2011.5 Citroen C4 PICASSO deactivate

18
FAMILIARISATION

Seat belts not fastened/
unfastened warning lamp
This warning lamp informs you
if the driver’s or front passen-
ger’s seat belt is not fastened
(depending on model), and if
the front passenger’s (depend-
ing on model) or the second-row
passengers’ seat belts are unfastened.
The illuminated positions represent
those whose seat belts are not fastened/
unfastened.
Once the function has been activated,
when starting the engine, the system
automatically locks the doors once you
reach approximately 6 mph (10 km/h).
This function can be deactivated by
pressing button A
for more than two
seconds.

Tyre under-inflation detection

This function warns you if a tyre is de-
fl ated or punctured.
This system does not absolve the driver
of the need to regularly check the tyre
pressures.
The service warning lamp comes
on, and a vehicle outline is dis-
played, accompanied by a mes-
sage and an audible signal.
Under-infl ation warning
The STOP
warning lamp comes
on, and a vehicle outline is dis-
played, accompanied by a mes-
sage and an audible signal.
Puncture


41




127




89

MONITORING


Automatic central locking
Instrument panel


with multifunction screen A or C

with the MyWay or NaviDrive
multifunction screen


1.
Instrument panel.

2.
Multifunction screen.

3.
Control buttons.

4.
Warning lamps display zone.



31




32



Manual central locking

You can use electrical central locking or
unlocking by pressing on button A
.
If one of the doors is open or is not
closed properly, central locking will not
work.

27
FAMILIARISATION
DRIVING

Stop & Start


Engine going into STOP mode
The "ECO"
warning lamp comes
on in the instrument panel and
the engine goes into stand-by:


- with the 6-speed electronic gear-
box system
; at speeds below
4 mph (6 km/h), press the brake
pedal or put the selector lever into
neutral (position N)
.
In certain circumstances the STOP
mode may not be available; the "ECO"

warning lamp fl ashes for a few sec-
onds, then goes off.



153
The "ECO"
warning lamp goes
off and the engine restarts:


- with the selector lever in position A

or M
, release the brake pedal,

- or with the selector lever in posi-
tion N
and the brake pedal released,
change to position A
or M
,

- or select reverse gear.
In certain circumstances, START mode
may be invoked automatically; the
"ECO"
warning lamp fl ashes for a few
seconds, then goes off.



154

Deactivation/Reactivation
You can deactivate the system at any
time by pressing the "ECO OFF"
but-
ton; the button’s warning lamp comes
on.
The system is reactivated automati-
cally every time you start the engine
with the key.

Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition
with the key.



154


Going into engine START mode

I
34
MONITORING


Warning lamp


is on


Cause


Action/Observations





Front
foglamps


fi xed. The front foglamps are
switched on. Turn the ring on the stalk rearwards twice
to switch off the front foglamps.




Rear
foglamps


fi xed. The rear foglamps are
switched on. Turn the ring on the stalk rearwards to
switch off the rear foglamps.




Diesel engine
pre-heating


fi xed. The ignition switch is at the
2nd position (ignition on).
Wait until the warning lamp has switched off before starting.
The duration for which the warning lamp is on is determined
by the climatic conditions.





Parking brake


fi xed. The parking brake is applied
or not properly released. Release the parking brake to switch off the
warning lamp, keeping your foot on the
brake pedal.
Observe the safety recommendations.
For further information on the parking
brake, refer to the "Driving" section.
fl ashing. The parking brake is not fully
applied or is released.


Parking
space
sensors


fi xed. The parking space sensors
function is active. Press the corresponding button
to deactivate it.

fl ashing. The system is measuring the
space. Once the measurement has been done,
the warning lamp comes on fi xed again.


Electric child
lock


temporarily. The electric child lock is
activated. Displayed for a few seconds after activating
the function and every time the ignition is
switched on.
For more information, refer to the "Child
safety" section.

I
35
MONITORING


Warning lamp


is on


Cause


Action/Observations




Stop & Start


fi xed. When the vehicle stops (red
lights, traffi c jams, ...) the
Stop & Start system has put
the engine into STOP mode. The warning lamp goes off and the engine
restarts automatically in START mode, as
soon as you want to move off.

fl ashes for a few
seconds, then
goes off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. Refer to "Driving - § Stop & Start" for
special cases with STOP mode and
START mode.




Passenger's
airbag
system
fi xed. The control switch, located in
the glove box, is in the " ON
"
position.
The passenger's front airbag
is activated.
In this case, do not install a
rear-facing child seat. Turn the control switch to the " OFF
"
position to deactivate the front passenger's
airbag.
In this case you can install a rear-facing
child seat.

I
36
MONITORING










Deactivation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the corresponding system has been switched off intentionally.
This is may be accompanied by an audible signal and a message on the multifunction screen.



Warning lamp


is on


Cause


Action/Observations





Passenger's
airbag
system


fi xed. The control, located in the
glove box, is set to the OFF

position.
The passenger's front airbag
is deactivated.
In this case you can install a
"rear facing" child seat. Set the control to the ON
position to
activate the passenger's front airbag.
In this case, do not fi t a child seat in the
rear-facing position.





ESP/ASR


fi xed. The button, located in the
middle of the dashboard, is
pressed. Its indicator lamp is
on.
The ESP/ASR is deactivated.
ESP: electronic stability
programme.
ASR: anti-skid regulation. Press the button to activate the ESP/ASR.
Its indicator lamp switches off.
The ESP/ASR system is activated
automatically when the vehicle is started.
If deactivated, the system is reactivated
automatically from approximately 30 mph
(50 km/h).

I
39
MONITORING




Deactivation of
the automatic
functions of the
electric parking
brake



fi xed. The "automatic application"
(on switching off the engine)
and "automatic release"
functions are deactivated or
faulty. Activate the function (according to country)
via the vehicle confi guration menu or
contact a CITROËN dealer or a qualifi ed
workshop if automatic application/release
is not possible.
The parking brake can be released
manually using the emergency release
procedure.
For more information on the electric
parking brake, refer to the "Driving"
section.

Warning lamp


is on


Cause


Action/Observations





Dynamic
stability
control
(ESP/ASR)


fl ashing. The ESP/ASR regulation is
active. The system optimises traction and
improves the directional stability of the
vehicle.

fi xed. Unless it has been
deactivated (button pressed
and its indicator lamp on) the
ESP/ASR system has a fault. Have it checked by a CITROËN or a
qualifi ed workshop.


Engine
autodiagnosis
system


fl ashing. The engine management
system has a fault. Risk of destruction of the catalytic converter.
Have it checked by a CITROËN dealer or
a qualifi ed workshop.

fi xed. The emission control system
has a fault. The warning lamp should go off when the
engine is started.
If it does not go off, contact a CITROËN
dealer or qualifi ed workshop without delay.





Airbags


temporarily. This lamp comes on for a few
seconds when you turn on the
ignition, then goes off.
This lamp should go off when the engine is started.

If it does not go off, contact a CITROËN
dealer or a qualifi ed workshop.

fi xed. One of the airbag or seat belt
pretensioner systems has a
fault. Have it checked by a CITROËN dealer or
a qualifi ed workshop.

II
46
MULTIFUNCTION SCREENS

Vehicle config

Options

This menu is used for diagnosis of
the state of systems (active, inactive,
faulty).


Radio-CD

With the Audio system on, you can
activate or deactivate functions of
the radio (RDS station tracking,
REG mode), CD or CD changer (CD
introscan, shuffl e, repeat).
For more information on the "Radio-
CD" application, refer to the Audio
system section in "Audio and
Telematics".


Display adjust

The "Display adjust" menu is used
for the following settings:


- year,

- month,

- day,

- hour,

- minutes,

- 12 or 24 hour mode.



Languages

You can select the screen display lan-
guage (Français, Italiano, Nederlands,
Portugues, Portugues-Brasil, Deutsch,
English, Espanol).


Units

This menu is used to select the units
for temperature (°C or °F) and fuel
consumption (l/100 km, mpg or km/l).

*
Depending on destination country.

The"Vehicle confi g" menu is used
to activate/deactivate the following
functions:


- rear wiper coupled to reverse gear
(refer to the "Visibility" section),

- guide-me-home and welcome
lighting (refer to the "Visibility"
section),

- automatic functions (application/
release) of the electric parking
brake * ,

- selective door locking,

- daytime running lamps (refer to
the "Visibility" section).

II
48
MULTIFUNCTION SCREENS

Warning log
This lists alert messages, displaying
them successively on the multifunc-
tion screen.


Audio functions
Trip computer
Bluetooth telephone
(hands-free system)
You can see information on the state
of the vehicle.
With the Audio system on, you can
activate or deactivate functions as-
sociated with the radio (RDS, REG,
Radio Text), CD or CD changer (CD
introscan, shuffl e, repeat).
For more information on the "Audio
functions" application, refer to the
Audio system section in "Audio and
Telematics". With the Audio system on, you can
confi gure your Bluetooth hands-free
system (pairing), view the various
telephone directories (calls log, serv-
ices..) and manage calls (call, hang
up, double call, secret mode...).
For more information on the
"Telephone" application, refer to the
Audio system section in "Audio and
Telematics".
Status of functions
This allows diagnosis of the state of
systems (active, inactive, faulty).

Enter the distance to destination
You can enter a value for the dis-
tance to your fi nal destination.