Page 9 of 324
8Quick Reference Guide
Instrument Panel
P.63
Lights On IndicatorHigh Beam IndicatorFog Light Indicator
Temperature
Gauge
Fuel Gauge Speedometer
Tachometer
Low Fuel
Indicator
Security System Alarm Indicator Multi-Information Display
Shift Lever Position Indicator
*
Gear Position Indicator
*
Gauges
P.75
Multi-Information Display
P.76
System Indicators
P.64
Lights Reminders
System IndicatorsSystem Indicators
VSA
® OFF Indicator
Turn Signal and
Hazard Warning
IndicatorsElectric Power
Steering (EPS)
IndicatorMalfunction
Indicator LampLow Oil Pressure
IndicatorCharging System
IndicatorAnti-lock Brake
System (ABS)
IndicatorVehicle Stability
Assist (VSA
®) System
Indicator
Seat Belt Reminder
IndicatorImmobilizer System
IndicatorSupplemental
Restraint System
IndicatorLow Tire Pressure/
TPMS IndicatorDoor and Trunk
Open IndicatorCruise Main IndicatorCruise Control
IndicatorSystem Message
Indicator Parking Brake
and Brake System
Indicator
U. S.Canada
Side Airbag Off
Indicator
U. S.Canada
Page 10 of 324
9Quick Reference Guide
Right
Low BeamHigh Beam
LeftFlashingAdjustment Ring
: Low speed: High speed
Pull toward
you to spray
washer fluid.
MIST
OFF
INT
LO
HI Turn Signal Control Lever Light Control Switches Wiper/ Washer Control Lever
Controls
P.87
Turn Signals
P.105
Lights
P.105
Wipers and Washers
P.108
* Not available on all models
Page 70 of 324
69Instrument Panel
Indicators
Continued
Indicator Name On/Blinking Explanation Message
System Message
Indicator t $ P N F T P O B M P O H X J U I B C F F Q X I F O
a problem is detected. A system
message on the multi-information
display appears at the same time. t 8 I J M F U I F J O E J D B U P S J T P O
Q S F T T U I F
(information) button to see
the message again.
t 3 F G F S U P U I F * O E J D B U P S T J O G P S N B U J P O J O
this chapter when a system message
appears on the multi-information
display. Take the appropriate action
for the message.
t 5 I F N V M U J J O G P S N B U J P O E J T Q M B Z E P F T
not return to the normal screen
unless the warning is canceled, or the button is pressed.
—
Turn Signal
Indicators t 5 I F U V S O T J H O B M J O E J D B U P S T C M J O L
when you operate the turn signal
lever.
t * G Z P V Q S F T T U I F I B [ B S E X B S O J O H
button, both indicators and all turn
signals blink at the same time. t Does not blink or blinks rapidly-
A turn signal light bulb has blown.
Change the bulb immediately.
Replacing Light Bulbs P.252, 253
—
High-Beam
Indicator t $ P N F T P O X I F O U I F I J H I C F B N
headlights are on.
t $ P N F T P O X J U I S F E V D F E C S J H I U O F T T
when DRL (daytime running lights)
are on.—
—
Lights On
Indicator t $ P N F T P O X I F O F W F S U I F M J H I U
switch is on, or in AUTO when the
exterior lights are on. t * G Z P V S F N P W F U I F L F Z G S P N U I F
ignition switch while the light is on, a
chime sounds when the driver's door
is opened.
—
Page 106 of 324
105
Continued
Controls
Operating the Switches Around the Steering Wheel
Turn Signals
Light Switches
Turn Signals
The turn signals can be used when the
ignition switch is in ON
II
.
Rotating the light switch turns the lights on
and off, regardless of the position of the
ignition switch.
High beams
Push the lever forward until you hear a click. Low beams
When in high beams, pull the lever back to
return to low beams. Flashing the high beams
Pull the lever back, and release it.
Manual Operation
Light Switches
If you remove the key from the ignition switch while
the light is on, a chime sounds when the driver’s
door is opened.
When the lights are on, the lights on indicator in
the instrument panel will be on.
Indicators
P. 6 4
Repeatedly turning the headlights on and off
reduces the life of the HID headlight bulbs.
If you sense that the level of the headlights is
abnormal, have the vehicle inspected by a dealer.
Do not leave the lights on when the engine is off
because it will cause the battery to discharge.
Light Switches
Right Turn
Left Turn
High Beams
Low BeamsFlashing the
high beams
Turns on side marker, tail and
license plate lights Turns on headlights, parking,
side marker, tail, and license
plate lights
Page 108 of 324
Operating the Switches Around the Steering Wheel
Fog Lights
107
Controls
Fog Lights
When the low beam headlights are on, turn
the fog light switch on to use the fog lights.
Fog Lights
When the fog lights are on, the indicator in the
instrument panel will be on.
They go off when the headlights turn off, or when
the daytime running lights are on.
Indicators
P. 6 4
Daytime Running LightsThe high beam headlights and indicator come on slightly dimmer than normal.
The ignition switch is in ON t
II
.
The headlight switch is off, or in t
.
The parking brake is released. t
The lights remain on even if you set the parking brake. Turning off the ignition
switch will turn off the daytime running lights.
The high beam headlights return to the original brightness once the headlight
switch is turned on.
Fog Light Switch
Page 248 of 324
247
Replacing Light Bulbs
Continued
Maintenance
When replacing, use the following bulbs.
High beam headlight: 60W (HB3)
Low beam headlight: 55W (H1 for halogen bulb Type)
35W (D2S for high voltage discharge type)
High Beam Headlight
6-cylinder models 1. Remove all the engine compartment
covers.
Engine Compartment Covers
P. 2 3 3
Passenger side
All models 2. Remove the engine coolant reservoir.
Headlight Bulbs NOTICE Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to overheat and shatter.
The headlight aim is set by the factory, and typically
does not need to be adjusted. However, if you
regularly carry heavy items in the trunk or tow a
trailer, have the aiming readjusted at a dealer or by
a qualified technician.
The HB3 and H1 types are halogen bulbs.
When replacing a bulb, handle it by its base, and
protect the glass from contact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
Headlight Bulbs
Engine Coolant
ReservoirEngine Coolant
Reservoir
6-cylinder models 4-cylinder models
Page 251 of 324
Replacing Light Bulbs
Headlight Bulbs
250Maintenance
Low Beam Headlights
1. Turn the steering wheel all the way to the
opposite side from the headlight being
replaced.
Passenger side: Turn the steering wheel
to the left.
Driver side: Turn the steering wheel to
the right.
2. Remove the holding clips and screws, and
pull the inner fender back.
3. Rotate the cover to the left, and remove.
Low Beam Headlights
High voltage can remain in the circuit for a long period of time after the light is
switched off. Do not attempt to inspect or replace the high voltage discharge type
bulbs yourself. Ask a dealer to inspect and replace low beam headlights.
Low Beam Headlights
When removing the clip, insert a flat-tip screwdriver,
and lift and remove the central pin.
High Voltage Discharge Type Halogen Type
Inner Fender
Screw
Cover Clip
Page 252 of 324
Replacing Light Bulbs
Fog Light Bulbs
251
Continued
Maintenance
4. Unhook the hook, and pull out the
connector.
5. Remove the old bulb and insert the new
bulb.
6. Put the connector back into the headlight
assembly.
Low Beam Headlights
When mounting the clip, insert while keeping the
central pin of the clip raised, and push until the pin
is flat.
Push until the
pin is flat
Fog Light BulbsWhen replacing, use the following bulbs.
Fog Lights: 55W
1. Remove the clip using a flat-tip screwdriver,
and lower the under cover.
Fog Light Bulbs NOTICE Halogen bulbs get very hot when lit. Oil,
perspiration, or a scratch on the glass can cause the
bulb to overheat and shatter.
The fog lights are halogen bulbs.
When replacing a bulb, handle it by its plastic case,
and protect the glass from contact with your skin
or hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth. Hook
Connector Bulb
Clip
Under Cover
