2010 PONTIAC G5 height

Seat Height Adjuster
To raise or lower the driver seat, move the lever upward
or downward repeatedly until the seat is at the desired
height.
SeeSeat Height Adjuster on page 2-3 .
Reclining Seatbacks
To recline the seatback, do the following:
1. Lift the recline lever.
2. Move the seatback to the desired position, then release the lever to lock the seatback in place.
3. Push and pull on the seatback to make sure it is locked.
See Reclining Seatbacks on page 2-4 .
1-7

Front Seats..................................................... .2-2
Manual Seats ............................................... .2-2
Seat Height Adjuster ...................................... .2-3
Manual Lumbar ............................................. .2-3
Heated Seats ................................................ .2-4
Reclining Seatbacks ....................................... .2-4
Head Restraints ............................................ .2-7
Easy Entry Seat (Coupe) .................................2-8
Rear Seats ...................................................... .2-9
Split Folding Rear Seat .................................. .2-9
Safety Belts .................................................. .2-11
Safety Belts: They Are for Everyone ................2-11
How to Wear Safety Belts Properly .................2-16
Lap-Shoulder Belt ........................................ .2-25
Safety Belt Use During Pregnancy ..................2-31
Safety Belt Extender .................................... .2-31
Child Restraints ............................................ .2-32
Older Children ............................................. .2-32
Infants and Young Children ............................2-35
Child Restraint Systems .................................2-39
Where to Put the Restraint .............................2-41Lower Anchors and Tethers for Children
(LATCH) ................................................. .2-43
Securing a Child Restraint in a Rear Seat Position .................................................. .2-49
Securing a Child Restraint in the Right Front Seat Position ........................................... .2-52
Airbag System .............................................. .2-55
Where Are the Airbags? ................................2-58
When Should an Airbag Inflate? .....................2-60
What Makes an Airbag Inflate? .......................2-61
How Does an Airbag Restrain? .......................2-61
What Will You See After an Airbag Inflates? .....2-62
Passenger Sensing System ............................2-64
Servicing Your Airbag-Equipped Vehicle ...........2-69
Adding Equipment to Your Airbag-Equipped Vehicle ................................................... .2-70
Restraint

System Check ................................. .2-71
Checking the Restraint Systems ......................2-71
Replacing Restraint System Parts After a Crash ..................................................... .2-72
Section 2 Seats and Restraint System
2-1

Seat Height Adjuster
The driver’s seat height adjuster is located on the
outboard side of the seat.
To raise the seat, move the lever upward repeatedly
until the seat is at the desired height. To lower the seat,
move the lever downward repeatedly until the seat is
at the desired height.
Manual Lumbar
On vehicles with this
feature, the knob is
located on the front of the
driver seat lower cushion
on the inboard side.
Turn the knob clockwise or counterclockwise to increase
or decrease the lumbar support.
2-3

Head Restraints
Adjust the head restraint so that the top of the restraint
is at the same height as the top of the occupant’s
head. This position reduces the chance of a neck injury
in a crash.Pull the head restraint up to
raise it. To lower the head
restraint, press the button,
located on the top of the
seatback, and push the
restraint down.
2-7

4. Push the latch plate into the buckle until it clicks.Pull up on the latch plate to make sure it is secure.
If the belt is not long enough, see Safety Belt
Extender on page 2-31 .
Position the release button on the buckle so that
the safety belt could be quickly if necessary.
5. If equipped with a shoulder belt height adjuster, move it to the height that is right for you. See
“Shoulder Belt Height Adjustment” later in this
section for instructions on use and important safety
information. 6. To make the lap part tight, pull up on the
shoulder belt.
It may be necessary to pull stitching on the safety
belt through the latch plate to fully tighten the
lap belt on smaller occupants.
2-26

To unlatch the belt, push the button on the buckle. The
belt should return to its stowed position.
Before a door is closed, be sure the safety belt is out of
the way. If a door is slammed against a safety belt,
damage can occur to both the belt and the vehicle.
Shoulder Belt Height Adjuster
(Sedan Only)
The vehicle has a shoulder belt height adjuster for the
driver and right front passenger position.
Adjust the height so that the shoulder portion of the belt
is centered on the shoulder. The belt should be away
from the face and neck, but not falling off the shoulder.
Improper shoulder belt height adjustment could
reduce the effectiveness of the safety belt in a crash.Press the release
button (A) and move the
height adjuster to the
desired position. The
adjuster can be moved up
by pushing up on the
shoulder belt guide.
After the height adjuster is set to the desired position,
try to move it down without pressing the release
button to make sure it has locked into position.
2-27

Child Restraints
Older Children
Older children who have outgrown booster seats should
wear the vehicle’s safety belts.The manufacturer’s instructions that come with the
booster seat state the weight and height limitations for
that booster. Use a booster seat with a lap-shoulder belt
until the child passes the below fit test:
•Sit all the way back on the seat. Do the knees bend
at the seat edge? If yes, continue. If no, return to
the booster seat.
•Buckle the lap-shoulder belt. Does the shoulder belt
rest on the shoulder? If yes, continue. If no, try
using the rear safety belt comfort guide. See “Rear
Safety Belt Comfort Guides” under
Lap-Shoulder
Belt on page 2-25 for more information. If the
shoulder belt still does not rest on the shoulder,
then return to the booster seat.
•Does the lap belt fit low and snug on the hips,
touching the thighs? If yes, continue. If no, return to
the booster seat.
•Can proper safety belt fit be maintained for the
length of the trip? If yes, continue. If no, return
to the booster seat.
•If you have the choice, a child should sit in a
position with a lap-shoulder belt and get the
additional restraint a shoulder belt can provide.
2-32

Q:What are the different types of add-on child
restraints?
A:Add-on child restraints, which are purchased by the
vehicle’s owner, are available in four basic types.
Selection of a particular restraint should take
into consideration not only the child’s weight, height,
and age but also whether or not the restraint will
be compatible with the motor vehicle in which it will
be used.
For most basic types of child restraints, there are
many different models available. When purchasing a
child restraint, be sure it is designed to be used
in a motor vehicle. If it is, the restraint will have a
label saying that it meets federal motor vehicle
safety standards.
The restraint manufacturer’s instructions that come
with the restraint state the weight and height
limitations for a particular child restraint. In addition,
there are many kinds of restraints available for
children with special needs.
{WARNING:
To reduce the risk of neck and head injury during
a crash, infants need complete support. This is
because an infant’s neck is not fully developed
and its head weighs so much compared with the
rest of its body. In a crash, an infant in a
rear-facing child restraint settles into the restraint,
so the crash forces can be distributed across the
strongest part of an infant’s body, the back and
shoulders. Infants should always be secured in
rear-facing child restraints.
2-38