2010 NISSAN ALTIMA HYBRID tow

WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the O n position to
activate the windshield wipers.

Move the lever to the following positions to operate
the windshield wipers:

1A intermittent (INT) – front wipers operate
intermittently and can be further adjusted by
twisting the time control ring
1B.

02 Low Speed (LO ) – continuous low-speed
operation of front wipers.

03 High Speed (HI ) – continuous high-speed
operation of front wipers.

04 Mist (MIST ) – Lift the lever up for one sweep of the front wipers.

Pull the lever toward you to activate front washer fluid and several s\
weeps of the wipers.
1B04
1A
02
03
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator
will flash once.
5. The ignition switch must be placed in the O ff and O n position again between each setting
change.
When the automatic door unlock system is deactivated, the doors do not unlock when the ignition
switch is placed in the O ff position. To unlock the door manually, use the inside lock knob or the
power door lock switch (driver’s or front passenger’s side).
HEADLIGHT AND TURN SIGNAL CONTROL
TO A cTiVATe TH e AuTOLi GHT S ySTe M (if so equipped):
Turn the headlight control switch
01 to the A
uTO position to
activate the autolight system. The autolight system can:

Turn the headlights on automatically when it is dark.

Turn the headlights off automatically when it is light.

k eep the headlights on for 45 seconds after you turn the
ignition switch to O ff and all doors are closed.
TO deAcTiVATe TH e AuTOLi GHT S ySTe M:
Turn the headlight control switch
01 to the O
ff,
or
position.
H
eAd LiGHT c OnTROL SW iTc H
Turn the headlight control switch
01 to the
position to turn on the front parking, tail,
license plate and instrument panel lights.

Turn the headlight control switch
01 to the
position to turn on the headlights.
All other lights remain on.
01

15
FUEL-FILLER DOOR RELEASE
The fuel-filler door release is located on the floor to the left of t\
he driver’s seat.

To open the fuel-filler door, pull the release up.

To lock, close the fuel-filler door securely.
FUEL-FILLER CAP
To tighten, turn the fuel-filler cap clockwise until ratcheting clicks
are heard. if the cap is not fully tightened, the

light may

illuminate.

if the
light illuminates because the fuel cap is loose or missing,
tighten or re-install the cap. The

light should turn off after a

few driving trips.
TRUNK LID CANCEL SWITCH
When the cancel switch (located inside the glove box) is O ff, the
trunk lid cannot be opened with the trunk lid opener (located on the
instrument panel), the trunk lid Release/Request Switch (if so
equipped) or the ni SSAn intelligent key
TM button.

it can be opened by using the emergency inside Trunk Release.
MOONROOF CONTROLS (if so equipped)
The ignition switch must be in the O n position to operate the
moonroof controls.
Ti LTin G TH e MOO nROO f
To tilt the moonroof up, push the tilt switch toward the

01 position.

To tilt the moonroof down, push the tilt switch toward the 02 position.
SL
idinG TH e MOOn ROOf
To open the moonroof, push the switch toward the 02 position.

To close the moonroof, push the switch toward the 01 position.

To open or close the moonroof part way, push the switch in either direction (01 or
02) while
the moonroof is sliding to stop in the desired position.
01
02