2011 Acura TSX brake light

Towing a Trailer
Towing Preparation
188Driving
Towing Equipment and Accessories
Towing equipment varies by the size of your trailer, how much load you are
towing, and where you are towing.
Hitches
The hitch must be of an approved type and properly bolted to the underbody. Safety chains
Always use safety chains when you tow a trailer. Leave enough slack to allow the
trailer to turn corners easily, but do not allow the chains to drag on the ground. Trailer brakes
There are two common types of trailer brakes: surge and electric. Surge brakes
are common for boat trailers, since the brakes will get wet. If you choose electric
brakes, be sure they are electronically actuated. Do not attempt to attach trailer
brakes to your vehicle's hydraulic system, as it will lower braking effectiveness and
create a potential hazard. Additional towing equipment
Many states and provinces/territories require special outside mirrors when towing
a trailer. Even if mirrors are not required in your locale, you should install special
mirrors if visibility is restricted in any way. Trailer light
Trailer lights and equipment must comply with federal, state, province/territory,
and local regulations. Check with your local trailer sales or rental agency for the
requirements in the area where you plan to tow.
Towing Equipment and Accessories
Make sure that all equipment is properly installed
and maintained, and that it meets federal, state,
province/territory, and local regulations.
Consult your trailer sales or rental agency if any
other items are recommended or required for your
towing situation.
The lighting and wiring of trailers can vary by type
and brand. If a connector is required, it should only
be installed by a qualified technician.

Towing a Trailer
Driving Safely with a Trailer
189
Continued
Driving
Things You Need To Know Before Towing a TrailerHave the trailer properly serviced and keep it in good condition. t
Make sure that all the weights and load in the vehicle and trailer are within t
limits.
Towing Load Limits

P.1 8 7
Securely attach the hitch, safety chains, and other necessary parts to the trailer. t
Securely store all the items in and on the trailer so that they do not shift while t
driving.
Check if the lights and brakes on the trailer are working properly. t
Check the pressures of the trailer tires, including the spare. t Towing Speeds and GearsDrive slower than normal. t
Obey posted speed limits for vehicles with trailers. t
Automatic transmission models
Use the tD
position when towing a trailer on level roads.
Turning and BrakingTurn more slowly and with a wider turning arc than normal. t
Allow more time and distance for braking. t
Do not brake or turn suddenly. t
Driving Safely with a Trailer
Driving Safely with a Trailer
Parking
In addition to the normal precautions, place wheel
chocks at each of the trailer's tires.

191
Continued
Driving
When DrivingStarting the Engine
1. Make sure the parking brake is applied.
Starting the Engine
Keep your foot firmly on the brake pedal when
starting the engine.
The engine is harder to start in cold weather and
in thinner air found at altitudes above 8,000 feet
(2,400 meters).
When starting the engine in cold weather, turn off
all electrical accessories such as the lights, climate
control system, and rear defogger in order to reduce
battery drain.
If exhaust sounds abnormal or you can smell
exhaust gas inside the vehicle, have your vehicle
checked by a dealer. There may be a problem with
the engine or exhaust system.
Automatic transmission models 2. Check that the shift lever is in P
, then
depress the brake pedal.
Although it is possible to start the
vehicle in N
, it is safer to start it in P
.
Manual transmission models 2. Check that the shift lever is in N
. Then
depress the brake pedal with your right
foot, and the clutch pedal with your left
foot.
The clutch pedal must be fully depressed
to start the engine.
Brake Pedal
Brake Pedal Clutch Pedal

195
Continued
Driving
When Driving
Shifting
Change the shift position in accordance with your driving need.
Shift lever positions
Shifting
You cannot turn the ignition switch to LOCK
0 and
remove the key unless the shift lever is in
P.
The vehicle may move forward very slightly even in
N
while the engine is cold.
Depress the brake pedal firmly and, when necessary,
apply the parking brake.
Auomatic transmission models Shifting
Park
Used when parking or starting the
engine
Reverse
Used when backing up
Neutral
Used when idling
Drive
Used for:
Normal driving (gears change t
between 1st and 5th automatically)
Temporarily driving in the sequential t
mode
Drive (S)
Used for:
Automatically changing gears t
between 1st and 4th (4th gear is
used only at high speed)
Driving in the sequential mode t
P
R
N
D
S

196Driving
When Driving
Shifting
Shift Lever Operation
Shift Lever Operation NOTICE When you change the shift lever from
D
to
R and
vice versa, come to a complete stop and keep the
brake pedal depressed.
Operating the shift lever before the vehicle has
come to a complete standstill can damage the
transmission.
Use the shift lever position indicator to check the
lever position before pulling away.
Whichever position the shift lever is in when driving,
a blinking
D
indicator indicates a transmission
problem.
Avoid sudden acceleration and have the
transmission checked by a dealer as soon as
possible.
The fuel supply may be cut off if you drive at engine
speeds in or over the tachometer red zone (engine
speed limit). If this happens, you may experience a
slight jolt.
It may not be possible to operate the shift lever
if the brake pedal is applied while the shift lever
release button is held down.
Depress the brake pedal first.
Tachometer's red zone
Shift Lever Position Indicator
Depress the brake pedal and
press the shift lever release button to
shift.
Shift without pressing the shift lever
release button.
Press the shift lever release button
and shift.M (Sequential Shift mode) Indicator/
Gear Position Indicator

Braking
210Driving
Brake System
Parking Brake
Use the parking brake to keep the vehicle stationary when parking.
To a p p l y :
Pull the lever fully up without pressing the
release button.
To r e l e a s e :
1. Pull the lever slightly, and press and hold
the release button.
2. Lower the lever down all the way, then
release the button.
Parking Brake NOTICE Release the parking brake fully before driving. The
rear brakes and axle can be damaged if you drive
with the parking brake applied.If you start driving without fully releasing the
parking brake, a buzzer sounds as a warning, and
"RELEASE PARKING BRAKE" appears on the multi-
information display.
Always apply the parking brake when parking.
To prevent the parking brake from freezing when
the outside temperature is extremely cold, do not
apply it, but do the following: Automatic transmission models Put the shift lever in
P, then use a block or other
wheel chock to stop the wheels from turning.
Manual transmission models Put the shift lever in
R or
1, then use a block or
other wheel chock to stop the wheels from turning.

Braking
Brake System
211
Driving
Foot Brake
Your vehicle is equipped with disc brakes at all four wheels. A power assist helps
reduce the effort needed on the brake pedal. The brake assist system increases the
stopping force when you depress the brake pedal hard in an emergency situation.
The anti-lock brake system (ABS) helps you retain steering control when braking
very hard.
Brake Assist System

P. 2 13
ABS (Anti-lock Brake System)


P. 2 12
Foot Brake
Check the brakes after driving through deep water,
or if there is a buildup of road surface water. If
necessary, dry the brakes by lightly depressing the
pedal several times.
If you hear a continuous metallic friction sound
when applying the brakes, the brake pads need to
be replaced. Have the vehicle checked by a dealer.
Constantly using the brake pedal while going down
a long hill builds up heat, which reduces the brake
effectiveness. Apply engine braking by taking your
foot off the accelerator pedal and downshifting to
a lower gear. With manual transmission use a lower
gear for greater engine braking.
Do not rest your foot on the brake pedal while
driving, as it will lightly apply the brakes and cause
them to lose effectiveness over time and reduce pad
life. It will also confuse drivers behind you.

Braking
ABS (Anti-lock Brake System)
212Driving
ABS (Anti-lock Brake System)
ABS
Helps prevent the wheels from locking up, and helps you retain steering control by
pumping the brakes rapidly, much faster than you.
The electronic brake distribution (EBD) system, which is part of the ABS, also
balances the front-to-rear braking distribution according to vehicle loading.
You should never pump the brake pedal. Let the ABS work for you by always
keeping firm, steady pressure on the brake pedal. This is sometimes referred to as
"stomp and steer."
ABS (Anti-lock Brake System) NOTICE The ABS may not function correctly if you use an
incorrect tire type and size.
When the ABS indicator comes on while driving,
there may be a problem with the system.
While normal braking is not affected, there is a
possibility of the ABS not operating. Have the
vehicle checked by a dealer immediately.
The ABS does not reduce the time or distance it
takes to stop the vehicle. It only helps with steering
control during hard braking.
In the following cases, your vehicle may need more
stopping distance than a vehicle without ABS:
When driving on rough road surfaces, including twhen driving on uneven surfaces, such as gravel
or snow.
When tire chains are installed. tYou may hear a motor sound coming from the
engine compartment while system checks are being
performed immediately after starting the engine or
while driving. This is normal.
ABS operation
The brake pedal may pulsate slightly when the ABS is working. Keep holding the
pedal firmly down. On dry pavement, you will need to press on the brake pedal
very hard before the ABS activates. However, you may feel the ABS activate
immediately if you are trying to stop on snow or ice.
When the vehicle speed goes under 6 mph (10 km/h), the ABS stops.