2010 PEUGEOT 308 SW BL ESP

1
!
i
194
PRACTICAL INFORMATION
A fl at battery prevents the engine
from starting (refer to the corre-
sponding paragraph). If the telephone is being used at
this time:


- it will be maintained for 10 minutes
with the hands-free kit of your
Peugeot Connect Sound,

-
it will be maintained for 10 minutes
with the Peugeot Connect Navi-
gation or the Peugeot Connect
Media, then it will transfer to your
telephone depending on the tele-
phone model.


System which manages the duration of
use of certain functions to conserve a
suffi cient level of charge in the battery.
After the engine has stopped, you can
still use functions such as the audio and
telematics system, windscreen wip-
ers, dipped beam headlamps, courtesy
lamps, etc. for a maximum combined
duration of thirty minutes.

Exiting economy mode

These functions are reactivated auto-
matically next time the vehicle is driven.


)
In order to resume the use of these
functions immediately, start the
engine and let it run:


- for less than ten minutes, to use
the equipment for approximately
fi ve minutes,

- for more than ten minutes, to
use the equipment for up to
approximately thirty minutes.



Switching to economy mode

Once the thirty minutes are over, a
message appears on the multi-function
screen indicating that the vehicle has
switched to economy mode and the ac-
tive functions are put on standby.
CHANGING A WIPER BLADE

Removing



)
Raise the corresponding wiper arm.

)
Unclip the wiper blade and remove it.



Fitting



)
Put the corresponding new wiper
blade in place and clip it.

)
Fold down the wiper arm carefully.



Before removing a front wiper
blade


)
Within one minute after switching off
the ignition, operate the wiper stalk
to position the wiper blades vertically
on the windscreen.



After fitting a front wiper blade



)
Switch on the ignition.

)
Operate the wiper stalk again to
park the wiper blades.

LOAD REDUCTION MODE
System which manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air condition-
ing, the heated rear screen...
The deactivated functions are reactivated
automatically as soon as conditions permit.

241
7
8
10
9
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK11
03
Repeat steps 5 to 7 for the "Street" and "House number" functions.


To delete a destination; from steps 1 to 3, select "Chooose from lastdestinations". A long press on one of the destinations displays a list of actions from which you can select:
Select the "Save to address book" function to record tthe address entered in a directory fi le. Press OK to confi rm the selection.The Peugeot Connect Media permits the recording off more than 4 000 contact fi les.


To speed up the process, the post code can be entereed directly after selecting the "Postal code" function.
Use the virtual keypad to enter the letters and digits.

Select the route type:
"Fast route", "Short route", or "Optimized route" and press OK toconfi rm.


Then select "Start route guidance" and the press OK to confi rm.


It is also possible to select a destination via "Choose frrom address book" or "Choose from last destinations", by selecting a junction, atown centre, geographic coordinates, or directly on thee "Map".
CHOOSE FROM ADDRESS BOOK
CHOOSE FROM LAST DESTINATIONS


START ROUTE GUIDANCE
It is possible to scroll the map using the 4-direction navigator. It is possible to select its orientation via the short-cut menu of the "Full screen map". Press OK then select "Map Settings" and confi rm.

Select the road with the colour corresponding to the route chosen and press OK to confi rm and startguidance.


Turn the ring and select OK.
Press OK to confi rm.
DELETE ENTRY DELETE LLIST

NAVIGATION - GUIDANCE

250
RADIO
11
2
3
05
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
RADIOMEDIANAVESCTRAFFICADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK

SELECTING A STATION


When the current radio station is displayed on the screen, press OK.


The radio source short-cuts menu appears and providees access to the following short-cuts:

Select the function required and pressOK to confi rm to gain access to thecorresponding settings.
TA


The RDS, if displayed, allows you to continue listening to tthe same station by automatic retuning to alternative frequencies. However, in certain conditions, coverage of an RDS station may not bee assuredthroughout the country as radio stations do not cover 100 % of theterritory. This explains the loss of reception of the station dduring a journey.
The external environment (hill, building, tunnel, underground car park...) may interfere with thereception, including in RDS following mode. This phenomenon is a normal result of the way in which radio waves are transmitted and does not in any way indicate a failure of the audio equipment.


RDS - REGIONAL MODE
Press the RADIO button to displaythe list of stations received locally sorted in alphabetical order.Select the station required by turning the ring and press to confi rm.
Press one of the buttons on the numeric keypad for mmore than 2 seconds to store the current station. A bleep confi rmms that ithas been stored.Press the button on the numeric keypad to recall the sstored radio station.
RDS
RADIOTEXT

REGIONAL PROG.
AM

RADIO
When the "RADIO" screen is displayed, turn thering or use the 4-direction navigator to select theprevious or next station on the list.

While listening to the radio, press buttons and for the automatic search for a lower or higher frequency.

267
SETUP
1
2
3
4
3
4
2
3
3
3
3
2
3
4
4
4
4
2
4
3
2
4
4
3
4
4
3
3
3
4
4
4
4
4
4
4
4
3
4
4
5
5
5
4
5
5
3
"SETUP" MENU

LANGUAGE & SPEECH
Menu language
Deutsch
English
Español
Français
Italiano
Nederlands
Polski
Portuguese
Voice control
Voice control active
Tutorial

Basics
Examples
Tips
Speaker adaptation
New speaker adaptation
Delete speaker adaptation
Voice output volume


DATE & TIME

Set date & time

Date format

Time format


DISPLAY

Brightness

Colour
Steel
blue light (only in day mode)
Orange Ray
Blue Flame

Map colour

Day mode for map

Night mode for map

Auto. Day/Night for map


UNITS

Te mperature
Celsius
Fahrenheit

Metric/Imperial

km

Miles


SYSTEM
Factory reset

Software version

Automatic scrolling

286
3 2 1 1
05
SELECTING A STATION

When the current radio station is displayed on the screen, pressthe dial.


The radio source short-cuts menu appears and providees access to the following short-cuts:

Select the function required and pressthe dial to confi rm to gain access tothe corresponding settings.
TA


RDS, if displayed, allows you to continue listening to thhe same station by automatic retuning to alternative frequenciess. However, incertain conditions, coverage of an RDS station may noot be assured throughout the entire country as radio stations do not ccover 100 % of the territory. This explains the loss of reception of the sstation during a journey.


The external environment (hill, building, tunnel, underground car park...) may interferewith the reception, including in RDS following mode. This phenomenon is a normal resultof the way in which radio waves are transmitted and does not in any way indicate a failure of the audio equipment.
RDS - REGIONAL MODE
Press the RADIO button to displaythe list of stations received locally sorted in alphabetical order.Select the station required by turning the dial and press to confi rm.
While listening to the radio, press one of the buttons to select the previous or next station on the list.
Press one of the buttons on the numeric keypad for mmore than 2 seconds to store the current station.Press the button on the numeric keypad to recall the sstored radio station.
RDS
RADIOTEXT

REGIONAL PROG.
AM

RADIO


A long press of one of the buttons starts theautomatic search for a station with a lower or higher frequency.

289
3 1
2
06
1
4
2
3
5
4

Connect the portable equipment(MP3/WMA player…) to the audiosockets (white and red, RCA type) in the glove box using a JACK/RCA audio cable.
Press the MUSIC button then pressit again or select the Music Menufunction and press the dial to confi rm.
Select the AUX music source andpress the dial to confi rm. Play beginsautomatically.
Select the "External device" function and press the dial to activate it.

EXTERNAL DEVICE


The display and management of the controls is via thee portableequipment.
USING THE EXTERNAL INPUT (AUX)
AUDIO/RCA CABLE NOT SUPPLIED

MUSIC MEDIA PLAYERS

MUSIC MENU

CD CHANGER
SELECT MUSIC

MUSIC MENU


Insert one or more CDs in the changer. Press the MUSIC button.

Press one of the buttons on the numeric keypad to select thecorresponding CD.

Select the "CD Changer" musicsource and press the dial to confi rm.

Select the "Select music" function and press the dial to confi rm.
CD CHANGER
PLAYING A CD (NOT MP3/WMA COMPATIBLE)


Press the MUSIC button again or select the Music Menu function and press the dial to confi rm.

296
1
2
3
4
1
3
4
3
4
2
2
2
3
4
4
4
4
2
3
3
3
2
3
3
3
2
3
4
4
4
4
2
4
3
4
3
3
3
3
3
3
3
3
2
4
4
2
3
4
4
3
4
4
4
2
3
3
3

"PHONE" MENU"SETUP" MENU


DIAL NUMBER


SETTINGS

Select ring tone

Phone/Ring tone volume

Enter mailbox number



SYSTEM LANGUAGE *
Deutsch
English

Español

Français

Italiano
Nederlands
Polski

Portuguese


DATE & TIME *

Set date & time

Date format

Time format
Dark blue
MAP colour
Day mode for MAP
Night mode for MAP
Auto. Day/Night for MAP
VEHICLE *
Vehicle information
Alert log
Status of functions


DISPLAY

Brightness

Colour
Pop titanium
Toffee
Blue steel
Technogrey
UNITS
Temperature
Celsius
Fahrenheit
Metric/Imperial
Kilometres (Consumption: l/100)
Kilometres (Consumption: km/l)
Miles (Consumption: MPG)
SYSTEM
Factory reset
Software version
Automatic scrolling
*
Available according to model.


DIAL FROM ADDRESS BOOK


CALL LISTS


CONNECT PHONE

Search phone


Phones connected
Disconnect phone
Rename phone

Delete pairing

Delete all pairings
Show details

299

QUESTION



ANSWER SOLUTION

The TA box is selected. However, certain traffi c jams along the route are not indicated in real time.
On starting, it is several minutes before the system begins to receive thetraffi c information.
Wait until the traffi c information is being receivedcorrectly (displaying of the traffi c information symbols on the map).
In certain countries, only major routes (motorways...) are listed for the traffi cinformation.
This phenomenon is normal. The system is dependent on the traffi c information available.

The time taken to calculatea route sometimes seemslonger than usual.
The performance of the system may slow down temporarily if a CD is beingcopied onto the Jukebox at the same time as a route is being calculated.
Wait until the CD has been copied or stop the copying before starting the guidance function.

I receive a speed cameraalert for a camera which is not on my route.
The system announces all speed cameras located in a conical zoneforward of the vehicle. It may detect speed cameras on nearby or parallel roads.

Zoom the map to view the exact position of thespeed camera.

The audible speedcamera alert is not working.

Audible alerts are not active. Activate audible alerts in Navigation Menu,Settings, Set parameters for risk areas.
The alert volume level is set to minimum.
Increase the speed camera alert volume.

The altitude is not displayed. On starting, the initialisation of the GPS may take up to 3 minutes toreceive more than 3 satellites correctly.
Wait until the system has started up completely.Check that there is a GPS coverage of at least3 satellites (long press on the SETUP button, thenselect GPS coverage).
Depending on the geographical environment (tunnel...) or the weather,the conditions of reception of the GPS signal may vary.
This phenomenon is normal. The system is dependent on the conditions of reception ofthe GPS signal.

The route is notcalculated successfully. The exclusion criteria may confl ict with the current location (exclusion of tollroads on a motorway with tolls). Check the exclusion criteria.