2010 MITSUBISHI LANCER lock

[x] Cancel search: lock

Page 592 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual Vehicle care and maintenance
7-49
7
Engine compartmentIn the engine compartment, the fuse block is located as shown
in the illustration. 
1. Push the lock lever.
2. Remove the fuse block cover.
Fuse l

Page 593 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual 7-50 Vehicle care and maintenance
7
Passenger compartment fuse location tablePassenger compartment fuse location
Sub fuse block Main fuse block
No.
Symbol
Electrical system
Capacity
1 Heater 30 A*
2St

Page 594 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual Vehicle care and maintenance
7-51
7
*- Fusible link
Some fuses may not be installed on your vehicle, depend-
ing on the vehicle model or specifications.
The table above shows the main equipment corr

Page 596 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual Vehicle care and maintenance
7-53
7
*- Fusible link
Some fuses may not be installed on your vehicle, depend-
ing on the vehicle model or specifications.
The table above shows the main equipment corr

Page 597 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual 7-54 Vehicle care and maintenance
7
Fuse replacement 
N00954900027
1. Before replacing a fuse, always turn off the electrical item
connected to the fuse and turn the ignition switch to the
“LOCK”

Page 603 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual 7-60 Vehicle care and maintenance
7
2. For vehicles equipped with turbocharger, when replacing
the bulb on the passenger’s side, lift up the engine coolant
reservoir (B).3. Turn the bulb (C) counter

Page 605 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual 7-62 Vehicle care and maintenance
7
Headlights (high beam, except for vehicles with 
high intensity discharge headlights)
N00943100843
1. When replacing the bulb on the front passenger’s side,
remov

Page 606 of 670

MITSUBISHI LANCER 2010 8.G Owners Manual Vehicle care and maintenance
7-63
7
3. Turn the bulb (C) counterclockwise to remove it. 4. While holding down the tab (D), pull out the bulb (E).
5. To install the bulb, perform the removal steps in r