2010 PEUGEOT 308 SW BL gearbox
[x] Cancel search: gearboxPage 191 of 336
1
189
PRACTICAL INFORMATION
Engine compartment fuses
The fusebox is placed in the engine
compartment near the battery (left-hand
side).
Access to the fuses
)
Unclip the cover.
)
Change the fuse (see corresponding
paragraph).
)
When you have fi nished, close the
cover carefully to ensure the sealing
of the fusebox.
Fuse table
Fuse N°
Rating
Functions
F1
20 A
Engine control unit supply, injection pump and EGR
electrovalves (2 litre HDI), injectors (2 litre HDI).
F2
15 A
Horn.
F3
10 A
Front/rear wash-wipe.
F4
20 A
Headlamp wash.
F5
15 A
Canister purge, turbine discharge and Turbo
pressure regulation electrovalves (1.6 litre THP
16V), oil vapour heater (1.6 litre THP 16V), diesel
heater (1.6 litre HDI).
F6
10 A
Vehicle speed sensor, ABS/ESP control unit.
F7
10 A
Power steering control unit, automatic gearbox,
engine coolant level detector.
F8
25 A
Starter motor control.
F9
10 A
Diagnostic socket, directional headlamps, air
fl ow sensor (Diesel), particle emission fi lter pump
(Diesel).
F10
30 A
Engine control unit actuators (petrol: ignition coils,
electrovalves, oxygen sensors, injectors, heaters,
fuel pump, electronic thermostat)
(Diesel: electrovalves, heaters).
F11
40 A
Air conditioning blower.
Page 193 of 336
1
191
PRACTICAL INFORMATION
Table of mini and midi-fuses above the battery
Table of maxi-fuses
Fuse N°
Rating
Functions
F1
-
Not used.
F2
5 A
Dual function brake switch.
F3
5 A
Battery charge unit.
F4
25 A
ABS/ESP electrovalves.
F5
-
Not used.
F6
15 A
Gearbox (electronic gear control or automatic).
F7 *
80 A
Power steering electropump assembly.
F8 *
60 A
Fan assembly.
F9 *
70 A/30 A
Pre-heat unit (Diesel)/Valvetronic electric motor
(1.6 litre THP 16V).
F10 *
40 A
ABS/ESP electropump assembly.
F11 *
100 A
Switching and protection unit.
F12 *
30 A
Electronic gear control gearbox electropump assembly.
Fuse N°
Rating
Functions
MF1 *
-
Not used.
MF2 *
30 A
Trailer fusebox.
MF3 *
50 A
Passenger compartment fuse box.
MF4 *
80 A
Built-in systems interface.
MF5 *
80 A
Built-in systems interface.
MF6 *
-
Not used.
MF7 *
30 A
Heated seats.
MF8 *
20 A
Headlamp wash.
*
The midi-fuses and maxi-fuses provide
additional protection for the electrical sys-
tems. All work on these types of fuse must
be carried out by a PEUGEOT dealer.
Page 195 of 336
1
!
i
193
PRACTICAL INFORMATION
Do not disconnect the terminals
while the engine is running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not push the vehicle to start the
engine if it is fi tted with a 6-speed
electronic gear control gearbox.
The batteries contain harmful sub-
stances such as sulphuric acid and
lead. They must be disposed of in
accordance with regulations and
must not, in any circumstances, be
discarded with household waste.
Take used remote control batteries
and vehicle batteries to a special
collection point.
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month.
Before disconnecting the battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the windows and the doors
before disconnecting the battery.
Following reconnection of the
battery
Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit
initialisation of the electronic sys-
tems. However, if problems are en-
countered following this operation,
contact a PEUGEOT dealer.
Referring to the corresponding sec-
tion, you must yourself reinitialise:
- the remote control key,
- the panoramic sunroof blind,
- the GPS satellite navigation
system.
Charging the battery using a
battery charger
)
Disconnect the battery from the
vehicle.
)
Follow the instructions for use
provided by the manufacturer of the
charger.
)
Reconnect starting with the negative
terminal (-).
)
Check that the terminals and connectors
are clean. If they are covered with
sulphate (whitish or greenish deposit),
remove them and clean them.
)
Connect one end of the green
or black cable to the negative
terminal (-) of the slave battery B
.
)
Connect the other end of the green
or black cable to the earth point C
on the broken down vehicle.
)
Operate the starter, let the engine
run.
)
Wait until the engine returns to idle
and disconnect the cables.
Page 197 of 336
1
!i
195
PRACTICAL INFORMATION
TOWING THE VEHICLE
Access to the tools
Towing your vehicle
)
On the front bumper, unclip the
cover by pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps
on the towed vehicle.
)
On the rear bumper, unclip the cover
by pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps
on the towed vehicle.
Towing another vehicle
The towing eye is installed in the boot
under the fl oor.
To gain access to it:
)
open the boot,
)
raise the fl oor,
)
secure it by hooking its cord on
the hook on the rear parcel shelf
support,
)
remove the polystyrene storage box,
)
remove the towing eye from the
holder.
When towing with all four wheels
on the ground, always use a towing
bar.
When towing with only two wheels
on the ground, always use profes-
sional lifting equipment.
When towing with the engine off,
there is no longer any braking or
steering assistance.
)
Place the gear lever in neutral
(position N
on the electronic
gearbox system or automatic
gearbox).
Failure to observe this special
condition could result in damage
to certain braking components
and the absence of braking
assistance the next time the
engine is started.
Procedure for having your vehicle towed
or for towing another vehicle using a re-
movable towing eye.
Page 198 of 336
1
!i
196
PRACTICAL INFORMATION
TOWING THE VEHICLE
Procedure for having your
vehicle towed or for towing
another vehicle using a re-
movable towing eye.
Access to the tools
Towing your vehicle
)
On the front bumper, unclip the
cover by pressing it on the left.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps
on the towed vehicle.
)
On the rear bumper, unclip the cover
by pressing it on the left.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps
on the towed vehicle.
Towing another vehicle
The towing eye is installed in the left-
hand side trim of the boot.
To gain access to it:
)
open the boot,
)
open the access fl ap in the left-hand
side trim,
)
unclip the wheelbrace from its
support,
)
remove the towing eye from the
same support.
When towing with all four wheels
on the ground, always use a towing
bar.
When towing with only two wheels
on the ground, always use profes-
sional lifting equipment.
When towing with the engine off,
there is no longer any braking or
steering assistance.
)
Place the gear lever in neutral
(position N
on the automatic
gearbox).
Failure to observe this special
condition could result in damage
to certain braking components
and the absence of braking
assistance the next time the
engine is started.
Page 203 of 336
1
201
TECHNICAL DATA
MODELS:
ENGINES AND GEARBOXES
Model codes:
4C... 4E... 4H...
8FS-C
8FR-0
5FW-C
5FS-0
5FW-F
5FS-9
PETROL ENGINES
1.4 litre VTi 16V
95 hp
1.4 litre VTi 16V
98 hp
1.6 litre VTi 16V 120 hp
Cubic capacity (cc)
1 397
1 397
1 598
Bore x stroke (mm)
77 x 75
77 x 75
77 x 85.8
Max power: EU standard (kW)
70
72
88
Max power engine speed (rpm)
5 750
6 000
6 000
Max torque: EU standard (Nm)
136
136
160
Max torque engine speed (rpm)
4 250
4 000
4 250
Fuel
Unleaded
Unleaded
Unleaded
Catalytic converter
Yes
Yes
Yes
GEARBOXES
Manual
(5-speed)
Manual
(5-speed)
Manual
(5-speed)
Auto.
(4-speed)
OIL CAPACITIES (in litres)
Engine (with fi lter replacement)
4.25
-
4.25
4.25
Gearbox - Final drive
1.9
-
1.9
-
4C...:
5-door.
4E...:
SW with rear bench seat.
4H...:
SW with individual rear seats.
Page 204 of 336
1
202
TECHNICAL DATA
MODELS:
ENGINES AND GEARBOXES
Model codes:
4C... 4E... 4H...
N6A-B
N6A-C
5FX-H
5FT-F
5FV-8
5FV-A
PETROL ENGINES
1.6 litre 16V
108 hp
1.6 litre THP
16V 150 hp
1.6 litre THP
16V 140 hp
1.6 litre THP 16V 156 hp
Cubic capacity (cc)
1 587
1 598
1 598
Bore x stroke (mm)
78.5 x 82
77 x 85.8
77 x 85.8
Max power: EU standard (kW)
78
11 0
103
115
Max power engine speed (rpm)
5 800
5 800
6 000
6 000
Max torque: EU standard (Nm)
142
240
240
Max torque engine speed (rpm)
4 000
1 400
1 400
Fuel
Unleaded
Unleaded
Unleaded
Catalytic converter
Yes
Yes
Yes
GEARBOXES
Manual
(5-speed)
Manual
(6-speed)
Auto.
(4-speed)
Manual
(6-speed)
Auto.
(6-speed)
OIL CAPACITIES (in litres)
Engine (with fi lter replacement)
3.25
4.25
4.25
-
-
Gearbox - Final drive
1.9
1.9
-
-
-
4C...:
5-door.
4E...:
SW with rear bench seat.
4H...:
SW with rear individual seats.
Page 205 of 336
1
203
TECHNICAL DATA
MODELS:
ENGINES AND GEARBOXES
Model codes:
4C... 4E... 4H...
5FU-8
RFJ-B
RFJ-C
RFJ-E
RFJ-F
PETROL ENGINES
1.6 litre THP 16V 200 hp
2 litre 16V 140 hp
Cubic capacity (cc)
1 598
1 997
Bore x stroke (mm)
77 x 85.8
85 x 88
Max power: EU standard (kW)
147
103
Mex power engine speed (rpm)
5 500
6 000
Max torque: EU standard (Nm)
275
200
Max torque engine speed (rpm)
1 700
4 000
Fuel
Unleaded
Unleaded
Catalytic converter
Yes
Yes
GEARBOXES
Manual
(6-speed)
Manual
(5-speed)
Auto.
(4-speed)
OIL CAPACITIES (in litres)
Engine (with
fi lter replacement)
4.25
5
5
Gearbox - Final drive
1.9
1.9
-
4C...:
5-door.
4E...:
SW with rear bench seat.
4H...:
SW with individual rear seats.