2010 TOYOTA PRIUS key

520 5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
InteriorbuzzerExterior buzzerWarning messageDetailsCorrection procedure
Once Contin-
uous
(Flashing)An attempt to
lock the doors
has been made
using the smart
key system
while the elec-
tronic key is
inside the vehi-
cle. (vehicles
with entry func-
tion)
Take the
electronic
key out-
side the
vehicle,
and lock
the doors
again.
With the key
inside the vehi-
cle, a front door
has been
opened, the
lock lever has
been pulled in
the lock direc-
tion, the door
has been
closed while the
door handle is
being pulled,
and an attempt
has been made
to lock the door.

5
When trouble arises
521
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
Interior
buzzerExterior buzzerWarning messageDetailsCorrection procedure
Contin-
uous Contin-
uous
(Displayed alternately) (Flashing) An open door
other than the
driver’s door is
closed while the
electronic key is
outside the
detection range
and the
“POWER”
switch is in
ACCESSORY
or ON mode
with the shift
position not in
“P”.
• Push the
“P” posi-
tion
switch.
• Confirm the loca-
tion of the
electronic
key.
Once  The electronic
key battery is
low.Replace
the bat-
tery.

( P. 460)
Once 
(Flashing)An open door
has been
closed and the
“POWER”
switch has been
turned twice to
the ACCES-
SORY mode
from OFF. Press the
“POWER”
switch
while
applying
the
brakes.

522 5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
InteriorbuzzerExterior buzzerWarning messageDetailsCorrection procedure
Once 
(Flashing)The elec-
tronic key
does not
operate
properly.
P. 542
 Power
was
turned off
due to
the auto-
matic
power off
function.Next time when
starting the
hybrid system,
increase the
engine speed
slightly and
maintain that
level for approxi-
mately 5 min-
utes to recharge
the battery.
■ Changing the engine oil
Make sure to reset oil change system.

538
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
If the hybrid system will not start
If the hybrid system still does not start after following the correct
starting procedure (
P. 164), confirm the following points.
■ The hybrid system will not start even if you are carrying the
correct key.
One of the following may be the cause of the problem.
●There may not be sufficient fuel in the vehicle’s tank. 
Refuel the vehicle.
● The electronic key battery may be discharged. ( P. 541)
● The hybrid system may be malfunct ioning due to an electrical
problem such as an open circuit or a blown fuse. However,
depending on the type of malfunc tion, an interim measure is
available to start the hybrid system. ( P. 539)
● There may be a malfunction in the immobilizer system. 
( P. 108)
■ The interior lights and headlight s are dim, or the horn does
not sound or sounds at a low volume.
One of the following may be the cause of the problem.
● The 12 volt battery may be discharged. ( P. 543)
● The 12 volt battery terminal c onnections may be loose or cor-
roded.

540
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
If you lose your keys
New genuine Toyota keys can be made by your Toyota dealer using
other key and the key number stamped on your key number plate.

5
When trouble arises
541
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
If the electronic key does not operate properly
Locking and unlocking the doorsUsing the mechanical key
( P. 41) in order to perform
the following operations:
Locks all doors
Unlocks the door
Turning the key rearward unlocks
the driver’s door. Turning the key
once again within 3 seconds
unlocks the other doors.
If communication between the elect ronic key and vehicle is inter-
rupted (
P. 43, 57) or the electronic key cannot be used because the
battery is depleted, the smart key system and wireless remote con-
trol cannot be used. In such cases, the doors can be opened or the
hybrid system can be started by following the procedure below.
ITO52P12N

542 5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
Changing “POWER” switch modes and starting the hybrid sys-
temApply the brakes and touch the
Toyota emblem side of the
electronic key to the “POWER”
switch.
An alarm will sound to indicate
that the start function cannot
detect the electronic key that is
touched to the “POWER” switch if
any of the doors is opened and
closed while the key is touched to
the switch.
To change “POWER” switch modes: Within 10 seconds of the
buzzer sounding, release the brake pedal and press the
“POWER” switch. Modes can be changed each time the
switch is pressed. ( P. 164) 
To start the hybrid system: Press the “POWER” switch within
10 seconds after the buzzer s ounds, keeping the brake pedal
depressed.
In the event that the “POWER” swit ch still cannot be operated, con-
tact your Toyota dealer.
ITO52P165
STEP1
■ Stopping the hybrid system
Push the “P” position switch and press the “POWER” switch as you normally
do when stopping the hybrid system.
■ Replacing the key battery
As this procedure is the temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery depletes.
(P. 460)
STEP2

587
6
Vehicle specifications
PRIUS_U (OM47668U) U.S.A.
6-2. Customization
Customizable features
*: Vehicles with the entry function
ItemFunctionDefault settingCustomizedsetting
Smart key
system 
( P. 43, 57) Smart key system ON OFF
Operation signals

(Emergency flashers)
*ON OFF
Operation signals
(Buzzer)
*ON OFF
Your vehicle includes a variety of electronic features that can be per-
sonalized to your preferences. Programming these preferences
requires specialized equipment and may be performed by an autho-
rized Toyota dealership.
Some function settings are changed simultaneously with other functions
being customized. Contact your Toyota dealer for further details.