2011.5 Citroen C4 ESP

195
7
Practical information

Removing a front or rear
wiper blade
) Raise the corresponding wiper arm.)
Remove the wiper blade, sliding it towards
the outside.










Changing a wiper
blade

Fitting a front or rear wiper
blade
) At the front, check the size of the wiper blade as the shorter blade is fitted on the
right-hand side of the vehicle.) Put the corresponding new wiper blade in
place and fix it. )
Fold down the wiper arm carefully.


Automatic power cut-off to accessories

After the engine has stopped, when the ignition switch is in the "ACC" position(or the vehicle in "ACC" mode)
you can still use functions such as the audio equipment, windscreen wipers, dipped beamheadlamps, cour tesy lamps, etc. for about
t
hirty minutes.
Cutting off
Once the thir ty minutes have expired, thepower supply to the accessories will be automatically cut off.
Restoring power
The power supply will be restored the next time
the ignition is switched on.

The period before cut-off can beextended up to about sixty minutes or deactivated, via the colour screen"Equipment" menu.

203
7
Practical information
The fitting of electrical equipment or accessories which are not recommended by CITROËN may resultin a failure of your vehicle's electronicsystem and excessive electrical consumption.
Please note this precaution. Youare advised to contact a CITROËNrepresentative to be shown the range of recommended equipment and accessories.
Installation of radiocommunicationtransmitters
Before installing any after-market radiocommunication transmitter, you cancontact a CITROËN dealer for thespecification of transmitters which can be fitted (frequency, maximum power,aerial position, specific installation requirements), in line with the Vehicle Electromagnetic Compatibility Directive (2004/104/EC).


Depending on the legislation in forcein the country, it may be compulsory to have a high visibility safety vest,warning triangle and spare bulbs andfuses available in the vehicle.

"Multimedia":

semi-integral satellite navigation systems, portable satellite navigation systems, audiosystems, speakers, rear shelf with speakers, hands-free kit, DVD player, mapping update
DVD, speed camera detector, Wi-Fi on board,
230V socket, head-up display, iPhone charger,
rear multimedia carrier...

210
Checks











Running out of fuel (Diesel)
engine, the fuel system must be manuallyprimed if you run out of fuel; refer to thecorresponding Diesel engine compartment
view.



1.6 litre HDi engine
)
Fill the fuel tank with at least five litres of diesel. )
Open the bonnet.)
If necessary, unclip the styling cover for
access to the priming pump. ) Squeeze and release the priming pump
repeatedly until resistance is felt (there may
be resistance at the first press). ) Operate the star ter until the engine starts(if the engine does not star t at the first
attempt, wait around 15 seconds before
tr
ying again). ) If the engine does not star t after a few
attempts, operate the priming pump again
then start the engine. ) Clip the styling cover back in place. )
Close the bonnet.

211
8
Checks






Checking levels


Take care when working under the bonnet, as certain areas of the engine may be extremelyhot (risk of burns).

Oil level
The check is carried out with the dipstick.
This check will only be correct if the
vehicle is on level ground and theengine has been off for more than 30 minutes.
It is normal to top up the oil level between
two ser vices
(or oil changes). CITROËN
recommends that you check the level, and top
up if necessary, every 3 000 miles (5 000 km).
After topping up the oil, the check when switching on the ignition with the oil levelindicator in the instrument panel is not validduring the 30 minutes after topping up.
Engine oil change
Refer to the ser vicing booklet for details of theinterval for this operation.
In order to maintain the reliability of the engine and emission control system, the use of additives in the engine oil is prohibited.
Oil specifi cation
The oil must be the correct grade for your
engine and conform to the manufacturer'srecommendations.

If a level drops si
gnificantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.
Check all of these levels regularly, in line with the ser vicing booklet and the requirements of the warranty. Top them up if necessary, unless other wise indicated.
Dipstick

There are two marks on the dipstick:
A
= m
aximum
If you fill past this mark,contact a CITROËN dealer or a qualified workshop. B
= minimum
Never allow the level to fallbelow this mark.

259
05SETTINGS

TIME AND DATE, LANGUAGE, UNIT, PICTURE SIZE
- Choose the size of the DVD picture for:E
- normal 4/3,E1
- extends the picture evenly to the right and toE2 the left in wide screen mode,
- extends the right and left parts only leaving E3 the centre as it stands in wide screen mode,
- enlarges the picture in 4/3 format. The top E4 and the bottom are outside the frame.
- Choose the base settings of the system for:

D
- setting of the time by the RDS signal, time
D1 zone, summer time,
- the language (English, Français, Deutsch,
D2 Nederlands, Portuguese, Español, Svenska, Italiano, Dansk),
- the units for calculation of the distances (km
D3 or miles and °C or °F),
- other settings such as:
D4



- the voice guidance volume,

- the t
ype of voice guidance voice (female or male),

- the volume of the operation bleeps
(1 to
3 and 0=no bleep),

- the t
ype of keypad (alphabet or PC),

- the ran
ge of menu colours (red or blue),

- the displa
y or not of the audio play icons in
the map screen,

- the reinitialisation of the vehicle sensor,

- the interruption or not of the displa
y when
the air conditioning is used.
E1E2E3E4
D1D2
D3D4
DE

278
09
3
4
7
8
9
10
11
1
2
5
6
12
14
13
BLUETOOTH® TELEPHONE®
The system has its own phone book, independent of that of the mobile telephone.
It can contain up to 32 names for each lan
guage.
Each name in the
phone book is associated with 4 locations: HOME, WORK, MOBILE and PAGER.
The s
ystem says " Select one of the following items: New Entry,
Change, List of names, Delete or Clear all, or say Cancel toreturn to the main menu".

Say "New entry".
The system says "HOME, WORK, MOBILE OR PAGER".
Give the location which corresponds to the number thatyou wish to record.
The s
ystem asks you to confi rm the location.


Answer "Ye s".
Say " No" to return to step 7.
If a telephone number has alread
y been recorded for this location, the system says " The current number is -number-, number please".















SAVING A NAME IN THE SYSTEM PHONE BOOK
Press this button.

Sa
y "Phone book".
The system says " Name please
".
Give the name of your choice.
If
you do not wish to change the telephone number, repeat the
original number to retain it, otherwise say the new number.

Answer "Ye s"
Say " No" to return to step 11.
The s
ystem asks you to confi rm the number.

279
09
2
3
1
4
6
5
7
8
9
BLUETOOTH® TELEPHONE®
Say "Call
".

The s
ystem says "Name please".
















USING A NAME IN THE PHONE BOOK
Give the name of the person that you wish to call. Pr
ess this button.
Give the location corresponding to the number that you
wish to call.
You must have fi rst matched a compatible Bluetooth®mobiletelephone with the system.

If several telephone numbers have been recorded for this person,
t
he system says "Do you wish to call {home}, {work}, {mobile} or {pager}?"

The system request confi rmation of the name.


Answer " Ye s
".
Say "No
" to return to step 4.

The s
ystem says "Call to at " and makes the call.

287
1
1
1
11
03GENERAL OPERATION

Press the "PWR" button.
Th
e last source selected beforeswitching off resumes operation.
The audio equipment functions can be
used when the ignition switch is in the "ON" or "ACC" position.
To switch o
ff, press the "PWR" button
again.

ADJU
STING THE VOLUME

SETTING THE AUDIO MODES

Press the "
SOUND" button several
times; the audio modes change in the following order:

SUB PUNCH / TYPE / FIELD /
BASS / MID / TREBLE / FADER /
BALANCE / OFF.
Turn the "V
OL" dial respectively to the
left to decrease the volume or to theright to increase it. To access the personalised sound
functions quickl
y, press and hold
this button, then turn it to reach the
personalised sound setting of your choice.
Release the button to store thesetting. QUICK ACCESS MODE SWITCHING ON / OFF

The audio settin
g mode is deactivated when the radio is operated or a CD is played or after approximately 10 seconds without anyaction.I
f you press this button for more than2 seconds in the audio setting mode,
the system switches to "Hold" mode.
The audio mode selected will be
retained until you press this button again for more than 2 seconds. "HOLD" MODE