you release the
clutch pedal,
A time counter calculates the sum
of the periods in STOP mode
during a journey. It rests itself
to zero every time the ignition is
switched on with the key. STOP mode is not invoked when:


- the driver's door is open,

- the driver's seat belt is not fastened,

- the vehicle has not exceeded 6 mph
(10 km/h) since the last engine star t using
the key,

- the engine is needed to maintain a
comfor table temperature in the passenger
compartment,

- demisting is active,

- some special conditions (battery charge,
engine temperature, braking assistance,
ambient temperature...) where the engine is
needed to assure control of a system.


Special cases: STOP mode
unavailable
The "ECO"
warning lamp flashes for
a few seconds, then goes off.

This operation is per fectly normal.

167Driving

Going into engine START mode

The "ECO"
warning lamp goes off
and the engine star ts:


- with a manual gearbox
, when you fully

depress the clutch pedal.


Special cases: START invoked
automatically
If the system has been deactivated
in STOP mode, the engine restarts
immediately. At any time, press the "ECO OFF"
switch to
deactivate the system.
This is confirmed by the switch warning lamp
coming on accompanied by a message in the
screen.

Deactivation

For your safety and comfort, START mode is
invoked automatically when:


- you open the driver's door ,

- you unfasten the driver's seat belt,

- the speed of the vehicle exceeds 15 mph
(25 km/h) with a manual gearbox,

- some special conditions (battery charge,
engine temperature, braking assistance,
ambient temperature...) where the engine is
needed to assure control of a system.
The "ECO"
warning lamp flashes, then
goes off.

This operation is per fectly normal.


With a manual gearbox in STOP mode,
if a gear is engaged without fully
depressing the clutch pedal, a message
is displayed asking you to depress the
clutch pedal to restar t the engine.

171Driving





Cruise control

System which automatically maintains the
speed of the vehicle at the value programmed
by the driver, without any action on the
accelerator pedal.
The cruise control is switched on
manually: it
requires a minimum vehicle speed of 25 mph
(40 km/h), as well as the engagement of:


- four th gear on a manual gearbox,

- second gear on a SensoDrive or automatic
gearbox, in sequential mode,

- position A
on a SensoDrive gearbox or
position D
on an automatic gearbox.
The cruise control is switched off
manually
or by pressing the brake or clutch pedal or
on triggering of the ESP system for safety
reasons.
It is possible to exceed the programmed speed
temporarily by pressing the accelerator pedal.
To return to the programmed speed, simply
release the accelerator pedal.
Switching off the ignition cancels any
programmed speed value. The controls of this system are grouped
together on stalk A
.


1.
Cruise control mode selection thumb
wheel.

2.
Value decrease button.

3.
Value increase button.

4.
Cruise control off/resume button.


Steering mounted controls

The cruise control cannot, in any circumstances,
replace the need to respect speed limits,
nor can it replace the need for vigilance and
responsibility on the par t of the driver.
The programmed information is grouped
together in the instrument panel screen.

5.
Cruise control off/resume indication.

6.
Cruise control mode selection indication.

7.
Programmed speed value.

Displays in the instrument panel

211Practical information

Dashboard fusebox

The fusebox is located in the lower dashboard
(left-hand side).

Access to the fuses



)
Refer to the paragraph "Access to the tools".



Fuse tables



Fuse N°



Rating


Functions



FH36



5 A

Trailer relay unit.


FH37



-

Not used.


FH38



20 A

Hi-Fi amplifier.


FH39



20 A

Heated seats.


FH40



40 A

Trailer relay unit.



Fuse N°



Rating


Functions



F1



15 A

Rear wiper.


F2



-

Not used.


F3



5 A

Airbags and pretensioners control unit.


F4



10 A

Air conditioning, clutch switch, electrochromatic mirror,
par ticle filter pump (Diesel), diagnostic socket, air flow
sensor (Diesel).


F5



30 A

Electric windows panel, passenger's electric window control,
front electric window motor.


F6



30 A

Driver's electric window motor.


F7



5 A

Cour tesy lamp, glove box lighting.