
12
Before driving off...1 Light switch, Page 78, 80
2 Ignition/starter switch, Page 72
3 Turn signal/headlight dimmer,
flasher lever, Page 81
4 Lever for on-board computer, Page 130
5Horn
6 Lever for automatic speed control, Page 84
7 Wiper/washer lever, Page 82
8 Stopwatch, Page 140
9 Interior temperature sensor
10 Emergency flasher switch, Page 77
11 Central locking button, Page 20, 23
12 Cupholder, Page 86
13 Seat heating/ventilation left/right,  Page 37, 38
14 Operating panel for air conditioning, Page 106
15 Sport/Sport Plus program, Page 61 Retactable spoiler, Page 67
Porsche Active Suspension Management
(PASM), Page 66
Porsche Stability Management 
(PSM), Page 63
Sports exhaust system, Page 55
16 Operating panel for Porsche Communication  Management (PCM), see separate operating 
instructions 

30
Operation, Safety
Folding in door mirrors
 Warning!
Danger of injury to fingers if the mirror 
accidentally flips back  when being folded in.
f Exercise extreme caution when folding in mir-
ror by hand. Do not let go of the mirror before 
the locking lever is locked  or the mirror is fully unfolded. 1. Push mirror towards the door window and 
continue to hold it (high spring force).
2. Swivel the locking lever up to the stop and  slowly let go of the mirror.
Unfolding door mirrors1. Push mirror towards the door window and continue to hold it (high spring force). The 
locking lever disengages automatically.
2. Move mirror back to unfolded position by hand.  Do not let go of the  mirror beforehand.
A-Sensor
B - Switch for automatic anti-glare operation
C - Light-emitting diode Automatic Anti-Glare Interior 
Mirror and Door Mirror Sensors on the front and re ar sides of the interior 
mirror measure the incident light.
The mirrors automatically change to anti-glare po-
sition or revert to their normal state, depending on 
the light intensity. 
When reverse gear is selected, automatic anti-
glare operation is switched off.  

Operation, Safety
31
Note 
The incident light in the area of the sensors must 
not be restricted, e.g. by stickers on the wind-
shield. 
Switching off the automatic anti-glare 
operation 
fPress switch  B.
Light-emitting diode  C goes out. 
Switching on the automatic anti-glare 
operation 
f Press switch  B.
Light-emitting diode  C lights up.
 Warning!
Risk of injury. Electrolyte fluid can emerge 
from a broken mirror glass. 
This fluid irritates the skin and eyes. 
f If the electrolyte fluid should come into contact 
with the eyes or skin, immediately rinse it off 
with clean water.
See a doctor if necessary.
Risk of damage to the paintwork, leather and 
plastic parts. Electrolyte fluid can be 
removed only while it is still wet. 
f Clean the affected parts with water.  The mirror heater is ready for operation when the 
ignition is on.
Switching on f
Press button.
The light-emitting diode in the button lights up.
After approx. 15 minutes, the heater switches off 
automatically. 
The heater can be switched back on by pressing 
the button again.Switching off f Press button.
The light-emitting diode in the button goes out.
Rear Window Defogger, 
Door Mirror Heating 

Operation, Safety
59
ABS Brake System
(Antilock Brake System)The ABS system represents a major contribution 
to the enhancement of active safety in your vehi-
cle. This system prevents the wheels from locking 
in a panic stop on almost all road surfaces. 
With the ABS system in your vehicle, the 
following areas are enhanced: 
Steering, vehicle remains steerable under all 
braking forces when ABS is engaged. 
Good directional control , no swerving caused 
by locking of wheels under braking conditions. 
Shorter stopping distance , stopping distances 
are usually reduced because controlled braking is 
maximized. 
Prevention of wheel lock up , no brake- induced 
sliding and thus no localized tire wear from emer-
gency braking. 
The crucial advantage of the ABS system over a 
conventional brake system is in the area of main-
taining directional control and maneuverability of 
the car in emergency situations. 
 Warning! 
The increased control that is provided should 
not induce you to take greater risks with your 
safety. The limits dictated by the laws of 
physics cannot be overcome, even with ABS.
The risk of accidents due to inappropriate 
speed cannot be reduced, even by the ABS.
The driver bears the responsibility for all 
driving maneuvers. 
f Adapt your driving style to the prevailing road 
and weather conditions. 
f Obey all traffic laws. 
Other vehicles not equipped with the ABS 
system may not be able to maintain control, 
especially on wet or  poor road surfaces and 
thus may be more likely to impact you from 
behind. 
f To minimize that risk, use your ABS system to 
increase your ability to  maneuver to avoid dan-
gerous situations and not merely to try to stop in the shortest distance possible. 
Operation of the ABS systemA wheel speed sensor is mounted to each of the 
four wheels. If wheel lock -up of either of the front 
wheels or the rear wheels is sensed during brak-
ing, the brake pressure is  adjusted automatically 
until the wheel no longer slips. 
If braking forces approach the wheel lock-up point 
for all wheels (panic brak ing) the ABS system will 
intervene to provide a rapid rythmic braking. The 
proper operation of ABS is perceived by the driver 
as a pulsating brake pedal in conjunction with au-
dible noise and perhaps some vibration.
f If you experience these sensations while driv-
ing or a road surface with questionable trac-
tion, reduce vehicle speed appropriate for the 
prevailing road conditions.
f If full braking should be necessary, press the 
brake pedal all the wa y down throughout the 
entire braking procedure, regardless of the pul-
sating pedal. Do not ease up on pressure ap-
plied to the pedal.
The functional readiness of  all the main electrical 
components of the ABS is checked by an 
electronic monitoring system both before and 
while you drive.  

60
Operation, Safety
When the ignition is switched on the ABS warning 
light will light up while the system is electronically 
interrogated and goes o
ut when the engine is 
started if the check is not yet complete. 
If the ABS warning lamp fails to go out, this indi-
cates that ABS has been deactivated due to a 
fault. If the warning lights in the instrument panel 
and on-board computer light up while you are driv-
ing, this indicates that a fault has occurred. In both 
cases, normal braking, as in vehicles without ABS, 
is still retained. 
The ABS system should, however, be examined at 
an authorized Porsche dealer immediately to pre-
vent the occurrence of further faults. 
f If the ABS system becomes inoperative, take 
your vehicle to your authorized Porsche dealer 
immediately. 
 Warning! 
Risk of an accident, resulting in serious per-
sonal injury or death.
The control unit of the ABS brake system is 
set for standard tire size. If non-standard 
tires are installed, the control unit may mis-
interpret the speed of th e vehicle, because of 
the variant data it rece ives from the sensors 
on the axles.
f Use only tire makes and types tested by Porsche.
Clutch Pedal The clutch pedal must be depressed fully 
before the starter will engage. 
 Warning!
Risk of an accident, resulting in serious per-
sonal injury or death. 
f Always check the movement of the clutch ped-
al before driving and make sure that it is not 
obstructed by a floor mat or any other object. 
f Secure the floor mat to prevent it from sliding 
into positions that could  interfere with the safe 
operation of your vehicle.
Your Porsche dealer will be glad to offer you 
nonskid floor mats of the correct size.
To avoid damage to the clutch and transmis-
sion: 
f Always depress the clutch pedal fully when 
changing gears. 
f Do not hold the car on a steep grade with the clutch pedal partially depressed. 
Should the free travel of the clutch pedal suddenly 
become larger, it could me an a malfunction of the 
clutch. 
f See your Porsche dealer for correction. 
Warning light USA
Warning light Canada 

Operation, Safety
63
Porsche Stability Management 
(PSM)PSM is an active control system for stabilization of 
the vehicle approaching the performance limits of 
driving maneuvers.
 Warning!
Risk of an accident, resulting in serious per-
sonal injury or death.
The increased control that is provided should 
not induce you to take greater risks with your 
safety. The limits dictated by the laws of 
physics cannot be overcome, even with PSM.
The risk of accidents due to inappropriate 
speed cannot be reduced, even by PSM.
The driver bears the responsibility for all 
driving maneuvers. 
f Adapt your driving style to the prevailing road 
and weather conditions. 
fObey all traffic laws. 
Sensors at the wheels, brakes, steering system 
and engine continuously measure:
–Speed
– Direction of travel (steering angle)
– Lateral acceleration
– Rate of turn about the vertical axis
– Longitudinal acceleration PSM uses these values to determine the direction 
of travel indicated by the driver.
PSM intervenes and helps to correct the course if 
the actual direction of motion deviates from the 
chosen course (steering-wheel position):
It brakes individual wheels as needed. In addition, 
the engine power may be manipulated in order to 
stabilize the vehicle.
The events below inform the driver of PSM control 
operations and warn him/her to adapt his/her 
driving style to the road conditions:
– The multifunctional in
formation light on the 
instrument panel flashes.
– Hydraulic noises can be heard.
– The vehicle decelerate s and steering-wheel 
forces are altered as the PSM controls the 
brakes.
– Reduced engine power.
– The brake pedal pulsates and its position is  changed during braking.
In order to achieve full vehicle deceleration, 
foot pressure must be increased after the 
brake pedal has begun vibrating.
Examples of PSM control operations– If the front wheels of the vehicle drift on a 
bend, the rear wheel on the inside of the bend 
is braked and the engine power is reduced if 
necessary.
– If the rear of the vehicle swings out on a bend,  the front wheel on the outside of the bend is 
braked.Additional braking functions– Pre-filling the brake system:The brake system is prepared for possible 
subsequent emergency braking if the acceler-
ator pedal is released suddenly and quickly. 
The brake system is prefilled and the brake 
pads are already applied gently to the brake 
discs.
– Brake booster: In the event of an emergency braking operation 
where the pedal force is insufficient, a brake 
booster provides the braking pressure neces-
sary for maximum deceleration at all 4 wheels.Advantages of PSM– Best possible traction and lane-holding ability in all driving situations – even on road surfaces 
with varying friction. 

70
Operation, Safety
Parking Aids Parking assistantWhen the driver backs up, the parking assistant 
system indicates the distance between the car 
and a large obstacle behind it, by means of signal 
tones. 
 Warning!
Risk of serious personal injury or death. 
Parking assistant cannot detect small ob-
jects such as children and pets.
Despite use of the parking assistant system, 
the driver is still responsible for taking due 
care and assessing obstacles when backing 
up. 
f Make sure that no persons, especially small 
children, animals or obstacles are within the maneuvering area. 
The parking assistant syst em is activated auto-
matically when reverse gear is selected and the ig-
nition is on.
Note 
Be aware that the parkin g assistant system is 
not  switched on if the car rolls backward without 
reverse gear being engaged.
Ultrasound sensors Sensors 
Four ultrasound sensors in the rear bumper meas-
ure the distance to the closest obstacle.
– Range middle sensors around 60 in./150 cm 
– Range outer sensors around 24 in./60 cm
Obstacles cannot be detected in the “blind” sen-
sor area (e.g. near the ground).  Note 
The sensors must always be kept free of dirt, ice 
and snow in order to ensure that they are fully 
functional. 
 Caution!
To avoid damaging the sensors: 
f Maintain sufficient distance when cleaning with steam-jet units. 
Signal tones/function 
When reverse gear is selected, the parking 
assistant confirms that it is switched on by issuing 
a  short signal tone .
A detected obstacle is signalled by an  intermit-
tent tone . The intervals decrease as the obstacle 
is approached.
A continuous tone sounds when the distance 
becomes less than one foot. This continuous tone 
c a n  s t o p  i f  t h e  o b s t a c l e  i s  a p p ro a c h e d  c l o s e r  t h a n  
one foot.
The radio volume should no t be so loud as to 
drown out the signal tones. 

Operation, Safety
71
Limits of ultrasonic measurement 
The parking assistant system cannot detect:
– sound-absorbing obstacles (e.g. powder snow), 
– sound-reflecting obstacles (e.g. glass surfac- es, flat painted surfaces) 
– and very thin obstacles. 
– Other ultrasound sources (e.g. pneumatic  brakes of other vehicles, jackhammers) can 
interfere with detection of obstacles. 
Fault indication 
The parking assistant system indicates a fault in 
two ways:
– After reverse gear has been selected, the  short signal tone is followed by a continuous 
tone of the  same pitch:
This indicates that sensors are soiled or cov-
ered with ice. 
– After reverse gear has been selected, the  short signal tone is followed by a continuous 
tone with a much  lower pitch:
This indicates a general system fault. 
Please have the fault remedied at an author-
ized Porsche dealer. A
- Control switch for door mirror adjustment Swivelling down mirror glass as a parking 
aidf
Please see the chapter “SEAT MEMORY” on 
Page 35.
– When reverse gear is engaged, the mirror  glass on the passenger’s side swivels down 
slightly to show the curb area.  Preconditions
– Vehicle must be equipped with seat memory.
– Set the control switch 
A to “passenger’s side”.
– Reverse gear must be engaged.
Returning mirror glass to its original position
f Drive forwards with a speed of over 4 mph 
(6 km/h)  or
f Set the control switch A  to “driver’s side”.