2010 YAMAHA RHINO 700 steering wheel

7-33
Become familiar with the way the vehicle feels in
low and high ranges, first in two-wheel drive with
both differentials unlocked “DIFF UNLOCK” and
with the rear differential locked “2WD”, and then in
four-wheel drive “4WD” and four-wheel drive with
the differential locked “DIFF LOCK”. Steering may
take more effort in four-wheel drive with the differ-
ential locked “DIFF LOCK”. Also practice driving in
reverse.
Take the time to learn basic operation of the vehi-
cle before attempting more difficult maneuvers.
Getting ready to ride
Perform the Pre-Operation Checks on pages 5-1–
5-31. Follow the instructions starting on pages
6-7–6-9 to start the engine.
EE.book Page 33 Monday, January 19, 2009 5:30 PM

7-35
Turning
Use care in turns – turning the steering wheel too
far or too fast can result in loss of control or a roll-
over. Slow down before entering turns. When
making tight turns from a standstill or at slow
speeds, avoid sudden or hard acceleration. Driv-
ing aggressively or making abrupt maneuvers
even on flat, open areas can cause side rollovers.
Avoid sideways sliding, skidding, or back-wheel
sliding, and never do donuts. If you feel the Rhino
begin to slide sideways or the back wheels slide
during a turn, steer into the direction of the slide, if
possible, and gradually let off the accelerator ped-
al to regain directional control and avoid rollover.
For example, if you feel the back of the vehicle
start to slide to your right, steer to the right.
EE.book Page 35 Monday, January 19, 2009 5:30 PM

7-37
If you think or feel that the vehicle may tip or roll,
keep your body completely inside the protective
structure of the vehicle:

Brace yourself by pressing your feet firmly on
the floorboards and keep a firm grip on the
steering wheel or handholds.


Do not put your hands or feet outside of the ve-
hicle for any reason. Do not try to stop a tipover
using your arm or leg.
EE.book Page 37 Monday, January 19, 2009 5:30 PM

7-51
Hills
Choose carefully which hills you attempt to climb
or descend. Avoid hills with slippery surfaces or
those where you will not be able to see far enough
ahead of you. Use common sense and remember
that some hills are too steep for you to climb or de-
scend. Use proper driving techniques to avoid
rearward, forward, or sideways rollovers on hills
and slopes.
Drive straight up and down inclines, not across
them. If crossing a hill is unavoidable, drive slowly.
Turn downhill immediately if you feel the vehicle
may tip.
If you think or feel the Rhino may tip or roll:

Brace yourself by pressing your feet firmly on
the floorboards and keep a firm grip on the
steering wheel or handholds.


Do not put your hands or feet outside of the ve-
hicle for any reason.
EE.book Page 51 Monday, January 19, 2009 5:30 PM

8-8
EVU01650
General maintenance and lubrication chart
ITEM ROUTINEWhichever
comes firstINITIAL EVERY
month136612
km
(mi)320
(200)1,200
(750)2,400
(1,500)2,400
(1,500)4,800
(3,000)
hours 20 75 150 150 300
Cooling system*Check coolant leakage.
Repair if necessary.
Replace coolant every 24 months.
Air filter elementClean.
Replace if necessary.Every 20–40 hours
(More often in wet or dusty areas.)
Engine oilReplace (warm engine before draining).Engine oil filter cartridgeReplace.Front differential gear oil
Check oil level/oil leakage.
Replace.Rear differential gear oil
Front brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Rear brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Parking brake*Check operation and free play/brake pad wear.
Correct if necessary. Replace pads if worn to the limit.Accelerator pedal*Check operation and free play.V-belt*Check operation.
Check for wear, cracks, or damage.Wheels*Check balance/damage/runout.
Repair if necessary.Wheel bearings*Check bearing assemblies for looseness/damage.
Replace if damaged.Front and rear
suspension*Check operation and for leakage.
Correct if necessary.Steering system*Check operation and for looseness/Replace if damaged.
Check toe-in/Adjust if necessary.Rear upper and lower
knuckle pivots*Lubricate with lithium-soap-based grease.
EE.book Page 8 Monday, January 19, 2009 5:30 PM

8-105
1. Nut (× 4)
1.Écrou (× 4)
1. Tuerca (× 4)
1
1
EVU00920
Steering shaft lubrication
Lubricate the pivot points.
EVU00930
Wheel removal
1. Loosen the wheel nuts.
2. Elevate the vehicle and place a suitable
stand under the frame.
3. Remove the nuts from the wheel.
4. Remove the wheel.Recommended lubricant:
Lithium-soap-based grease
EE.book Page 105 Monday, January 19, 2009 5:30 PM

10-1
EVU01050
1 -SPECIFICATIONS
Model YXR7F4PZ
Dimensions:
Overall length 3,128 mm (123.1 in)
Overall width 1,516 mm (59.7 in)
Overall height 1,890 mm (74.4 in)
Seat height front 780 mm (30.7 in)
rear 843 mm (33.2 in)
Wheelbase 2,090 mm (82.3 in)
Ground clearance 310 mm (12.2 in)
Minimum turning radius 4,250 mm (167 in)
Basic weight:
With oil and full fuel tank 672.0 kg (1,481 lb)
Noise and vibration level:
Noise level (77/311/EEC) (for Europe) 80.2 dB(A)
Vibration on seat (EN1032, ISO5008) (for Europe) Will not exceed 0.5 m/s
2
Vibration on steering wheel (EN1032, ISO5008)
(for Europe)Will not exceed 2.5 m/s
2
EE.book Page 1 Monday, January 19, 2009 5:30 PM