Page 111 of 164
8
Practical information
109
Access to the fuses
)Open the bonnet (refer to the "Checks" section), )Unclip the cover and remove it completely
by pulling towards you. )Change the fuse (refer to the corresponding paragraph). )When you have finished, close the cover carefully to ensure sealing of the fusebox.
Fuse N°RatingFunctions
1110 A On-board charger.
12 10 A
Dir
ection indicator.
1
310 A
Horn.
1410 A Daytime running lamps.
1515 A
Battery fan.
1610 A
Air conditioning compressor.
1720 A
Right hand dipped beam.
1820 A
Left hand dipped beam, headlamp adjusters.
1
910 A Right hand main beam.
20 10 A
Left hand main beam.
Page 112 of 164
i !
!
Practical information
110
Towing the vehicle
Procedure for having your vehicle towed using fixed mechanical equipment.
To w i ng your vehicle
The towing eye is welded to the body below
the front bumper. ) Install the towing bar. )
Start your vehicle ("Ready" lamp on). )
Put the drive selector in position N . )
Release the parking brake. )
Switch on the hazard warning lamps onyour vehicle. )
Have your vehicle towed for no more than 20 miles (30 km) without exceeding a speed of 20 mph (30 km/h)
.
When towing the vehicle with the four wheels on the ground, always use a towing bar.
When towing with only two wheels onthe ground, use professional lifting equipment.
Failure to follow these instructions may cause damage to braking components and the electric motor.
Changing
a wiper blade
Removing a front or rear
wiper blade
)Raise the corresponding wiper arm. )Remove the wiper blade, sliding it towards
the outside.
Fitting a front or rear wiper
blade
)Put the new wiper blade in place and
secure it. )Fold down the wiper arm carefully.
To w i ng another vehicle
Your vehicle cannot be used in any circumstances to tow another vehicle.
Page 114 of 164
i
!i
Practical information
112
"Protection":
front and rear mudflaps, vehicle cover,
translucent bumper protectors, side rubbing strips...
"Multimedia":
audio systems, speed camera warning,
universal solar charger...
The fitting of electrical equipment or accessories which are not recommended by CITROËN may result
in a failure of your vehicle's electronicsystem and excessive electricalconsumption. Please note this precaution. You are advised to contact a CITROËNrepresentative to be shown the range of recommended equipment and accessories.
Installation of radiocommunicationtransmitters
Before installing any after-market radio communication transmitter, you cancontact a CITROËN dealer for thespecification of transmitters which canbe fitted (frequency, maximum power,aerial position, specific installation requirements), in line with the VehicleElectromagnetic Compatibility Directive(2004/104/EC).
Depending on the legislation in forcein the country, it may be compulsory to have a high visibility safety vest, warning triangle and spare bulbs andfuses available in the vehicle.
Page 119 of 164
9
!
Checks
117
Checking levels Check all of these levels regularly and top them up if necessary, unless other wise indicated.
If a level drops significantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.
Never do anything in the compar tmentswhen the "Ready" lamp is on or whenyour vehicle is being charged. Take care when carrying out checks in the front and rear compartments assome parts of the compartments canbe very hot (risk of burns): wait at leastone hour after stopping the motor or the end of the charging procedure beforecarrying out any work.
Brake fluid level
The brake fluid level should be
between the "MIN" and "MA X"
marks. If it is not, check the brakepad wear.
Changing the fl uid
Refer to the ser vicing booklet for details ofthe inter val for this operation.
Fluid specifi cation
The brake fluid must conform to the
manufacturer's recommendations and meetthe DOT4 standard.
Front compartment
Heatin
g system fluid level
Changing the fl uid
The fluid does not have to be changed.
Fluid specifi cation
The fluid must conform to the manufacturer's
recommendations. Th
e level of this fluid should be between the "L"MIN and "F" MA X marks.
Screenwash fluid level
Top up the level when necessary.
Fluid specifi cation
For optimum cleaning and to avoid freezing,
this fluid must not be topped up or replaced
with plain water.
Page 131 of 164
11
02
1
2
129
RADIO
Press SRC/TEL several times insuccession and select the FM1 or FM2radio band.
Press a button to listen to the corresponding preset station.
Select the desired radio station and confi rm by pressing "OK".
RADIO
Press LIST
to display the list of stations
received in alphabetical order.
The exterior environment
(hills, buildings, tunnel, car park, below ground...) may prevent reception, even in RDS station tracking mode. Thisphenomenon is normal in the propagation of radio waves and is in no way indicative of a fault with the audio system.
A long press on LIST
builds or updates
the list of stations; audio reception is cut
momentarily.
Make a lon
g press on one of the buttons
to preset the station being heard.
The name of the station is displayedaccompanied by an audible signal to confi rm the preset.
A press chan
ges to the next or previous
letter (e.g. A, B, D, F, G, J, K, ...). MANAGE THE LIST
PRESETTING AND SELECTING A STATION
Page 146 of 164
1
2
05
144
Press ‘to display the audio settings menu.
Press ‘to go to the next setting.
The settings available are:
- AMBIANCE: BASS
, TREBLE and Loudness.
-
SOUND DIST. (sound distribution): BALANCE(left/right balance), FADER (front/rear balance)
- A
uto. volume
The distribution, or spatialisation of sound, is an audio process
w
hich allows the sound quality to be improved according to the setting chosen, corresponding to the position of the listeners in
the vehicle.
AUDIO SETTINGS
The AMBIANCE, TREBLE and BASS audio settings are different
and independent for each sound source.
Page 148 of 164
07
146
SCREEN MENU MAP
1
2
2
2
2
1
2
2
2
1
2
2
2
2
3
3
1
2
2
4
4
4
1
2
3
2
3
3
3
3
3
3
3
2
2
3
3
3
MENU
Radi
o
TA
RD
S
TXT
Write freq.
Media
Normal
Random
Random all
Telephone
Call
Repeat
TA
Phone status
Directory
Calls list
Bluetooth
BT mana
gement
Search
Missed calls
Dialed calls
An
swered calls
Confi g.
Displaying
Scrollin
g text
Language
D
eutsch
En
glish
Español
Français
It
aliano
Nederlands
Português
Version
System Portu
guês-Brasil
Р
усский
T
ürkçe
Page 153 of 164
.
Visual search
151
Exterior
Remote control key 31- 32- opening/closing - central locking - anti-theft protection Starting - Stopping the vehicle 52
Lighting 56-58 Headlamp height adjustment 58 Changing bulbs 97-102- front lamps - foglamps- daytime running lamps - direction indicator repeaters
Wipers 59Changing a wiper blade 110
Door mirrors 42
Doors 35 - opening/closing Electric windows 34
Charging flaps 37 Charging the main battery 80-85- normal - fast
Accessories 111
ABS, EBFD, ASR, ESP 70 -72Tyre pressures 123Changing a wheel 94-96
Boot 36- opening/closing
Changing bulbs 102-104- rear lamps - 3rd brake lamp- number plate lamps - foglamp
To w i ng 11 0
