2010 MERCEDES-BENZ ML450 HYBRID display

What to do if ...
Lamps in instrument cluster
Problem
Possible causes/consequences and
X Solutionsé
The yellow RBS
(Recuperative Brake
System) warning lamp
is on while the
combustion engine is
running. In addition, an
acoustic warning may
sound.
The RBS is malfunctioning.
Risk of accident!
The combustion engine may not turn off automatically.
X
Read and observe messages that may appear in the
multifunction display
(Y page 24).
X Continue driving with added caution.
X Contact an authorized Mercedes-Benz Center. $
(USA only)
J
(Canada only)
The red brake warning
lamp is on while the
combustion engine is
running. An additional
acoustic warning
sounds.
The RBS is malfunctioning.
Risk of accident!
Brake pedal travel may be longer than usual and the braking
behavior of the vehicle may change.
X
Stop the vehicle in a safe location or as soon as it is safe to do
so. Do not continue to drive.
X Contact an authorized Mercedes-Benz Center immediately.
X Read and observe messages that may appear in the
multifunction display

(Y page 24), see Operator’s Manual. The brake fluid level in the brake fluid reservoir is too low.
Risk of accident!
X
Stop the vehicle in a safe location or as soon as it is safe to do
so. Do not continue to drive.
X Contact an authorized Mercedes-Benz Center immediately.
X Read and observe messages that may appear in the
multifunction display

(Y page 24), see Operator’s Manual.
Do not add brake fluid. This will not solve the problem. d
The yellow ABS/ESP
®
warning lamp flashes
while driving. The ESP
®
,
the 4-ETS, or the ABS has come into operation because
of detected traction loss for at least one wheel.
Risk of accident!
The cruise control is deactivated.
X When driving off, apply as little throttle as possible.
X While driving, ease up on the accelerator pedal.
X Adapt your speed and driving to the prevailing road and weather
conditions.
X Do not switch off the ESP ®
.
Exceptions, see Operator’s Manual. Practical hints
29164_ZA; 2; 2, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-12T15:08:04+02:00 - Seite 29 Z

Problem
Possible causes/consequences and
X SolutionsThe warning and
indicator lamps in the
instrument cluster fail
to come on when
switching on the
ignition. The 12-volt battery and/or the high-voltage battery are
discharged.
X
Charge the 12-volt battery (Y page 32).
or
X Get a jump start (Y page 33).
or
X Contact an authorized Mercedes-Benz Center. Combustion engine
Problem
Possible causes/consequences and
X SolutionsThe combustion engine
cannot be started. The
warning and indicator
lamps
in the instrument
cluster come on when
switching the ignition. The high-voltage battery is discharged.
The discharged high-voltage battery is being charged with the
ignition switched on while the vehicle is being jump started
(Y page 33).
X
Read and observe messages that may appear in the
multifunction display

(Y page 24). The combustion engine
cannot be started. The
multifunction display
does not display any
messages. The self-diagnosis has not been completed yet or the HYBRID
system is malfunctioning.
X
Switch off the ignition and switch it back on.
X Try to start the combustion engine once more.
X If the combustion engine cannot be started: Contact an
authorized Mercedes-Benz Center. RBS (Recuperative Brake System)
Problem
Possible causes/consequences and
X SolutionsLess brake pedal
pressure is required
and the brake pedal
travel is longer than
usual.
X
Apply the brake pedal fully and release it.
The required brake pedal pressure and the brake pedal travel
are back to normal. The RBS is malfunctioning.
Risk of accident!
X
Read and observe the messages in the multifunction display
(Y

page 24) and the notes on warning and indicator lamps in the
instrument cluster (Y page 29). 30
Practical hints 164_ZA; 2; 2, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-12T15:08:04+02:00 - Seite 30

Problem
Possible causes/consequences and
X SolutionsThe brake pedal
pulsates. The RBS is providing electronic controlled brake boost. Read and
observe the notes on the ABS/ESP
®
warning lamp ( Y page 9). The HYBRID system switches of automatically
Problem
Possible causes/consequences and
X SolutionsThe HYBRID system
has switched of
automatically. Your vehicle was involved in an accident.
The HYBRID system remains switched off, if
R
the combustion engine cannot be started again after a few
seconds
R the SRS warning lamp + in the instrument cluster comes on
X Contact an authorized Mercedes-Benz Center. The HYBRID system
has switched of
automatically. An
additional message
appears in the
multifunction display. A short circuit in the HYBRID system has occurred or a plug
connection of the HYBRID system was disconnected.
X
Read and observe messages that may appear in the
multifunction display ( Y page 24).
X Contact an authorized Mercedes-Benz Center. Opening the fuel filler flap manually
G
Warning!
Avoid contact with the vehicle walls as they
may contain sharp edges. Otherwise, you
could injure yourself while opening the fuel
filler flap. G
Warning!
Open the fuel filler flap manually only if the
fuel filler flap switch is not operational.
With the fuel filler flap opened manually, fuel
may spray out during the refueling process.
In case the fuel filler flap switch ( Y page 20)
does not release the fuel filler flap, you can
open it manually.
The fuel filler flap release is located behind a
cover on the passenger side in the cargo
compartment. X
Open the tailgate, see Operator's Manual.
X Insert a suitable object such as a coin into
the slot of locks :.
X Turn locks : by 90° in direction of the
arrows.
X Remove cover ;. Practical hints
31164_ZA; 2; 2, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-12T15:08:04+02:00 - Seite 31 Z

X
Press the KEYLESS-GO start/stop button
once.
X Remove the foot from the brake pedal.
Ignition is switched on automatically.
The message Charging Hybrid
Battery Please Wait appears in the
multifunction display.
Start the combustion engine when the
message Engine Can Now Be Started
appears in the multifunction display.
Depending on the high-voltage battery's
discharge, the charging procedure may
take up to 60 minutes.
X After the combustion engine of your vehicle
has
been started, leave the engines of both
vehicles running at idle speed. Disconnecting the jumper cables
X Disconnect the jumper cables in reverse
order, starting with jump start terminal 4
(Y page 34).
X Close the hood.
X Drive the vehicle for some time in order to
charge the 12-volt battery and the high-
voltage battery. Practical hints
35164_ZA; 2; 2, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-12T15:08:04+02:00 - Seite 35 Z