2011.5 Citroen C4 PICASSO display
[x] Cancel search: displayPage 13 of 352
11
FAMILIARISATION
8.
Controls:
- Trip mileage recorder reset
button
- Lighting rheostat
9.
Warning lamps display (with the
MyWay or NaviDrive multifunction
screen)
10.
Electric parking brake
11 .
Instrument panel
12.
Hazard warning lamps
13.
Switch panels:
- Emergency or assistance
- Lane departure warning system
14.
ESP deactivation button
15.
Steering lock - Ignition switch
16.
Steering mounted controls for
multifunction screen
17.
Horn
1.
Controls:
- Lighting
- Direction indicators
- Front and rear foglamps
2.
Paddles for automatic gearbox or
6-speed electronic gearbox system
3.
Cruise control and speed limiter
(steering mounted controls)
4.
Direction indicator warning lamps
5.
Audio and telematics system
steering mounted controls
6.
Selector for automatic gearbox or
6-speed electronic gearbox system
7.
Controls:
- Windscreen wipe
- Screenwash
- Rear screen wipe
- Trip computer
INSTRUMENTS AND CONTROLS
18.
Optional function controls
(steering mounted controls)
19.
Fusebox access cover
20.
Controls:
- Fuel fi ller fl ap
- Front and rear parking sensors
- Stop & Start
- Volumetric alarm deactivation
- Headlamp adjustment
21.
Bonnet release
22.
Mirror controls
Page 20 of 352
18
FAMILIARISATION
Seat belts not fastened/
unfastened warning lamp
This warning lamp informs you
if the driver’s or front passen-
ger’s seat belt is not fastened
(depending on model), and if
the front passenger’s (depend-
ing on model) or the second-row
passengers’ seat belts are unfastened.
The illuminated positions represent
those whose seat belts are not fastened/
unfastened.
Once the function has been activated,
when starting the engine, the system
automatically locks the doors once you
reach approximately 6 mph (10 km/h).
This function can be deactivated by
pressing button A
for more than two
seconds.
Tyre under-inflation detection
This function warns you if a tyre is de-
fl ated or punctured.
This system does not absolve the driver
of the need to regularly check the tyre
pressures.
The service warning lamp comes
on, and a vehicle outline is dis-
played, accompanied by a mes-
sage and an audible signal.
Under-infl ation warning
The STOP
warning lamp comes
on, and a vehicle outline is dis-
played, accompanied by a mes-
sage and an audible signal.
Puncture
41
127
89
MONITORING
Automatic central locking
Instrument panel
with multifunction screen A or C
with the MyWay or NaviDrive
multifunction screen
1.
Instrument panel.
2.
Multifunction screen.
3.
Control buttons.
4.
Warning lamps display zone.
31
32
Manual central locking
You can use electrical central locking or
unlocking by pressing on button A
.
If one of the doors is open or is not
closed properly, central locking will not
work.
Page 27 of 352
25
FAMILIARISATION
166
Electric parking brake
Before leaving the vehicle, check
that the electric parking brake warn-
ing lamp P
(red) is on fi xed (not
fl ashing).
If you leave the vehicle with the en-
gine running, apply the parking brake
manually.
Never leave a child alone inside the
vehicle with the ignition on, as they
could release the parking brake.
Parking space sensor
You can activate this function by press-
ing button A
.
Once the space has been measured, the
system displays the following messages:
< 12 mph (20 km/h)
Parking possible
Parking diffi cult
Parking not advised
This device combines:
- automatic functions: Automatic ap-
plication when the engine stops and
automatic release on use of the ac-
celerator (automatic operation by
default);
- manual use: Manual application/
release of parking brake is possible
by operating control lever A
.
Hill start assist
To aid starting on a gradient, your ve-
hicle is equipped with a system which
keeps it immobilised for about 2 sec-
onds, the approximate time it takes to
move your foot from the brake pedal to
the accelerator pedal.
146
DRIVING
139
Do not drive if the parking brake
warning lamp and the P indicator on
the lever A
are on. When in automatic mode, it remains
possible to apply or release the parking
brake at any time:
)
To apply it, pull on the lever A
.
)
To release it, pull then release
lever A
.
Page 31 of 352
29
FAMILIARISATION
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
Optimise the use of your
gearbox
With a manual gearbox, move off
gently, change up without waiting and
drive by changing up quite soon. If
your vehicle has the system, the gear
effi ciency indicator invites you to
change up; it is displayed in the instru-
ment panel, follow its instructions.
With an automatic or electronic gear-
box, stay in Drive "D"
or Auto "A"
, ac-
cording to the type of gearbox, without
pressing the accelerator pedal heavily
or suddenly.
Drive smoothly
Maintain a safe distance between ve-
hicles, use engine braking rather than
the brake pedal, and press the accel-
erator progressively. These practices
contribute towards a reduction in fuel
consumption and CO
2 emissions and
also helps reduce the background traf-
fi c noise.
If your vehicle has cruise control, make
use of the system at speeds above
25 mph (40 km/h) when the traffi c is
fl owing well.
Control the use of your
electrical equipment
Before moving off, if the passenger
compartment is too warm, ventilate it
by opening the windows and air vents
before using the air conditioning.
Above 30 mph (50 km/h), close the
windows and leave the air vents
open.
Remember to make use of equipment
that can help keep the temperature
in the passenger compartment down
(sunroof and window blinds...).
Switch off the air conditioning, unless
it has automatic digital regulation, as
soon as the desired temperature is at-
tained.
Switch off the demisting and defrost-
ing controls, if not automatic.
Switch off the heated seat as soon as
possible.
ECO-DRIVING
Page 36 of 352
I
34
MONITORING
Warning lamp
is on
Cause
Action/Observations
Front
foglamps
fi xed. The front foglamps are
switched on. Turn the ring on the stalk rearwards twice
to switch off the front foglamps.
Rear
foglamps
fi xed. The rear foglamps are
switched on. Turn the ring on the stalk rearwards to
switch off the rear foglamps.
Diesel engine
pre-heating
fi xed. The ignition switch is at the
2nd position (ignition on).
Wait until the warning lamp has switched off before starting.
The duration for which the warning lamp is on is determined
by the climatic conditions.
Parking brake
fi xed. The parking brake is applied
or not properly released. Release the parking brake to switch off the
warning lamp, keeping your foot on the
brake pedal.
Observe the safety recommendations.
For further information on the parking
brake, refer to the "Driving" section.
fl ashing. The parking brake is not fully
applied or is released.
Parking
space
sensors
fi xed. The parking space sensors
function is active. Press the corresponding button
to deactivate it.
fl ashing. The system is measuring the
space. Once the measurement has been done,
the warning lamp comes on fi xed again.
Electric child
lock
temporarily. The electric child lock is
activated. Displayed for a few seconds after activating
the function and every time the ignition is
switched on.
For more information, refer to the "Child
safety" section.
Page 44 of 352
I
42
MONITORING
Service indicator
System which informs the driver
when the next service is due, in ac-
cordance with the manufacturer's
servicing schedule.
The point at which the service is due
is calculated from the last indicator
zero reset. It is determined by two
parameters:
- the distance travelled,
- the time elapsed since the last
service. 5 seconds after the ignition is switched
on, the spanner
goes
off
; the dis-
tance recorder resumes its normal
operation. The display then indicates
the total and trip distances.
Less than 1 000 km remain
before the next service is due
Example:
900 km remain before the
next service is due.
For 5 seconds after the ignition is
switched on, the display indicates:
Service overdue
For 5 seconds after the ignition is
switched on, the spanner fl ashes
to indicate that the service must be
carried out as soon as possible.
Example:
the service is overdue by
300 km.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is
switched on, the distance recorder
resumes its normal operation. The
spanner remains on
to indicate that
a service must be carried out soon. 5 seconds after the ignition is
switched on, the distance recorder
resumes its normal operation. The
spanner remains
on
.
More than 1 000 km remain
before the next service is due
For 5 seconds after the ignition is
switched on, the spanner symbol-
ising the service operations comes
on. The distance recorder display
line indicates the distance remaining
before the next service is due.
Example:
4 800 km remain before
the next service is due.
For 5 seconds after the ignition is
switched on, the display indicates:
The distance remaining may be
weighted by the time factor, depend-
ing on the driver's driving habits.
Therefore, the spanner may also
come on if you have exceeded the
two year service interval.
Page 45 of 352
I
43
MONITORING
Service indicator zero reset
Engine oil level indicator
After each service, the service indi-
cator must be reset to zero.
The procedure for resetting to zero
is as follows:
)
switch off the ignition,
)
press and hold the trip distance
recorder zero reset button,
)
switch on the ignition; the dis-
tance recorder display begins a
countdown,
)
when the display indicates "=0"
,
release the button; the spanner
disappears. System which informs the driver
whether the engine oil level is correct
or not.
This information is displayed for a
few seconds when the ignition is
switched on, after the service infor-
mation.
The level read will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 30 minutes.
Oil level correct
Oil level low
This is indicated by the fl ashing of
"OIL"
, accompanied by an audible
signal and a message on the multi-
function screen.
If the low oil level is confi rmed by a
check using the dipstick, it is essen-
tial that the level is topped up to pre-
vent damage to the engine.
Oil level gauge fault
This is indicated by the fl ashing of
"OIL--"
. Contact a CITROËN dealer
or a qualifi ed workshop.
Dipstick
Refer to the "Checks" section to lo-
cate the dipstick and the oil fi ller cap
on your engine.
There are 2 marks on
the dipstick:
- A
= max; never ex-
ceed this level (risk
of engine damage),
- B
= min; top up the
level via the oil fi ller,
using the type of oil
suited to your en-
gine.
Following this operation, if you wish
to disconnect the battery, lock the
vehicle and wait at least fi ve minutes
for the zero reset to be taken into ac-
count.
Page 47 of 352
II
45
MULTIFUNCTION SCREENS
MONOCHROME SCREEN A
Displays in the screen
This screen can display the following
information:
- time
- date
- ambient temperature
When the ambient temperature
is between +3 °C and -3 °C, the
temperature display fl ashes (risk
of ice). The ambient temperature
displayed may be higher than
the actual temperature if the ve-
hicle is parked in the sun.
- the current audio source,
- trip computer (see the end of the
section).
Alert messages (e.g.: "Antipollution
system faulty") or information mes-
sages (e.g.: "Boot open") may appear
temporarily. They can be removed by
pressing "ESC"
.
A.
Access to the "Main menu".
B.
Navigation in the screen menus.
C.
Confi rmation of the selection of a
function in a menu or of a value
modifi ed.
D.
Cancellation the current operation.
E.
Selection of the type of infor-
mation (date, audio-CD and trip
computer).
B
or F.
In the menus, navigation,
choice of activation/deactiva-
tion of functions and choice
of settings.
)
Press button A
, then using B
,
you have access to the following
menus:
- radio-CD
- vehicle confi g
- options
- display adjust
- languages
- units
)
Press button C
to confi rm.
Controls
Main Menu
For safety reasons, confi guration
of the multifunction screen by the
driver must only be done when
stationary.