2010 MITSUBISHI OUTLANDER tailgate

[x] Cancel search: tailgate

Page 391 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual 3-280 Features and controls
3
Interior light auto-cutout function (dome light 
and other lights)
N00526300400

If interior lights are left on with the ignition switch in the
“LOCK” position, the

Page 408 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual Driving safety
4-3
4 Driving, alcohol and drugs
N00628900049
Drunk driving is one of the most frequent causes of accidents.
Your driving ability can be seriously impaired even with blood
alcohol level

Page 412 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual Driving safety
4-7
4 Parking
N00629600232
Parking on a hillWhen parking on a hill, set the parking brake, and turn the
front wheels toward the curb on a downhill, or away from the
curb on an uphill.
I

Page 418 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual Driving safety
4-13
4
Loading cargo on the roof
N00630400041
NOTE
To prevent wind noise or reduction in gas mileage,
remove the roof carrier when not in use.

Before using an automatic car wash, che

Page 581 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual 6-12 For emergencies
6
To remove the spare tire
N00849700127
1. Open the tailgate and use the bar to remove the cover (A)
over the tire hanger mounting bolt.
Refer to “Flap-fold tailgate: To open”

Page 582 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual For emergencies
6-13
6
2. With the wheel nut wrench, loosen the tire hanger mount-
ing bolt by turning it counterclockwise.
3. Raise the lower gate until it clicks and locks.
Refer to “Flap-fold tai

Page 584 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual For emergencies
6-15
6
3. Open the lower gate.
Refer to “Flap-fold tailgate: To open” on page 3-60.
4. With the wheel nut wrench, firmly tighten the tire hanger
mounting bolt by turning it clockwi

Page 666 of 714

MITSUBISHI OUTLANDER 2010 2.G Owners Manual Vehicle care and maintenance
7-69
7
4. To install the bulb, perform the removal steps in reverse.NOTE
When mounting the light unit, align the clips (D) on the
light unit with the hole in the body.
Ba