2011.5 Citroen C5 RHD driver seat adjustment

8
FAMILIARISATION
INSTRUMENTS AND CONTROLS



1.
Electric windows/door mirrors/child safety controls.

2.
Storing driver’s seat and door mirror settings.

3.
Audio/telematic steering mounted controls.

4.
Horn.

5.
Steering mounted controls:


- Speed limiter

- Cruise control

6.
Driver’s airbag.

7.
Navigation controls for the audio/telematic and trip
computer systems.

8.
Driver’s air vent.

9.
Instrument panel.

10.
Driver’s air vent.

11 .
Stop & Start switch.

12.
Lighting/Direction indicators/Foglamp/Voice
recognition control stalk.

13.
Manual headlamp height adjustment.

14.
Steering wheel adjustment.

15.
Knee airbag.

16.
Locking/unlocking of doors and boot.

17.
Checks/Anti-intrusion alarm/Parking space sensor
controls.

18.
Ignition switch.

19.
Windscreen wiper/screenwash control stalk.

20.
Oddments tray or programmable heater controls.

21.
USB port.

11
FAMILIARISATION
SITTING COMFORTABLY



1.
Seat cushion height, angle and slide
adjustments.

2.
Adjustment of the backrest angle.

3.
Adjustment of top of backrest.

4.
Adjustment of lumbar support height
and level.

5.
Massage function.

6.
Heated seat control.


A.
Adjustment of the backrest angle.

B.
Adjustment of the seat height.

C.
Heated seat control.

D.
Longitudinal adjustment of seat.

E.
Adjustment of the backrest lumbar
support.


Storing settings

This function allows you to programme
and store the driver’s seat and the air
conditioning settings. The correct position
for the upper seat
belt anchorage places the belt across
the middle of the shoulder.


)
To adjust the seat belt for height,
compress the control and slide
it in
the desired direction.


Seat belt height adjustment

Front seats


Electrical adjustments

Manual adjustments



62



63




122




65

III
65
COMFORT












Storing driving positions

System which stores the settings of
the driver's seat and air conditioning.
Up to two positions can be stored
using the buttons on the side of the
driver's seat.
Storing a position

Using buttons M/1/2


)
Switch on the ignition.

)
Adjust your seat.

)
Press button M
, then press but-
ton 1
or 2
within four seconds.
An audible signal confi rms that the
settings have been stored.
Storing a new position cancels the
previous position.

Recalling a stored position

Ignition on or engine running


)
Briefl y press button 1
or 2
to re-
call the corresponding position.
An audible signal indicates the end
of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery.
For your safety, avoid storing a
driving position while driving.









REAR HEAD RESTRAINTS

The rear head restraints can be
removed and have two positions:


- high, position for use,

- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high posi-
tion, push the lug and pull it upwards.
To r efi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
Never drive with the head restraints
removed, they must be in place and
correctly adjusted.

III
68
COMFORT
As a safety precaution, these op-
erations must only be carried out
while the vehicle is stationary.









STEERING WHEEL ADJUSTMENT

The steering wheel can be adjusted
for height and reach to adapt the
driving position to the size of the
driver.

Adjustment



)
First, adjust the driver's seat to
the most suitable position.

)
When stationary
, pull the lever A

to unlock the steering wheel ad-
justment.

)
Adjust for height and reach.

)
Push the lever to lock the steering
wheel adjustment.
After locking, if you press fi rmly on
the steering wheel, a slight click may
be heard.






Automatic day/night model

In order to guarantee optimum visi-
bility during your manoeuvres, the
mirror lightens automatically when
reverse gear is engaged. By means of a sensor, which mea-
sures the light from the rear of the
vehicle, this system automatically
and progressively changes between
the day and night uses.
It has an anti-dazzle system which
darkens the mirror glass: this reduces
any driver discomfort caused by the
light beam of following vehicles, the
sun... In vehicles fi tted with electrochro-
matic door mirrors, the system has
an on/off button and an associated
warning lamp.

On


)
With the ignition on, press on
button 1
.
The warning lamp 2
comes on and the
mirror glass is in automatic mode.

Off


)
Press on button 1
.
The warning lamp 2
goes off and the
mirror glass remains in its lightest
defi nition.

V
91
VISIBILITY

Linked with the automatic
"Guide-me-home" lighting
The link with the automatic illumi-
nation of headlamps provides the
"guide-me-home" lighting with the
following additional options:


- selection of the duration of ligh-
ting for 15, 30 or 60 seconds in
the vehicle parameters on the in-
strument panel screen confi gu-
ration menu,

- automatic activation of "guide-
me-home" lighting when auto-
matic illumination of headlamps
is in operation.


Operating fault
In the event of a fault with the sun-
shine sensor, the lighting comes on
and a message appears in the instru-
ment panel screen, accompanied by
an audible signal.
Contact a CITROËN dealer or a
qualifi ed workshop.
In fog or snow, the sunshine sen-
sor may detect suffi cient light.
Therefore, the lighting will not
come on automatically.
Do not cover the sunshine sen-
sor, linked with the rain sensor and
located in the centre of the wind-
screen behind the rear view mirror;
the associated functions would no
longer operate.







MANUAL HEADLAMP
ADJUSTMENT
To avoid dazzling other road users,
the height of the halogen bulb head-
lamps must be adjusted according
to the load in the vehicle.

0.
1 or 2 people in the front seats.

-. 3 people.

1.
5 people.

-. Intermediate setting.

2.
5 people + maximum authorised
loads.

-. Intermediate setting.

3.
Driver + maximum authorised
loads.
Initial setting is position "0"
.












AUTOMATIC ADJUSTMENT
OF DIRECTIONAL
HEADLAMPS
Do not touch the xenon bulbs.
Contact a CITROËN dealer or a
qualifi ed workshop. If a fault occurs, this
warning lamp comes
on in the instrument
panel, accompanied by an audible signal and a
message in the instru-
ment panel screen.
The system then places your head-
lamps in the lowest position. To avoid causing a nuisance to other
road users, this system corrects
the height of the xenon headlamp
beams automatically and when sta-
tionary, depending on the load in the
vehicle.

VI
101
FITTINGS








MATS


Removing



)
Slide the seat back as far as
possible,

)
unclip the fi xings,

)
remove the fi xings, then the mat.



Refitting



)
Position the mat correctly,

)
clip the fi xings,

)
check that the mat is held is
place correctly.
To avoid any interference with the
pedals:


- only use mats which are suit-
able for the fi xings already
present in the vehicle. The use
of these fi xings is essential,

- never fi t more than 1 mat.
The use of a mat not approved by
CITROËN may obstruct access to
the pedals and hinder the cruise
control/speed limiter function.
Floor mats approved by CITROËN
are fi tted with a 3rd fi xing located in
the pedal area to avoid any risk of
interference with the pedals.














FRONT ARMREST

Comfort and storage system for the
driver and front passenger.

Adjustment

To optimise your driving position:


)
lift the control A
,

)
push the armrest forwards.
The armrest returns to its initial posi-
tion when you push it rearwards.
The front armrest includes a cup
holder and a USB port.
The USB port allows connection of
a portable device, such as a USB
memory stick, sending the audio
fi les to your audio system so that
they can be heard via the vehicle's
speakers.


)
Lift the armrest to access the cup
holder or the USB port.
Equipment available for the driver
and front passenger.

Cup-holder/USB port

VIII
123
SAFETY




The driver must ensure that passen-
gers use the seat belts correctly and
that they are all restrained securely
before setting off.
Wherever you are seated in the ve-
hicle, always fasten your seat belt,
even for short journeys.
Do not interchange the seat belt
buckles as they will not fulfi l their
role fully.
The seat belts are fi tted with an
inertia reel permitting automatic
adjustment of the length of the strap
to your size. The seat belt is stowed
automatically when not in use.
Before and after use, ensure that the
seat belt is reeled in correctly.
The lower part of the strap must be
positioned as low as possible on the
pelvis.
The upper part must be positioned
in the hollow of the shoulder.
The inertia reels are fi tted with an
automatic locking device which
comes into operation in the event
of a collision, emergency braking or
if the vehicle rolls over. You can re-
lease the device by pulling fi rmly on
the strap and releasing it so that it
reels in slightly. In order to be effective, a seat belt
must:


- be tightened as close to the body
as possible,

- be pulled in front of you with a
smooth movement, checking
that it does not twist,

-
be used to restrain only one person,

- not bear any trace of cuts or
fraying,

- not be converted or modifi ed to
avoid affecting its performance.
Recommendations for children
Use a suitable child seat if the pas-
senger is less than 12 years old or
shorter than one and a half metres.
Never use the same seat belt to se-
cure more than one person.
Never allow a child to travel on
your lap.
In accordance with current safety
regulations, for all repairs on your
vehicle, go to a qualifi ed workshop
with the skills and equipment need-
ed, which a CITROËN dealer is able
to provide.
Have your seat belts checked reg-
ularly by a CITROËN dealer or a
qualifi ed workshop, particularly if the
straps show signs of damage.
Clean the seat belt straps with soapy
water or a textile cleaning product,
sold by CITROËN dealers.
After folding or moving a seat or rear
bench seat, ensure that the seat belt
is positioned and reeled in correctly.
In the event of an impact

Depending on the nature and se-
riousness of the impact
, the pre-
tensioning device may be deployed
before and independently of the
airbags. Deployment of the preten-
sioners is accompanied by a slight
discharge of harmless smoke and
a noise, due to the activation of the
pyrotechnic cartridge incorporated
in the system.
In all cases, the airbag warning lamp
comes on.
Following an impact, have the seat
belts system checked, and if neces-
sary replaced, by a CITROËN dealer
or a qualifi ed workshop.

XI
194
PRACTICAL INFORMATION
FUSEBOX A

Table of fuses



Fuse N°



Rating



Function




G29



-

Not used


G30



5 A

Heated door mirrors


G31



5 A

Rain and sunshine sensor


G32



5 A

Seat belt not fastened warning lamps


G33



5 A

Electrochromatic rear view mirror


G34



20 A

Sunroof (saloon)


G35



5 A

Passenger door lighting - passenger door mirror adjustment


G36



30 A

Electric tailgate (tourer)


G37



20 A

Heated front seats


G38



30 A

Driver’s electric seat


G39



30 A

Passenger’s electric seat - HIFI amplifi er


G40



3 A

Trailer relay unit supply

FUSEBOX B



Fuse N°



Rating



Function




G36



15 A

6 speed automatic gearbox


5 A

4 speed automatic gearbox


G37



10 A

Daytime running lamps - Diagnostic socket


G38



3 A

ESP


G39



10 A

Hydraulic suspension


G40



3 A

STOP switch