2010 OPEL COMBO fold seats

4In Brief
Picture no: 12429s.tif
Front seat height
3: Pull lever at
side
Lift lever and relieve some weight from seat
to raise it or press down on seat with body
weight to lower it.
Never adjust the driver’s seat whilst driving.
It could move in an uncontrolled manner
when the lever has been pulled.
Seats 338, Seat position 339.
Picture no: 11536s.tif
To fold front seat backrest
forward
3: Raise release lever
Seats 338, Seat position 339.
Picture no: 13781s.tif
Adjust head restraint height
3 of
front and rear outboard seats: Tilt
forward to release, hold in place,
adjust height and release again
Head restraint 340, Head restraint
position 341, Rear, centre head restraint 3
341.

39
Seats, Interior
Picture no: 12429s.tif
Adjust height of seat
Lift lever and relieve some weight from seat
to raise it or press down on seat with body
weight to lower it.
Picture no: 11536s.tif
Tilting the backrests forward
In order to fold the backrest forwards, lift
the release lever.
Picture no: 18530s.tif
Seat position
zSit with your buttocks as far back against
the backrest as possible. Adjust the
distance between your feet and the
pedals so that your legs are slightly
angled when pressing the pedals. Slide
the passenger seat as far back as
possible.
9 Warning
Only drive with the seat correctly
adjusted.

40 Seats, InteriorzSit with your shoulders as far back
against the backrest as possible. Set the
backrest rake so that you can easily
reach the steering wheel with your arms
slightly bent. Maintain contact between
your shoulders and the backrest when
turning the steering wheel. Do not angle
the backrest too far back. We
recommend a maximum rake of
approx. 25.
zAdjust the steering wheel 36.
zSet seat height 3 high enough to have a
clear field of vision on all sides and of all
display instruments. There should be at
least six inches of clearance between
your head and the headlining. Your
thighs should rest lightly on the seat
without pressing into it.
zAdjust the head restraint.
zAdjust the height of the seat belt 352.
Picture no: 15997s.tif
Heated front seats 3
Two pushbuttons ß in centre console.
With the ignition switched on, the heating
of the relevant front seat is activated by
pressing the button ß.
LED ß on: the relevant front seat is heated.
LED ß off: heating of relevant front seat is
switched off.
For vehicles with natural gas operation 3,
only switch ß is available. Operation for
both front seats when the ignition is on.
Picture no: 13781s.tif
Head restraints Adjusting the front and outboard rear
seat headrestraints 3
To adjust, hold head restraint at side, tilt
forward, hold and adjust height.
To improve visibility when the rear seats
are unoccupied or to fold down a rear seat
or the front passenger seat, push the head
restraint all the way down or remove.
If the rear seats are occupied, adjust the
rear head restraints to the appropriate
level for the occupant’s body size.
The open frame head restraint on the
Combo Van cannot be adjusted.

42 Seats, InteriorLuggage compartment extension Remove the luggage compartment
cover3 if necessary 344.
Pull out the push-in collars 3 for the ISOFIX
child-restraint system mounting.
Closely follow the installation instructions
accompanying the ISOFIX child restraint
system.
Picture no: 18099s.tif
Folding down the rear seat backrests
Push the rear, outer head restraint 3 down
completely or remove it 340. Push the rear,
centre head restraint3 down completely
341.
To fold one or both of the rear seat
backrests, press the button at the top to
release the backrest and fold it onto the
seat cushion.
Picture no: 18100s.tif
– or –
Remove the rear, outer head restraints3
340. Push the rear, centre head restraint3
down completely 341.
Hook seat belt buckles on rear seat
backrests.
Pull up one or both rear seat cushions using
the straps provided.

43
Seats, Interior
Picture no: 12438s.tif
To fold one or both of the rear seat
backrests, press the button at the top to
release the backrest (Fig. 18099 S) and fold
it forward. Repositioning the rear seats
Pull the seat belt slightly forward so that it
does not get damaged and audibly
engage the backrests.
Reposition the seat cushions.
Insert outer rear head restraints 3.
Picture no: 13787s.tif
Folding down the front passenger seat3
Push the passenger seat head restraint
down or remove it 340.
Slide the front passenger seat back.
Fold front passenger seat forward by
raising release lever.
Restoring the front passenger seat to an
upright position3
Press the release lever forward, fold up the
front passenger seat and audibly engage.

45
Seats, Interior
Picture no: 12443s.tif
Safety net
3
Passengers must not be carried behind the
safety net.
The safety net can be fitted behind the rear
seats or, with the rear seat backrest folded
down, behind the front seats.
Remove the luggage compartment cover
as necessary 344.
Unroll the safety net.
Fitting behind the rear seats
There are two installation apertures in the
roof frame above the rear seats: Open the
cover. Engage one side of the upper net
rod in one side, extend the rod and engage
in the other side. Close the cover.
Picture no: 12444s.tif
Fold down both rear seat backrests.
Hook tensioning straps into lashing eyes in
floor and tighten by pulling on the loose
end of the strap.
Reposition and engage the backrests.
Fitting behind front seats
Pull up both rear seat cushions and fold
down rear seat backrests.
Open the cover of the installation
apertures in the roof frame above the front
seats. Engage the net rod in one side,
extend the rod and engage in the other
side. Close the cover.
Hook tensioning straps into brackets in
floor and tighten by pulling on the loose
end of the strap.
Picture no: 12445s.tif
Removing
Swivel tensioning strap length adjusters
upward and unhook straps. Open the
cover. Unhook upper net rod and close
cover.
Roll the safety net.
9 Warning
The brackets must not be used as
lashing eyes to prevent objects that are
being transported from sliding around
344.

47
Seats, Interior
Picture no: 18103s.tif
Notes on loading the vehicle zHeavy objects in the luggage
compartment should be placed as far
forward as possible against the rear seat
backrests or, if the rear seat backrests
are folded down, against the front seat
backrests. If objects are to be stacked,
the heavier objects should be placed at
the bottom.
zSecure heavy objects with lashing
straps3 attached to lashing eyes 3
344.
zWhen transporting objects with the
backrests folded down, install the safety
net 3 345.
zClose the luggage compartment
cover3. zIf the seat backrests are not folded down
when transporting objects in the
luggage compartment, the backrests
must be fully upright and engaged in
position 342.
zDo not allow the load to protrude above
the upper edge of the backrests.
zThe warning triangle 3 and first-aid kit
(cushion) 3 must always be freely
accessible.
zDo not place any objects in front of the
rear window or on the instrument panel.
zNo objects must be placed in the area in
which the airbags inflate, as they could
cause injury when the systems are
deployed.
zThe load must not obstruct the operation
of the pedals, handbrake and gear
selector, or hinder the freedom of
movement of the driver. Do not place
any unsecured objects in the interior.
zDo not drive with luggage compartment
open when transporting bulky objects,
for example, since toxic exhaust fumes
could penetrate the interior.
zThe payload is the difference between
the permitted gross vehicle weight
(identification plate 3182) and the EC
kerb weight.
zTo calculate the EC kerb weight, enter
the data for your vehicle on page 189. zThe EC kerb weight includes allowances
for the driver (68 kg), luggage (7 kg) and
all fluids (tank 90 % full).
zOptional equipment and accessories
increase the kerb weight.
zWeights and payload 3189.
zDriving with a roof load increases the
sensitivity of the vehicle to cross-winds
and has a detrimental effect on vehicle
handling due to the vehicle’s higher
centre of gravity. Distribute the load
evenly and secure it properly with
retaining straps. Adjust the tyre pressure
to the load conditions. Do not drive
faster than 120 km/h. Check and
retighten the straps frequently. Observe
country-specific regulations.
zThe permissible roof load is 100 kg. The
roof load consists of the weight of the
roof rack plus the load carried.
zIf objects are transported in the load
compartment, the split load
compartment grille
3 must always be
locked in one of the retainers and the
lever must be engaged at its bottom
position 346.
zWhen stowing objects in the stowage
compartment above the front seats,
secure against falling out.

63
Seats, Interior
Picture no: 11591s.tif
Rear ashtray 3
In the rear centre console.
To open, swivel the cover upwards.
To empty, lift the cover and pull the
ashtray out upwards by its cover.
Picture no: 11592s.tif
Stowage compartments Glove compartment
To open, pull handle.
On the inside of the glove compartment
cover there is a pen holder.
In vehicles with Infotainment system 3, the
telematics unit 3 can be housed in the
glove compartment.
The glove compartment should remain
closed while driving.
Picture no: 11701s.tif
Stowage compartment for glasses 3
On driver’s side: fold down to open.