If and when
284
– Check that the seal is seated correctly on the bulb holder.
– Position the bulb holder on the tail light and align it so that it is securely seated.
– Press the bulb holder into the tail light until it engages.
– Check that all four retaining tabs ⇒page 283, fig. 229 -arrows-
have engaged.
– Re-install the tail light unit ⇒page 284.Fitting the tail light unit
The tail light unit is easy to fit.
– First place the tail light unit in ⇒fig. 230 arrow in the
housing.
– Gently press the tail light unit against the housing, first in posi- tion and then in position , until that the clips engage firmly
in the rubbe r mountings.
– Apply gentle pressure to the front side of the tail light unit and secure using the screwdriver, from the luggage compartment
⇒ fig. 231 .
– Try to move the tail light sideways to ensure it is correctly fitted.
– Fit the cover back onto the screw, with the notch pointing to the rear .
– Put the screwdriver back into the tool kit.
– Make sure that all bulbs for the tail lights are working.
Fig. 230 Fitting the tail
light unit
Fig. 231 Luggage
compartment: Location of
the bolt securing the tail
light unit
A1
A2
A3
A1
A2
ExeoST_EN.book Seite 284 Freitag, 3. September 2010 11:41 11
