Page 108 of 396
control, you can no longer unlock, lock or
locate your vehicle. )First of all, use the key in the lock to unlock
or lock your vehicle. )Then, reinitialise the remote control.
Fault with the remote
control
Reinitialisation
)Switch off the ignition and remove the ignition key. )Press the closed padlock immediately for a
few seconds. )Turn the key to position 2 (Ignition on). )Switch off the ignition and remove the keyfrom the ignition switch.
The remote control is fully operational again.
Changing the battery
Battery ref.: CR2032/3 volts.
)Unclip the cover using a small screwdriver at the two cutouts. )Lift off the cover. )Remove the flat battery from its location. )Fit the new battery into its location
observing the original direction of fitment. )Clip the cover onto the casing.
If the batter
y is flat, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.
If the problem persists, contact aCITROËN dealer as soon as possible.
Page 109 of 396
107
Access
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.
Lost keys
Visit a CITROËN dealer with the vehicle's registration document, your personalidentification documents and if possible the key code label.
The CITROËN dealer will be able to find the key code and the transponder code required to order a new key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from working and the remote control would have to be reinitialised.
The remote control does not operate when the key is in the ignition switch, even when the ignition is switched off, except for reinitialisation.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by theemergency ser vices more difficult in an emergency. As a safety precaution (with children on board), remove the key from the ignition switch when you leave the vehicle, even for a shor t time.
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this couldcause malfunctions.
When purchasing a second-hand vehicle
Have the pairing of all of the keys in your possession checked by a CITROËN dealer, to ensure that only your keys can be used to open and star t the vehicle.
Page 110 of 396
Locking
)Press this button to lock the vehicle.
The red indicator lamp in the button comes on.
Central locking control
This control allows the simultaneous locking or unlocking of the doors and boot from inside
th
e vehicle.
If one of the doors is open, centrallocking from the inside does not takeplace.
Unlocking
)
Press the button again to unlock
the vehicle.
The red indicator lamp in the button goes off.
When locking/deadlockingfrom the outside
When the vehicle is locked or deadlocked from the outside, the red warning lamp flashes and the button is inoperative. )With normal locking, pull the interior door control lever to unlock
the vehicle. )With deadlocking, you have to use the remote control or the keyto unlock the vehicle.
Page 114 of 396
Tr iggering of the alarm
This is indicated by sounding of the siren and
flashing of the direction indicators for
thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times insuccession. When the vehicle is unlocked using the remotecontrol, rapid flashing of the indicator lamp
in the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops
immediately.
Failure of the remote control
To deactivate the monitoring functions:
Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key
in the driver's door lock.
)
unlock the vehicle using the key in the
driver's door lock,
) open the door; the alarm is triggered, )
switch on the ignition; the alarm stops;the indicator lamp in the button goes off.
Operating fault
When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault with the s
ystem.
Have it checked by a CITROËN dealer or a qualified workshop.
Page 115 of 396
113Access
Doors
Opening
From outside
)After unlocking the vehicle completely
using the remote control or the key, pull thedoor handle.
From inside
)
Pull the interior control lever of a front door;
this unlocks the vehicle completely.
Closing
When a door is not closed correctly:
- when the en
gine is running,this warning lamp comes
on, accompanied by an aler t
message for a few seconds,
-when the vehicle is moving (speed higher than 6 mph (10 km/h)), this warning lamp comes on, accompanied by an alertmessage for a few seconds.
When the selective unlocking isactivated, the first press of the remotecontrol unlocking button permitsunlocking of the driver's door only.
With the selective unlocking activated:- opening the driver’s door unlocks the driver’s door only (if the vehiclehas not already been completely unlocked). - opening the passenger’s door unlocks the rest of the vehicle. The interior door controls donot operate when the vehicle is deadlocked.
Page 116 of 396
System allowing the doors to be locked and
unlocked manually in the event of a malfunction
of the central locking system or battery failure.
Emergency control
Locking the driver's door
)Inser t the key in the door lock, then turn it
to the rear.
You can also apply the procedure describedfor the passenger doors.
Unlocking the driver's door
)Inser t the key in the door lock, then turn it
to the front.
Locking the front and rear passenger doors
)
Open the doors. )
On the rear doors, check that the child lock
is not on (see Child Safety). ) Remove the black cap, located on the edge of the door, using the key. )
Insert the key in the socket without forcing
it, then without turning it, move the latch sideways towards the inside of the door. ) Remove the key and refit the cap. )
Close the doors and check that the vehicle
has locked correctly from the outside.
Unlocking the front and rear passenger doors
)Pull the interior door opening control.
Page 117 of 396
115
Access
Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Tailgate release
Unlocking
)
Fold back the rear seats to gain access to
the lock from inside the boot. ) Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )
Move the latch to the left.
)After unlocking the boot or the vehicle
using the remote control or the key, press
the openin
g control, then raise the tailgate.
Opening Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate
to fully close it.
-
when the engine is running,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,
- when the vehicle is moving
(speed above6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal andthe display of an aler t message for a fewseconds.
Locking after closing
If the fault persists after closing again, the boot
w
ill remain locked. If the tail
gate is not closed correctly:
Page 119 of 396
11 7Access
Safety anti-pinch
When the window rises and meets an obstacle,
it stops and par tially lowers again.
Reinitialisation
If a window does not rise automatically,its operation must be reinitialised: ) pull the control until the window stops, )
release the control and pull it again until
the window closes fully, ) continue to hold the control for
approximately one second after the
window has closed,
) press the control to lower the window
automatically to the low position, ) when the window has reached the low
position, press the control again for
approximately one second. The safety anti-pinch function is notoperational during these operations.
If the window cannot be closed(for example, in the presence of ice), once the window has lowered: )
press and hold the control until the window opens fully, )
then pull the control immediately and hold it until the window closes, )
continue to hold the control for approximately one second after thewindow has closed. The safety anti-pinch function is not operational during these operations.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
If an obstacle is encountered during operation of the electric windows,you must reverse the movement of the window. To do this, press the controlconcerned.
When the driver operates thepassenger's electric window control,they must ensure that nothing ispreventing the windows closing correctly.
The driver must ensure that the passengers use the electric windows correctly.
Be aware of children when operatingthe windows.
