2010 TOYOTA PRIUS disp switch

60 1-2. Key information
PRIUS_U (OM47668U) U.S.A.
■Alarms and warning indicators
A combination of exterior and interior alarms are used to prevent theft of the
vehicle and unforeseeable accidents resulting from erroneous operation.
Take appropriate measures according to the warning message shown on the
multi-information display. ( P. 508)
The following table describes circumstances and correction procedures
when only alarms are sounded.
AlarmSituationCorrection procedure
Exterior alarm
sounds once for
10 seconds An attempt was made to
lock the vehicle while a
door is open Close all of the doors
and lock the doors
again
Interior alarm
pings continu-
ously
*1
The “POWER” switch was
turned to ACCESSORY
mode while the driver’s
door was open (or the
driver’s door was opened
while the “POWER” switch
was in ACCESSORY
mode) Turn the “POWER”
switch OFF and close
the driver’s door
Interior alarm
sounds continu-
ously
*1
When the “POWER”
switch is in ON mode or
ACCESSORY mode, an
attempt was made to open
the door and exit the vehi-
cle, and the shift position
was not in “P” Push the “P” position
switch and turn the
“POWER” switch OFF
Interior and exte-
rior alarms sound
continuously
*1
When the “POWER”
switch is in ON mode or
ACCESSORY mode, the
driver’s door was closed
after the key was carried
outside the vehicle, and
the shift position not in “P” Push the “P” position
switch, turn the
“POWER” switch OFF
and close the driver’s
door again

61
1-2. Key information
1
Before driving
PRIUS_U (OM47668U) U.S.A.
*1: A message will be shown on the multi-information display in the instru-
ment cluster.
*2: If the hybrid system does not start when the electronic key is inside the vehicle, the electronic key battery may be depleted or there may be dif-
ficulties receiving signal from the key. ( P. 541)
■ If the smart key system does not operate properly
 P. 542
■ When the electronic key battery is fully depleted
 P. 460
■ Customization that can be co nfigured at Toyota dealer
Settings (e.g. smart key system) can be changed. 
(Customizable features P. 587)
AlarmSituationCorrection procedure
Interior alarm
pings once
*1
The electronic key has a
low battery Replace the electronic
key battery
An attempt was made to
start the hybrid system
without the electronic key
being present, or the elec-
tronic key was not func-
tioning normally Start the hybrid sys-
tem with the elec-
tronic key present
*2
Interior alarm
pings once and
exterior alarm
sounds 3 times
*1
The driver’s door was
closed after the key was
carried outside the vehicle,
and the “POWER” switch
was not turned OFF
Turn the “POWER”
switch OFF and close
the driver’s door again
An occupant carried the
electronic key outside the
vehicle and closed the
door while the “POWER”
switch was not OFF Bring the electronic
key back into the vehi-
cle

When driving2
149
PRIUS_U (OM47668U) U.S.A.
2-1. Driving proceduresDriving the vehicle............ 150
Power (ignition) switch ..... 162
EV-Drive Mode................. 168
Transmission.................... 171
Turn signal lever .............. 178
Parking brake ................... 179
Horn ................................. 180
2-2. Instrument cluster Gauges and meters ......... 181
Indicators and warning 
lights .............................. 185
Multi-information  display............................ 188 2-3. Operating the lights and
windshield wipers
Headlight switch ............... 206
Fog light switch ................ 209
Windshield wipers 
and washer .................... 210
Rear window wiper  and washer .................... 212
Headlight 
cleaner switch ................ 213
2-4. Using other driving systems Cruise control ................... 214
Dynamic radar 
cruise control ................. 218
Rear view monitor 
system ........................... 231
LKA (Lane-Keeping 
Assist) ............................ 235
Hill-start assist control ...... 243
Driving assist systems ..... 245
Pre-Collision System........ 249
2-5. Driving information Cargo and luggage .......... 255
Vehicle load limits ............ 260
Winter driving tips ............ 261
Trailer towing ................... 266
Dinghy towing .................. 267

174 2-1. Driving procedures
PRIUS_U (OM47668U) U.S.A.
Changing shift ranges to “P” positionPush the “P” position switch with
the brake pedal pressed down.
The “P” position icon is displayed
on the instrument cluster, and the
indicator on the “P” position
switch comes on.
You can only shift to other posi-
tions from “P” when the brake
pedal is depressed.
When parking, check that the “P”
position icon is displayed on the
instrument cluster, and release
the brake pedal gently after
applying the parking brake.
ITO21P107
■Using engine brake
To use the engine braking, shift the shift lever to “B” position.
● During high speed driving, you may feel that deceleration by engine brak-
ing is less than that of a typical vehicle.
● Do not continue normal driving with the transmission in “B” for a long
time.
This may cause decreased fuel economy. To prevent this, use “D” for
normal driving.

175
2-1. Driving procedures
2
When driving
PRIUS_U (OM47668U) U.S.A.
■
Reverse warning buzzer
When shifting into “R”, a buzzer will sound to inform the driver that the shift
lever is in “R”.
■ When in heavy traffic
If the shift lever is in “N”, the hybrid battery (traction battery) will not be
charged. To help prevent the battery from discharging, avoid putting the shift
lever in “N” for an extended period of time.
■ Eco Driving Mode
When the accelerator pedal is depressed in Eco Driving Mode, it may take
more time to accelerate than usual. This is normal operation.
■ If the system malfunctions
The following situations indicate a problem with the system. 
Immediately stop the vehicle in a safe place and contact your Toyota dealer.
● The indicator on the “P” position switch flashes. However, this does not
indicate a malfunction unless a warning message appears in the multi-
information display.
● All frames of the shift position indicators in the instrument cluster flash.
● The parking system error message appears on the multi-information dis-
play.
● The instrument cluster does not come on when the “POWER” switch is in
ON mode.

177
2-1. Driving procedures
2
When driving
PRIUS_U (OM47668U) U.S.A.
*: Follow the warning message displayed.
CAUTION
■
To avoid an accident
Do not hang objects on or attach objects to the shift lever. 
Doing so may cause the shift lever to move and the shift position to change.
AlarmSituationCorrection procedure
Interior alarm beep sounds and warning message
*
If the driver’s door is
opened while the transmis-
sion is in “N”, “D” or “B”. Push the “P” position
switch.

181
2
When driving
PRIUS_U (OM47668U) U.S.A.
2-2. Instrument cluster
Gauges and meters
The following gauges and meters illuminate when the “POWER”
switch is in ON mode.Fuel gauge
Displays the quantity of fuel remaining in the tank.
Speedometer
Displays the vehicle speed.
Instantaneous fuel consumption
Displays the current rate of fuel consumption.
Shift position indicators
Displays the shift position.

182 2-2. Instrument cluster
PRIUS_U (OM47668U) U.S.A.
Touch tracer display (if equipped)When the audio control switches,
climate control switches, “DISP”
switch or “TRIP” switch of the
steering wheel are touched, the
touch tracer display will appear
in front of the gauges, with the
touched switch highlighted to
allow the driver to identify the
switch that is being operated.
The switch can then be operated
by further presses.