2010 Seat Alhambra roof

Seats and storage compartments145
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
xPull the head restraint out of the fitting without releasing the button
Ÿfig. 93 .
xFold the backrest of the rear seat backwards until it is engaged.
Installing the head restraints for the second and third row of seats
xFold the backrest of the rear seat forwards Ÿpage 146.
xInsert the head restraint into the guides on the backrest.
xPush the head restraint down as far as it will go while pressing button .
xFold the backrest of the rear seat backwards until it is engaged.
xAdjust the head restraint to the correct position Ÿpage 143.
WARNING
Travelling with the head restraints removed or improperly adjusted
increases the risk of severe or fatal injuries in the event of accidents and
sudden braking or manoeuvres.
xAlways fit and adjust the head restraint properly whenever a person is
occupying a seat.
xRefit any removed head restraints immediately so that passengers are
properly protected.
Caution
On removing and fitting the head restraint, make sure the head restraint does
not hit the interior roof of the vehicle or the backrest of the front seat. This
could damage the interior roof and other parts of the vehicle.
Centre ar mrest
To lift the central armrest, lift it upwards in the direction of the arrow
Ÿfig. 94, setting by setting.
To lower the centre armrest, pull it downwards. Then lower the centre armrest.
WARNING
The centre armrest may limit the freedom of movement of the driver's arm
and cause a serious accident.
xKeep the centre armrest compartments closed while the vehicle is in
motion.
xThe centre armrest is not designed for children to sit on! Sitting in this
incorrect position can cause severe injuries.
A1
A1
Fig. 94 Front centre
armrest.

Seats and storage compartments 152
Net partition
The net partition can prevent objects in the luggage compartment entering
the passenger compartment / the driver area.First remove the net from its bag and unfold it.
Fold out the net partition
Fold out the support transversal rods Ÿfig. 99 for the net partition fully
in the direction of the arrow until you hear a “click”.
Installing the net partition behind the second row of seats
xHook in the net partition on the left-hand side roof support Ÿfig. 100
. To do this, guide the rod from up to down.
xHook in the net partition on the rear right-hand side roof support by
pressing on the rod.
xSecure the net partition hooks into the straps in the front of the luggage
compartment Ÿfig. 100 then tighten them.
Installing the net partition behind the front seats
xHook in the net partition on the left-hand side roof support Ÿfig. 100
. To do this, guide the rod from up to down.
Fig. 99 Unfold the net partition then fold it again
and .A1A2A3
Fig. 100 In the luggage
compartment: Install the
net partition behind the
second row of seats.
A1
AA
AB
AC

Seats and storage compartments153
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
xHook in the net partition on the rear right-hand side roof support by
pressing on the rod.
xSecure the hooks of the net partition to the attachment rings in the left
and right hand side foot rests on the second row of seats then tighten the
straps.
Removing the net partition
xLoosen the net partition straps.
xRelease the net partition hooks from the rings Ÿpage 152, fig. 100 .
xRelease the net partition from the right and left roof supports
Ÿpage 152, fig. 100 or by pressing on the rod.
xUnhook the net partition from the left-hand side roof support.
Folding in the net partition
xPress on the release button Ÿpage 152, fig. 99 and bend the rod
in the direction of the arrow with the release o button pressed.
xPress on the release button Ÿpage 152, fig. 99 and bend the rod
in the direction of the arrow with the release button pressed.
xStore the net partition securely in the vehicle.
WARNING
Loose objects in the passenger compartment can be violently thrown in
case of a sudden manoeuvre or braking and especially in accidents causing
serious injury.
xEnsure that the rods are correctly locked in place.
xEven when net partition is correctly fitted, objects must be secured.
xWhen driving with the net partition, no passengers should be behind
it.
Fastening rings
To the front and rear of the luggage compartment, there are fastening rings
for securing objects Ÿfig. 101 (arrows). On some models, the fastening
rings are all the way to the back on the lock carrier plate.
There are other fastening rings located to the left and right hand side of the
second row footrests.
Some models of fastening rings must be lifted to use them.
WARNING
Unsuitable or damaged ropes or straps may be released in case of sudden
braking or an accident. As a result, objects may be fired through the
passenger compartment causing serious injury or death.
xAlways use suitable ropes and straps in good condition.
xSecure the ropes and straps to the fastening rings.
xLoose objects in the luggage compartment can suddenly slide and
change the way the vehicle handles.
AB
AAAC
A2AA
A3AB
Fig. 101 In the luggage
compartment: fastening
rings

Seats and storage compartments159
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Roof carrier system
Introduction
The vehicle roof has been designed to optimise aerodynamics. For this
reason, conventional roof carrier systems cannot be secured to the roof rails.
Given that the water drains have been incorporated into the roof for aerody-
namic reasons, only the SEAT approved basic supports and roof carrier
systems can be used.
When should the roof carrier system be removed?
xWhen it is not being used.
xWhen the vehicle is being washed in a car wash.
xWhen the vehicle height exceeds the maximum height (for example, in a
garage).
Additional information and warnings:
xLight Ÿpage 113
xTransporting Ÿpage 13
xEcological driving Ÿpage 252
xWheels and tyres Ÿpage 323
xAccessories, parts replacement, repairs and modifications Ÿpage 285
WARNING
The risk of an accident is increased by transporting heavy or bulky loads on
the roof, which affects the car's handling by shifting the centre of gravity
and increasing susceptibility to cross winds.
xAlways secure loads correctly with suitable and undamaged attach-
ment rope or straps.
xLarge, heavy, wide and flat loads negatively affect the vehicle aerody-
namics, centre of gravity and handling.
xAvoid brusque manoeuvres and sudden braking.
xAdjust your speed and driving style to visibility, road, traffic and
weather conditions.
Caution
xAlways remove the roof carrier system from the roof before entering a car
wash.
xThe height of your vehicle is changed by the installation of the roof carrier
and the load secured on it. Compare the vehicle height with the passage
height, for example in underground car parks or entering garage doors.
xThe roof antenna, the range of the panoramic sliding roof and the tailgate
should not be affected by the roof carrier system and the load being trans-
ported.
xTake extra care not to let the tailgate strike the roof load when opening.
For the sake of the environment
The vehicle uses more fuel when the roof carrier system is fitted.
WARNING (continued)

Seats and storage compartments 160
Securing the base supports and roof carrier system
The mounts are the basis of a complete roof carrier system. Special fixtures
must then be added in order to safely transport luggage, bicycles, skis, surf
boards or boats on the roof. All these system components are available from
an Authorised Service Centre.
It will only be possible to install a basic support or roof carrier system if the
vehicle has a roof rail.
Securing the base supports and roof carrier system
Always secure the base supports and roof carrier system correctly.
The roof carrier system must always be installed exactly according to the
instructions provided.
The position holes are located on the inner side of the rail Ÿfig. 107.
WARNING
If the base supports and the roof carrier system are incorrectly fitted or
used in an unsuitable manner, the entire system could break free causing
accident and injury.
xAlways take the manufacturer assembly instructions into account.
xOnly use base supports and roof carrier systems that are not damaged
and are correctly fitted.
xThe base support should only be fitted to the points indicated in the
diagram Ÿfig. 107.
xSecure the base supports and roof carrier system correctly.
xCheck the screw fittings and attachments before driving and after a
short distance. During each long journey, check the attachments during
every break.
xAlways fit the roof carrier system correctly for wheels, skis and surf-
boards.
xNever change or repair the basic supports or roof carrier system.
Note
Read and take into account the instructions included with the roof carrier
system fitted and keep them in the vehicle.
Loading the roof carrier system
Loads can only be correctly secured when the roof carrier system is correctly
fitted Ÿ.
Maximum authorised roof load
The maximum authorised roof load is 100 kg (about 220 lbs). The roof load
includes the roof carrier system and the load being transported Ÿ.
Fig. 107 Attachment
points for the basic
support and the roof
carrier system.

Seats and storage compartments161
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a Always check the roof carrier system weight and the weight of the load to be
transported and, if necessary, weigh them. Never exceed the maximum
authorised roof load.
If you are using a roof carrier with a lower weight rating, you cannot transport
the maximum roof load. Do not exceed the maximum weight limit for the roof
carrier given in the fitting instructions.
Distributing a load
Uniformly distribute loads and secure them correctly Ÿ.
Check attachments
After fitting the base supports and the roof carrier system, always check the
attachments after a short trip or at regular intervals.
WARNING
Exceeding the maximum authorised roof load can result in accidents
and/or vehicle damage.
xAlways respect the maximum authorised weight for the roof, the
maximum authorised weight on the axles and the total maximum author-
ised weight of the vehicle.
xNever exceed the capacity of the roof carrier system even if this is less
than the maximum authorised roof load.
xSecure heavy objects towards the front and distribute the load evenly.
WARNING
Loose and incorrectly secured loads can fall from the roof carrier system
causing accidents and injury.
xAlways use suitable ropes and straps in good condition.
xAlways secure loads correctly.

Seats and storage compartments163
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Spectacle case in the roof console
To open, press and release the button Ÿfig. 108 (arrow).
To close, press the cover upwards until it clicks into place.
To ensure the passenger compartment monitoring works correctly, the spec-
tacle case must be closed when the vehicle is locked Ÿpage 90.
Compartment in the roof console*
To open, press and release the button Ÿfig. 109.
To close, press the storage compartment upwards until it clicks into place.
To ensure passenger compartment monitoring works properly, the storage
compartments must be closed when the vehicle is locked.
Fig. 108 On the roof
console: Sunglasses
storage compartment.Fig. 109 On the roof
console: Storage
compartment.

Seats and storage compartments169
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Other storage compartments
Side compartments in the luggage compartment
There are other compartments Ÿfig. 120 and in the side of the
luggage compartment. To open the compartment , turn the catch clock-wise. To open the compartment , lift the cover. The factory-fitted CD
changer can be located in the storage compartment .. The cover of the
compartment can be used to safely store the covers of the rear shelf
supports.
Compartments in the luggage compartment floor
More storage compartments can be found in the luggage compartment floor.
Other storage compartments:
xin the centre console, front and rear.
xin the door trims, front and rear.
xCoat hooks on the central door pillars and on the rear roof handles.
xBag hook in the luggage compartment Ÿpage 146.
Fig. 120 In the luggage
compartment: Side
storage compartment.
Fig. 121 Other compart-
ments in the luggage
compartment floor
A1A2A1
FunctionNecessary operations
Open the front compartment
Ÿfig. 121 :„ Pull the front of the luggage compart-
ment floor back using the handle.
Open the rear compartment
Ÿfig. 121 :„ Lift the rear of the luggage compartment
floor using the handle.
Keeping the rear compartment
open:„ Move the hook at the rear right of the
luggage compartment and hook the lug-
gage compartment floor onto it
Ÿpage 146.
Closing the compartment:
„ Push back the hook and push the rear of
the luggage compartment floor down.
„ Fold the front part of the luggage com-
partment floor forwards .
A2A1A1
A3
A4
A4
A3