2010 PEUGEOT 5008 ECO mode
[x] Cancel search: ECO modePage 227 of 331
PRACTICAL INFORMATION
195
Let the engine run for the
d u r a t i o n s p e c i fi e d t o e n s u r e
that the battery charge is suf-
fi c i e n t .
Do not repeatedly and continuously
restart the engine in order to charge
the battery.
A fl a t b a t t e r y p r e v e n t s t h e e n g i n e
from starting (refer to the "Battery"
paragraph). If the telephone is being used
a t t h i s t i m e :
- it will be maintained for 5 minutes with the hands-free kit of your
Peugeot Connect Sound or
Peugeot Connect Navigation,
- i t w i l l s t i l l b e p o s s i b l e t o fi n i s h t h e call with the Peugeot Connect
Media.
Exiting economy mode
These functions are reactivated auto-
m a t i c a l l y n e x t t i m e t h e v e h i c l e i s d r i v e n .
In order to resume the use of these
functions immediately, start the en-
g i n e a n d l e t i t r u n :
- for less than ten minutes, to use t h e e q u i p m e n t f o r a p p r o x i m a t e l y
fi v e m i n u t e s ,
- for more than ten minutes, to use t h e e q u i p m e n t f o r u p t o a p p r o x i -
mately thirty minutes.
CHANGING A WIPER BLADE
Removing
Raise the corresponding wiper arm.
Unclip the wiper blade and remove it.
Fitting
Put the corresponding new wiper
blade in place and clip it.
Fold down the wiper arm carefully.
Before removing a front wiper
blade
Within one minute after switching off
the ignition, operate the wiper stalk
to position the wiper blades verti-
cally on the windscreen.
After fitting a front wiper blade
Switch on the ignition.
Operate the wiper stalk again to
park the wiper blades.
LOAD REDUCTION MODE
System which manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air condi-
tioning, the heated rear screen...
The deactivated functions are reactivat-
ed automatically as soon as conditions
permit.
ENERGY ECONOMY MODE
System which manages the duration of
use of certain functions to conserve a
s u f fi c i e n t l e v e l o f c h a r g e i n t h e b a t t e r y .
After the engine has stopped, you can
still use functions such as the audio and
telematics system, windscreen wip-
ers, dipped beam headlamps, courtesy
l a m p s , e t c . f o r a m a x i m u m c o m b i n e d
duration of thirty minutes.
Switching to economy mode
Once the thirty minutes are over, a
message appears on the multi-function
screen indicating that the vehicle has
switched to economy mode and the ac-
tive functions are put on standby.
Page 274 of 331
241
5
6
SETUP 1
2
3
4
0 9 CONFIGURATION
SETTING THE DATE AND TIME
Set the parameters using the ring and move on to the next usingthe 4-direction navigator. P r e s s O K t o c o n fi r m .
Select the "Date format" function and p r e s s O K t o c o n fi r m . Select the format required using the r i n g a n d p r e s s O K t o c o n fi r m .
Select the "Set date & time" function a n d p r e s s O K t o c o n fi r m .
Pressing the SETUP button for more than 2 seconds peds permits a c c e s s t o :
This setting operation must be carried out if the battery httery has been disconnected.
Press the SETUP button.
Select the "Time format" function and p r e s s O K t o c o n fi r m . Select the format required using t h e r i n g a n d p r e s s O K t o c o n fi r m .
SET DATE & TIME
Select the "Date & Time" function and p r e s s O K t o c o n fi r m .
DESCRIPTION OF THE UNIT
G P S C O V E R A G E
DEMO MODE
DATE & TIME
P r i n c i p l e o f t h e G P S s y n c h r o ( G M T ) : 1 . C o n fi r m t h e " S y n c h r o n i s e w i t h G P S " s e l e c t i o n , t h e t i m e i s t h e n s e t t o G M T u n i v e r s a l t i m e , t h e d a t e is also updated. 2 . U s i n g t h e 4 - d i r e c t i o n n a v i g a t o r , m o v e t h e c u r s o r t o t h e t i m e fi e l d s a n d p r e s s O K . 3 . Y o u c a n t h e n u s e t h e r i n g t o s e t t h e t i m e t o t h e t i m e z o n e o f y o u r c h o i c e . T a k e c a r e w h e n c h a n g i n g b e t w e e n s u m m e r / w i n t e r t i m e , t h e t i m e z o n e m u s t b e c h a n g e d a g a i n manually.
This function provides access to the options in the SETUP menu.
Page 279 of 331
246
sound quality between the different audio s o u r c e s ( r a d i o , C D . . . ) .
Check that the audio settings (Volume, Bass, T r e b l e , A m b i e n c e , L o u d n e s s ) a r e a d a p t e d t o the sources listened to. It is advisable to set the AUDIO functions (Bass, Treble, Front-Rear B a l a n c e , L e f t - R i g h t B a l a n c e ) t o t h e m i d d l e position, select the musical ambience "Linear" and set the loudness correction to the "Active" position in CD mode or to the "Inactive" position in radio mode.
For optimum sound quality, the audio settings (Volume, Bass, Treble, A m b i e n c e , L o u d n e s s ) c a n b e a d a p t e d t o t h e d i f f e r e n t s o u n d s o u r c e s , which may result in audible differences when changing source ( r a d i o , C D . . . ) .
The CD is ejected automatically or is not played by the player.
- Check that the CD is inserted in the playerthe right way up. - C h e c k t h e c o n d i t i o n o f t h e C D : t h e C D c a n n o t be played if it is too damaged. - Check the content in the case of a recorded C D : c o n s u l t t h e a d v i c e i n t h e " A u d i o " s e c t i o n . - The audio equipment's CD player does not play DVDs. - Due to inadequate quality, certain recorded CDs will not be played by the audio system.
The CD is inserted upside down, is unplayable, does not contain any audio data or contains an audio format which the player cannot play.
The CD is protected by an anti-pirating protection system which is not recognised by the audio equipment.
The CD player sound is poor. Insert good quality CDs and store them in suitable conditions. The CD used is scratched or of poor quality.
T h e a u d i o e q u i p m e n t s e t t i n g s ( b a s s , t r e b l e , a m b i e n c e s ) a r e u n s u i t a b l e . Set the treble or bass level to 0, without selecting an ambience.
The table below groups together the answers to th e most frequently asked questions concerning the Pe ugeot Connect Media.
QUESTION SOLUTION ANSWER
FREQUENTLY ASKED QUESTIONS
Page 280 of 331
247
SOLUTION ANSWER
The stored stations do not function (no sound, 8 7 . 5 M h z i s d i s p l a y e d . . . )
An incorrect waveband is selected.
The quality of reception of the radio station listened to gradually deteriorates or the stored stations do not function (no s o u n d , 8 7 . 5 M h z i s d i s p l a y e d . . . ) .
Activate the "RDS" function by means of the short-cut menu to enable the system to check whether there is a more powerful transmitter in the geographical area.
Press RADIO, select Radio Menu then "Waveband" to return to the waveband on which the stations are stored.
The vehicle is too far from the transmitter used by the station listened to or there is no transmitter in the geographical area th rough which the vehicle is travelling.
T h e e n v i r o n m e n t ( h i l l s , b u i l d i n g s , t u n n e l s , b a s e m e n t c a r p a r k s . . . ) b l o c k reception, including in RDS mode.
Sound cut-outs of 1 to 2 seconds in radio mode.
During this brief sound cut-out, the RDS searches for any frequency permitting better reception of the station. Deactivate the "RDS" function by means of the short-cut menu if the phenomenon is too frequent and always on the same route.
With the engine off,the system switches off after a few minutes of use.
When the engine is switched off, the system's oper ating time depends on the battery charge.
T h e s w i t c h - o f f i s n o r m a l : t h e s y s t e m s w i t c h e s t o e c o n o m y m o d e a n d switches off to prevent discharging of the vehicle's battery.
Start the vehicle's engine to increase the battery charge.
This phenomenon is normal and does not indicate a failure of the audio equipment.
Have the aerial checked by a PEUGEOT dealer. The aerial is absent or has been damaged (for exam ple when going through a c a r w a s h o r i n t o a n u n d e r g r o u n d c a r p a r k ) .