2010 SKODA FABIA Blues Car Radio Manual

www.skoda-auto.com
Blues: Fabia, Roomster, Praktik
Rádio anglicky 11.2011
S00.5610.74.20
5J0 012 095 CM SIMPLY CLEVER
RADIO BLUES
OWNER'S MANUAL

Table of Contents
General information
. . . . . . . . . . . . . . . . . . . . . . 2
Owner's Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Symbols in the text of the operating instructions . . . 2
Equipment overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Anti-theft protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Basic setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Radio mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
CD player . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Using the system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 1
Table of Contents

General information
Owner's Manual This Owner's manual describes
all possible equipment variants without identify-
ing them as special equipment, model variants or market-dependent equipment.
Consequently, this vehicle does not need to contain all of the equipment compo-
nents described in this Owner's manual.
The scope of equipment for your vehicle is described in the sales documentation
you were given when purchasing the car. For more information, contact your local
ŠKODA retailer. Ð
Symbols in the text of the operating instructions Explanation of symbols
Ð
End of a section.
 The section is continued on the next page. Ð
Equipment overview Control button
–
Switching radio on and off (press)
– Volume control (rotate)
Control button to activate the function Scan
Button RADIO to activate the radio mode
Button MEDIA to activate the play function of audio sources
Buttons 
 –
manual station finding, select the track in CD mode (press briefly)
– fast station finding, fast forward/reverse in the CD mode (press for a long
period of time)
Button TP to activate the reception of traffic reports
Button MENU to call up the menu settings of the parameter for radio or CD
player
1 2
3
4
5
6
7 Function keys
–
store and select the RDS station
– Enter code
– Call up the Stop menu
Button  for adjusting the sound
CD case
CD - eject button Ð
Important information Warranty The equipment warranty terms and conditions also apply for new vehicles.
After the expiration of the warranty, a piece of equipment in need of repair will be
replaced with a reconditioned, original item with spare part warranty. It is, howev-
er, a precondition that the housing has not been damaged and no unauthorised
attempts have been made to carry out repairs. Note
Damage within the meaning of the warranty must not be the result of improper
handling of the system or from unprofessional repair attempts. It is also essential
that there is no external damage. Ð
Device operation The unit should only be used, if the traffic situation permits it.
The volume settings must be selected in such a way that audible signals from the
outside, e.g. a Martins horn from utility vehicles (police cars, ambulances and fire
brigade), can be heard at all times. WARNING
Please concentrate fully at all times on your driving! As the driver you are fully
responsible for road safety. Only use the functions of the radio in such a way
that you are always in full control of your vehicle in all traffic situations! Ð
8
9
10
112
General information

Using the display
Carefully handle the display because dents and scratches can occur through pres-
sure of the finger or contact with sharp objects.
The display can be cleaned with a soft cloth and finger marks can be wiped away
with pure alcohol. Note
Do not use solvent such as turpentine or petrol as they will corrode the display
surface. Ð
Anti-theft protection Anti-theft coding Your radio is equipped with a convenience coding. If the radio is being operated
for the first time, the safety code is not only stored in the radio but also in the ve-
hicle.
After disconnecting and reconnecting the battery, first of all switch on the ignition
and then the radio.
If you wish to install the radio in another vehicle, the safety code must be entered.
In this case, please do not hesitate to contact a
ŠKODA Service Partner or a
ŠKODA importer.
As the unit only functions after entering the safety code, this practically excludes
its use after a theft - a contribution to increased anti-theft safety. Note
The code is stored in the instrument cluster. This ensures that it is automatically
decoded (convenience coding). Manual input of the code is normally not necessa-
ry. Ð
Enter code –
Switch on the radio if the ignition is on. SAFE
is displayed and then 1000.
– Enter the safety code using the function keys 1 -
4 .
– Confirm the safety code by pressing down on the function key 6 .If you have confirmed a wrongly entered code, you can repeat once again the en-
tire process.
If the code number is entered incorrectly for the second time, the unit will be
blocked for approx. one hour. It is possible to enter again the safety code after
one hour has expired, when the unit and the ignition have been switched on.
The cycle - two attempts, blocked for an hour - will continue to apply. Ð
Basic setting Switching the unit on and off –
The system is switched on or off by pressing the control button 1 .
If the key is pulled out of the ignition lock while the unit is switched on, the unit
will switch off automatically. You can switch on the unit again by pressing the
control button 1 . If the ignition is switched off, the unit (discharge protection of
the vehicle battery) switches off automatically after approx. one hour.
If you have switched off the radio by withdrawing the ignition key, the radio
switches on again once the ignition is on. Ð
Tone settings –
Press the button  repeatedly to select the desired parameter.
– Set the desired value by turning the rotary/push knob 2 .
You can select between the following parameters:
● TRE - Treble setting;
● BAS - Bass setting;
● BAL
- setting of the volume ratio between the left and the right side;
● FAD* - setting of the volume ratio between the front and the rear. Ð
Setting the special functions –
Press the button MENU afterwards select the function key
SET. You activated
the Setup menu.
– You can select individual functions of the menu by pressing the function keys.  3
General information

–
Set the desired value by pressing the button  or
 .
SKM (SEEK MODE)
● ALL - stops the station finding on all available stations;
● PRESET - stops the station finding on the stored stations.
VOL
Your radio stores the last volume set before switching off. If the value is higher,
the volume is reduced to the value of the parameter ON VOLUME after switching
on the radio again.
GAL (GALA)
Your radio increases automatically its volume with the increasing vehicle speed. A
higher setting value results in a stronger volume increase.
DIS (DISPLAY)
Set the level of the backlighting for the display.
PHONE
If your vehicle is equipped with a handsfree system, the monophone play function
of the mobile phone calls is carried out via the loudspeakers of the vehicle.
PDC AT
If your vehicle is equipped with
“parking aid”, the volume is automatically de-
creased to a pre-defined value, when the “parking aid” is active.
● PDC AT0 - no volume restriction;
● PDC AT1 - restricts the volume to a middle level;
● PDC AT2 - restricts the volume to a low level;
● PDC AT3 - Mute.
AUX
Setting of the input sensitivity AUX VOL LEVEL:
● AUX VOL LEV 1 - high level, used in particular for notebooks;
● AUX VOL LEV 2 - middle level, used for cassettes or CD player;
● AUX VOL LEV 3 - low level, used for MP3 player;Note
Each setting change is stored by changing to another menu point. ÐRadio mode
Waveband switch-over Your radio is equipped with FM and AM wavebands.
In the ranges FM1/FM2 and AM1/AM2 there are each 6 memory spaces available, in
order to change, press the button
RADIO briefly.
Ð
The process of searching for and storing the radio stations Manual search
–
Search the frequency of the desired radio station by turning the control button
2 .
Automatic station finding
– The radio searches for the next radio station in the selected waveband by
pressing the button  or
 briefly.
Function SCAN
– The radio stations of the current waveband are briefly played (10 seconds) by
pressing the control button 2 or by pressing the button
MENU and tapping
the function key SCN afterwards.
– This function is ended by pressing the button 2 once again and the current
station is replayed.
Function AS
– Press the button MENU and then the button
AS. An automatic station finding
is started during which the 6 stations with the strongest signal in the memory
level FM1 and/or AM1 are stored. AM1.
Store station
– After selecting the radio station, hold the station key 8 , on which it should be
stored until it briefly switches to mute and a brief signal sounds. Ð
RDS functions Certain radio stations transmit additional text information - designated as radio
text.
4
General information

Note
● The text information must not be available to all radio stations.
● Depending upon the quality of the received signal, the radio needs a specific
time, in order to correctly read all the illustrated characters. Ð
Traffic information function Activating and deactivating the traffic reports
Press the button
TP ,
TP appears in the display. If a set radio station does not
transmit a traffic report, NO TP appears on the display, and the radio searches for
a station which transmits the traffic report. TP SEEK is displayed on the display.
If no radio station which transmits the traffic reports is found, NO TP is shown on
the display.
An incoming traffic report will automatically interrupt CD playback. INFO and Sta-
tion name is shown on the display. At the end of the traffic report, the radio auto-
matically returns to the original play function.
If you wish to deactivate the traffic information, press once again the button TP ,
TP goes out on the display. Ð 5
General information

CD player
Using the systemInserting the CD –
Press the button MEDIA , in order to select the source for the play function:
CD
(internal CD drive), EXT (CD changer, if it is connected to the radio) or AUX.
– Carefully insert a CD into the CD case 10 until it is automatically drawn in. The
play function begins automatically. Ð
Operating the CD player Select track
–
Press the button  or
 during the play function of the CD, in order to select
the previous and/or the next title.
– Press the button  or
 longer for fast replay of the track (reverse or for-
ward). The play function is continued after releasing the button.
– Press the relevant station key 8 (valid for MP3 data) for scrolling in the fold-
ers or in the play lists (if they are present on the CD).
Function SCAN
– Press the button 2 , in order to scroll through the CD. The first 10 seconds of
each title are played.
– In order to return to the normal mode, press once again the button 2 .
– Press the button  or
 if you wish to select the previous or the following
track.
End the play function of the CD
– In order to end the play function of the CD and to activate the radio, press the
button RADIO .
Ejecting CD
– Press the button 11 , the Cd is ejected. Display of additional information (MP3 data)
In the display, you can select the display of additional information via the MP3 da-
ta using the function key INF. Note
● If the ejected CD is not removed, it is drawn in again for safety reasons.
● If the radio is functioning in the TP mode before changing to the CD mode, the
play function of the CD is interrupted during the traffic reports and the unit
switches over to the radio mode. After the traffic reports have ended, the unit
switches back once again to the CD mode. Ð
Replay the tracks in random order –
Select a function of the MIX menu with the help of the station keys.
MIX
Play function of titles in random order.
● MIX OFF - the function of the menu is switched off;
● MIX CD - Plays the tracks on a CD in random order;
● MIX FLD - Play function of titles in random order in a certain (folder);
● MIX PLS - Play function of the playlist (folder of selected tracks from individual
folders, which is stored on the CD). Is only displayed when a playlist is created for
the replayed CD. Ð
General information for MP3 operation Requirements for the MP3 data and data carrier
●
CD-ROM, CD-R, CD-RW with a capacity of 650 MB and 700 MB.
● The CDs must correspond to the ISO 9660 Level 2 standard as well as the Jo-
liet data system (single and multi-session).
● Data names must be no longer than 64 characters.
● The list structure is restricted to a depth of 8 list levels. 6
CD player