2011 Alfa Romeo MiTo tyre pressure

IN AN EMERGENCY173
4
“Fix&Go Automatic” KIT
This is located in the luggage compartment. The Kit container al-
so contains a screwdriver and the ring. The kit includes:
❍a cylinder A-fig. 13 containing sealing fluid and fitted with: a
filling pipe B and adhesive label C with the words“max. 80
km/h”, to be attached in a position easily visible to the dri-
ver (on the dashboard) after tyre repair;
❍a compressor D complete with pressure gauge and connectors;
❍an information booklet fig. 14, providing instructions for us-
ing the kit correctly. This booklet should be given to the per-
sons charged with handling the tyre treated with this kit;
❍a pair of gloves located in the side compartment of the com-
pressor;
❍adapters for inflating different elements.IMPORTANT The sealing fluid is effective with external tempera-
tures between –20 °C and +50 °C. The sealing fluid also has an
expiry date.
fig. 13A0J0112mfig. 14A0J0113m
Hand over the instruction booklet to the personnel
charged with treating the tyre repaired with the
Fix&Go Automatic kit.
In the event of a puncture caused by foreign bod-
ies, the kit may be used to repair tyres showing
damage to the track or shoulder up to a maximum
diameter of 4 mm.

IN AN EMERGENCY175
4
INFLATION PROCEDURE
fig. 16A0J0214m
Wear the gloves provided in the kit.
Proceed as follows:
❍Make sure the handbrake is on, unscrew the tyre valve cap,
take out the flexible filling pipe, B-fig. 16 and screw down
the ring nut C on the tyre valve;
❍make sure that switch A-fig. 17 on the compressor is in posi-
tion 0 (off), start the motor, insert pin A-fig. 18 into the cur-
rent socket/cigar lighter on the central tunnel and switch on
the compressor by placing switch A-fig. 17 in position I (on);
❍inflate the tyre to the pressure shown in the paragraph entitled
“Wheels” in chapter 6. In order to obtain a precise reading,
check the pressure on pressure gauge B-fig. 17 with the com-
pressor off;
fig. 17A0J0114m

176IN AN EMERGENCY
❍if a pressure value of a least 1.8 bars is not reached within 5
minutes, disconnect the compressor from the valve and current
socket, move the vehicle forwards by about 10 metres to dis-
tribute the sealant fluid in the tyre and repeat the inflation
procedure;
fig. 18A0J0116m
❍if a pressure value of a least 1.8 bars is not reached within 5
minutes of switching on the compressor, do not continue dri-
ving. Contact an Alfa Romeo Authorised Services;
❍after having driven for about 10 minutes, stop the car and check
the tyre pressure once more: remember to engage the hand-
brake;
❍if a pressure value of at least 1.8 bars is detected, restore the
correct pressure (with the engine running and the handbrake
engaged), and drive with care to an Alfa Romeo Authorised
Services.
Apply the adhesive label where it can be easily
seen by the driver as a reminder that the tyre has
been treated with the quick repair kit. Drive care-
fully, particularly on bends. Do not exceed 80 km/h. Do
not accelerate or brake suddenly.If the pressure has fallen below 1.8 bar, do not
drive any further: the Fix & Go automatic quick
tyre repair kit cannot guarantee proper hold be-
cause the tyre is too damaged. Contact an Alfa Romeo
Authorised Services.
Remember to inform the workshop that the tyre
has been treated with a quick repair kit. Give the
instruction booklet to the personnel charged with
handling the treated tyre.

IN AN EMERGENCY177
4
fig. 19A0J0225m
A
CHECKING AND RESTORING TYRE PRESSURE
The compressor can also be used to check and if necessary top
up the tyre pressure. Release quick coupling A-fig. 19 and con-
nect it directly to the tyre to be inflated.
REPLACING THE CYLINDER
Proceed as follows:
❍release coupling A-fig. 20 and disconnect pipe B;
❍turn the cylinder to be replaced anticlockwise and raise it;
❍fit the new cylinder and turn it clockwise;
❍insert coupling A or connect pipe B into its housing.
fig. 20A0J0115m

41
41
41
43
41
41
41
41
43
43
4315
20
15
7.5
30
7.5
30
15
5
10
5F08
F09
F10
F13
F15
F19
F20
F21
F31
F36
F37
IN AN EMERGENCY193
4
CONSUMERS FUSE AMPERE FIGURE
Heated windscreen
Headlight washer pump
Two-tone horn
Headlight alignment adjustment system
Additional heater (PTC 1)
“Dynamic Suspension” control system
Air conditioning compressor
Heated rear windscreen, demisting system
Fuel pump on tank
INT/A key exhaust relay coils
on engine fuse box
Radio, Blue&Me
TMcontrol unit, Climate control unit,
Alarm control unit, Volume sensing system control unit,
EOBD external diagnostic socket,
Tyre pressure detection control unit
Instrument panel, Brake light switch,
Gas discharge headlights management system

F38
F43
F47
F48
F4915
20
20
20
543
43
43
43
43
194IN AN EMERGENCY
CONSUMERS FUSE AMPERE FIGURE
Door lock motor on door,
Safe Lock motor on doors,
Tailgate unlocking motor
Windscreen / rearscreen washer pump
Electric window motor complete with
control unit (driver-side door)
Electric window motor complete with
control unit (passenger-side door)
Parking sensors control unit, Tyre pressure
detection control unit, Rain/dusk sensor
on rear-view mirror, Electro-chrome sensor
on rear-view mirror, Seat belts fastened
warning light display on rear-view mirror,
Control panel illumination (Central control
panel, Driver-side control panel, Steering wheel
control panel, Blue&Me
TMcontrol panel),
Front seat heating pad activation switch,
Alarm system volume-sensing sensors control unit,
Electric sunroof control unit,
PND socket on dashboard

202CARE AND MAINTENANCE
SCHEDULED MAINTENANCE
Correct maintenance is essential for ensuring long car life under the
best conditions.
Alfa Romeo has prepared a series of checks and service opera-
tions to be carried out every 30,000 kilometres (for petrol ver-
sions) or every 35,000 kilometres (for diesel versions).
In between these services it is still necessary to adhere to the in-
structions in the Scheduled Service Plan (e.g. regularly check the
fluid levels and tyre pressure etc.).
Scheduled Service operations should be carried out at an
Alfa Romeo Authorised Service Provider according to a set time
schedule. If, during each operation, in addition to the ones pro-
grammed, the need arises for further replacements or repairs, these
may be carried out only with the explicit agreement of the Cus-
tomer.
If your car is used frequently for towing, the interval between one
service operation and the next should be reduced.IMPORTANT NOTES❍At 2000 km from the next service operation the display will
show a message.
❍Scheduled Service operations are required by the manufactur-
er. Failure to carry them out may invalidate the warranty.
❍It is advisable to inform your Alfa Romeo Authorised Service
Provider of any small faults without waiting for the next sched-
uled service.

CARE AND MAINTENANCE203
5
SCHEDULED SERVICING PLAN
PETROL VERSIONS
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights, passenger
compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses (exhaust - fuel - brakes),
rubber parts (gaiters, sleeves, bushes, etc.)
Check cleanliness of locks, bonnet and boot, and
cleanliness and lubrication of linkages
Check and top up, if required, fluid levels
(engine coolant, brake/hydraulic clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever travel and adjust it, if necessary
Check timing belt condition
Visually inspect condition of auxiliary drive belt/s
Check tension and adjust auxiliary drive belt (versions with heater system)30 60 90 120 150 180
●●● ●●●
●●● ●●●
●●● ●●●
●●● ●●●
●●● ●●●
●●● ●●●
●●● ●●●
●●● ●●●
●●● ●●●
●●● ●●●
●●
●●
●●