2010 NISSAN VERSA HATCHBACK ignition

AUTOMATIC DOOR LOCKS (if so equipped)
All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).

All doors unlock automatically when the ignition is placed in the O ff position (niSSAn
intelligent k eyTM equipped vehicles) or when the key is removed from the ignition switch
(mechanical key equipped vehicles).
The automatic lock and unlock functions can be deactivated or activated independently
of each other. To deactivate or activate the automatic door lock or unlock system, perform the
following procedure:
1. close all doors.
2. Place the ignition switch in the O n position.
3. do one of the following within 20 seconds of performing Step #2:
• To change A uTO unLOck settings: Push and hold the Power door Lock switch to the


(un
LOck) position for more than 5 seconds.
• To change A uTO LOck settings: Push and hold the Power door Lock switch to the


(LO
ck) position for more than 5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator
will flash once.
5. The ignition switch must be placed in the O ff and On position again between each setting
change.
WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the O n position to
activate the windshield wipers.

Move the lever to the following positions to operate
the windshield wipers:

1A intermittent (INT) – front wipers operate
intermittently and can be further adjusted by
twisting the time control ring

1B .

02 Low Speed (LO) – continuous low-speed
operation of front wipers.

03 High Speed (HI) – continuous high-speed
operation of front wipers.

04 Mist (MIST) – Lift the lever up for one sweep of the front wipers.

05 Rear Wiper (REAR) (if so equipped) – Twist the end section to operate the first (INT)

or second (ON) speed settings for the rear wipers.

f or front Washer, pull the lever toward you.

f or Rear Washer, push the lever away from you.
1B
1A
05
04
02
03

9
TWIN TRIP ODOMETER
The twin trip odometer records the distance of two
individual trips.

Press the button
01 to change the display as follows:
Trip A
Trip B
Trip A.

Press and hold the button
01 for more than 1 second
to reset the currently displayed trip odometer to zero.
01
4-SPEED AUTOMATIC TRANSMISSION (if so equipped)
The 4-speed automatic transmission is electronically controlled to produce
maximum power and smooth operation.

The automatic transmission in your vehicle is designed so that the brake
pedal must be depressed before shifting from P (P ARk) to any gear
position while the ignition switch is in the O n position.

The shift lever cannot be moved out of P (P ARk) and into any of the other
gear positions if the ignition is turned to the LO ck position or if the key
is removed.
CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (if so equipped)
The cVT does not produce a gear change
sensation like traditional automatic transmissions.

R (ReVe RSe) speed for cVT vehicles is limited
to 15 MPH (25 km/h).
The transmission in your vehicle requires a special
fluid available only at your ni SSAn dealer. no other
fluid will meet the exact requirements of the cVT.
STARTin G THe enGine W iTH cVT
(ni SSAn intelligent k ey™ models only)
depress the brake pedal.

Push the ignition knob in.

confirm the intelligent k ey system warning light is illuminated green.

Turn the ignition knob to start the engine.
Tu Rnin G TH e enGine O ff WiTH cVT (ni SSAn intelligent k ey™ models only)
Shift the shift lever into the P (P ARk) position.

Turn the ignition knob to the LO ck position.
OVeRd RiVe (O/ d) Off SW iTc H
each time your vehicle is started, the cVT is automatically “reset” to Overdrive on.

To turn Overdrive mode off, push the O/D OFF switch
01 . The light in the instrument panel
will illuminate.

use the Overdrive off mode when you need improved engine braking.
01

11
FRONT PASSENGER AIR BAG STATUS LIGHT
This vehicle is equipped with the nissan Advanced Air Bag System.
under some conditions, depending on the type of occupant or object
detected in the front-passenger’s seat by the occupant classification
sensor, the front passenger air bag is designed to automatically turn
OFF. When the front passenger air bag is OFF, the front passenger
air bag status light will illuminate*. f or example:

When the system detects that the front-passenger’s seat is
occupied by a small adult, child or child restraint as outlined in
the Owner’s Manual, the

will illuminate to indicate that
the front passenger air bag is OFF and will not inflate in a crash.

When the front-passenger’s seat is occupied and the passenger meets th\
e conditions
outlined in the Owner’s Manual, the

will not illuminate to indicate that the front
passenger air bag is operational.
*When the system detects that the front-passenger’s seat is unoccupie\
d, the front
passenger air bag status light will not illuminate even though the front\
passenger
air bag is OFF.
TIRE PRESSURE MONITORING SYSTEM (TPMS)
This system monitors tire pressure. if the low tire pressure warning light
illuminates, check the tire pressure in all four tires.
Adjust the low tire pressure to the recommended cOL d tire pressure
shown on the Tire and Loading information label, located in the driver’s
door opening. After tire pressures are adjusted, the vehicle will need to
be driven at speeds above 16 MPH (25 km/h) to activate the TPMS and
turn off the low tire pressure warning light.
SEAT BELT WARNING LIGHT AND CHIME
The light and chime remind you to fasten your seat belts. The
light illuminates whenever the ignition switch is placed in the
On or START position and remains illuminated until the driver’s
seat belt is fastened. At the same time, the chime sounds for
approximately 6 seconds unless the driver’s seat belt is
securely fastened.

With the ignition O n, the seat belt warning light may also
illuminate if the front-passenger’s seat is occupied with the
front-passenger’s seat belt unfastened.

12
HIGH AND LOW TEMPERATURE INDICATOR
HiGH Te MPeRATu Re indic ATOR (Red)
When the ignition switch is in the O n position, the high temperature warning light
illuminates and then turns off.
LOW Te MPeRATu Re indic ATOR (Blue)
When the ignition switch is in the O n position, the low temperature indicator light illuminates and
then turns off after the engine coolant has warmed up.
CHILD SAFETY REAR DOOR LOCKS
The child safety lock levers are located on the edge of the
rear doors.

child safety locks help prevent the rear doors from being
opened accidentally, especially when small children are in
the vehicle.

When the lever is in the LO ck position, the door can only
be opened from the outside.
MOONROOF CONTROLS (if so equipped)
The ignition switch must be in the O n position to operate
the moonroof.
Ti LTin G TH e MOO nROO f
To tilt the moonroof up, push the tilt switch toward the

01 position.

To tilt the moonroof down, push the tilt switch toward
the

02 position.
SLidin
G THe MOO nROO f
To open the moonroof, push the switch toward the
02 position.

To close the moonroof, push the switch toward the
01 position.

To open or close the moonroof part way, push the switch in either direction 01 or
02 while
the moonroof is sliding to stop in the desired position.
01
02

REAR SEAT ADJUSTMENTS
fOLdinG dOWn TH e ReAR S eATS
(if so equipped)
either side of the seatback (or both) can be
folded and has its own release.

Pull the 01 release on the top of the
seatback to fold the rear seat down.
INTERIOR LIGHT
Push the switch to the O n position 01 . The interior
lights illuminate regardless of door position.

Push the switch to the O ff position 02 . The interior
lights will not illuminate regardless of door position.

Push the switch to the d OOR position 03 . The interior
lights will stay on for approximately 30 seconds when:
• The doors are unlocked by a keyfob, key or Power door Lock switch while all doors are
closed and the ignition is in the O ff position.
• The driver’s door is opened and then closed with the key removed from \
the ignition.
• The key is removed from the ignition and all doors are closed.
FRONT SEAT ADJUSTMENTS
WiTH MAnu AL SeATS
Pull up on the lever 01 under the front of the
seat and slide forward or backward. Release
the lever to lock the seat in position.

Lift the lever 02 on the side of the seat to
adjust your seatback forward or backward;
release the lever when you have found a
comfortable angle and the seat belt fits
properly.
Seat lifter (driver’s seat, if so equipped)
Pull up or push down the adjusting lever 03
repeatedly to adjust the seat height.
01
0203
01
02
03

14
BLUETOOTH® HANDS-FREE PHONE SYSTEM (if so equipped)
With an overhead microphone and sound
transmitted through the audio system speakers,
the Bluetooth
® Hands-free Phone System
utilizes Bluetooth® wireless technology and
voice recognition to provide hands-free
cellular phone communication.
SYSTe M OPeRATin G TiPS
close all windows. Surrounding noises
may interfere with system operation and
performance.

Press the
button on the steering wheel to activate voice recognition.

Wait for the tone before speaking.

Begin speaking a command within 5 seconds of the tone.

Speak in a clear and natural voice without pausing between words.

To go back to the previous command, say “Go back” or “correction.”

To cancel a voice recognition session, simply wait 5 seconds, say “cancel” or “Quit,” or
press the

button.

To increase or decrease the volume of the voice prompts, push the VOL (volume) control
switch on the steering wheel or turn the POWER/VOLUME knob on the audio system
while the system is responding.

if the Voice Recognition system does not recognize your voice commands, train th\
e system
using the Speaker Adaptation Mode. See your Owner’s Manual for detailed information.

Some commands are not available while the vehicle is in motion.

The “Help” command can be used in any menu to hear a list of availa\
ble commands.

Please refer to the cellular phone manufacturer’s Owner’s Manual for detailed information
regarding your Bluetooth® phone.

For recommended phones and detailed instructions, please visit
www.nissanusa.com/bluetooth.
cO nnec Tin G YO uR PHO ne
To use the hands-free feature, you need to set up, or connect, the system to recognize your
cellular phone(s). five Bluetooth®-enabled phones can be connected. After setup, the system
automatically connects with a connected phone when the ignition is in th\
e A cc or On position,
as long as the phone is on and in the vehicle.
n OTe: Some cellular phones require the user to enable the automatic reconnec\
tion feature. Please
refer to the cellular phone manufacturer’s Owner’s Manual for Blue\
tooth
® setup information.

17
06
07
0102
05
0304
NAVIGATION SYSTEM (if so equipped)
GeTTin G STARTed
The navigation System begins when the ignition is placed in the A cc or O n position. Park the
vehicle in a safe location and then operate the navigation System.
BASic func TiOnS
Touch the screen to select the item or key displayed.

Touch the map screen once to activate map scrolling. Then touch the screen again and drag
your finger in the direction you want to move. To return to the current vehicle location, push the
BACK button

05 .

To select a menu item from a list, touch the item or turn the SCROLL knob
06 to highlight
the selection, then press the SCROLL knob to select the highlighted feature.

Press the BACK button
05 to return to the
previous function shown on the navigation
display.

not all features can be operated while the
vehicle is in motion. These features will become
available again when the vehicle is stopped.

Press the day/night button
07 to switch
between the day screen (bright) and the night
screen (dark). Within 5 seconds of pressing the

button, you can adjust the brightness of the map display screen by turning the
SCROLL knob.

Press the “Voice” key to hear the current navigation situation when a route is ac\
tive.